39-136
Notes:
Observe general repair instructions Page 00
-
14
.
With the final drive installed, remove the drive
flange housing from the rear final drive Page 39
-86
.
With the final drive removed, remove the drive
flange housing from the rear final drive Page 39
-119
.
Always replace both tapered roller bearings
together as a set. If possible, use same
manufacturer.
Do not oil new tapered roller bearings for the
friction torque measurement. The bearings are
already factory treated with a special oil.
Remove differential Page 39
-114
.
Adjustments are required when replacing
components marked with "1)" List of
adjustments, Page 39
-149
.
Pa
ge 4 of 13 Pinion shaft, removin
g, installin
g and servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.16
39-143
Fig. 9 Installing small tapered roller bearing outer race
- Oil outer race, and position using VW408A punch and 30-205 thrust
pad.
WARNING!
Wear protective gloves. Fig. 10 Installing small tapered roller bearing inner race
- Insert pinion shaft with new spacer sleeve.
-
Heat small tapered roller bearing inner race to approx. 100 C (212 F)
and install onto pinion shaft. - Lift up pinion shaft and press bearing using 40-21 sleeve up to stop.
Pa
ge 11 of 13 Pinion shaft, removin
g, installin
g and servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.16
