13-4
Cylinder block, crankshaft and
flywheel, servicing Notes:
Always replace seals and O-rings.
The engine speed sensor is installed in the
transmission bellhousing with a spacer washer
underneath.
1 -
Main bearing cap bolts
Always replace60 Nm (44 ft lb) + additional 180 (1/2 turn)
2 -
Main bearing caps
Always replace boltsMarking -1- on oil pump sideChecking bearing clearance page 13
-25
3 -
Connecting rod bearing bolts
Always replace30 Nm (22 ft lb) + additional 90 (1/4 turn)When measuring radial clearance, tighten
to 20 Nm (15 ft lb), but do not turn further
Pa
ge 1 of 33 C
ylinder block, crankshaft and fl
ywheel, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.2
13-5
4 -
Connecting rod bearings
Do not interchange used bearing shellsConnecting rods, connecting rod bearings
page13
-33
5 -
Piston rings
Checking page 13
-29
6 -
Pistons
Checking page 13
-29
7 -
Crankshaft
Checking page 13
-25
Chain gear for oil pump, removing and
installing page 17
-29
For vehicles with automatic transmission,
always install bushing as pilot for converter Remove bushing using KUKKO 21/2 and
22/1
8 -
Oil passage with seal Always replace seal
9 -
Sealing flange, front
10 -
Bolt 10 Nm (7 ft lb)
11 -
Collar bolt
Pa
ge 2 of 33 C
ylinder block, crankshaft and fl
ywheel, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.2
