87-158
Dust and pollen filter, removing and
installing
Remove right air plenum cover
Repair Manual, Body Exterior, Repair Group
66
Notes: - Remove water guide -A-.
- Remove dust and pollen filter -B- from housing.
The water guide and the plenum cover must be properly installed to
ensure no water flows onto the dust and pollen filter and into the
heater housing. Gasket -C- must be attached to the housing of the dust and pollen
filter; before installing the housing, check that it is correctly located
and not damaged. The dust and pollen filter should be replaced at regular intervals
Repair Manual, Maintenance.
Pa
ge 8 of 24 Heatin
g and ventilation s
ystem, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.87.22
87-159
Heater/air conditioner assembly
complete with instrument panel,
removing and installing (1996)
- Using VAG1551 function 03, initiate output
Diagnostic Test Mode (DTM) page 01
-42
.
CAUTION!
Before proceeding with removal of instrument panel and heater/air
conditioner complete: - Proceed through output DTM and wait until air flow flap -A- closes via
air flow flap motor V71.
- Cancel output DTM (press VAG1551 button -C-) with closed air flow
flap -A-.
- Discharge refrigerant system page 87
-201
.
- Remove dust and pollen filter page 87
-158
.
Obtain security code for anti-theft radio.Note customer's pre-set radio stations.Move power seats to most rearward position.Disconnect and remove battery.
Pa
ge 9 of 24 Heatin
g and ventilation s
ystem, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.HA01.87.22
