97-4
Electronics box (E-box) in plenum
chamber, removing and installing
- Remove mounting bolts (arrows) and pull off cover.
- When installing, press cover on by hand and tighten mounting bolts in
diagonal sequence. Tightening torque: 4 Nm (35 in. lb) (also see
information on cover).
- Remove engine control module and, if necessary, remove auxiliary
relay panel/auxiliary fuse panel Page 97
-5 .
- Disconnect harness connector at connector station.
- Pull out engine wiring harness together with rubber grommet from
opening in electronics box.
Note the following when installing: - Remove both nuts -A- (4 Nm or 35 in. lb).
- Lift electronics box off studs at rear and pull out of mount -B-.
- Install in reverse order of removal.
- Always replace seal -C-: seal must not overlap opening in body and
edge of sheet metal.
Pa
ge 4 of 5 Rela
y panel, fuse
panel
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.97.1
97-5
Auxiliary relay panel/auxiliary fuse
panel, removing and installing
Location: in footwell, bottom left.
- Remove nut -A- (2 Nm or 18 in. lb) and self-tapping screw -B-.
- Remove relay and control module, unclip relay carrier and, if
necessary, unclip auxiliary relay panel.
- Pull out auxiliary relay panel from retainers and remove from below.
- Install in reverse order of removal.
Pa
ge 5 of 5 Rela
y panel, fuse
panel
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.97.1
