2000 Acura Integra change time

Owner's Identification
This Owner's Manual should be considereda permanent part of the car, and should
remain with the car when it i
s sold.
The information and specifications include in this publication were in affect at the time
of approval for printing. Honda Motor Co., Ltd. reserves the right, however, to
discontinue or change specifications or
design at any time without notice and
with out incurring any obligation whatsoever
OWNER
ADDRESS
STREET
CITY STATE/PROVINCE ZIP CODE /
POSTAL CODE
V. I. N.
DELIVERY DATE
(Date sold to original retail purchaser)
DEALER NAME DEALER NO.
ADDRESS
STREET
CITY STATE/PROVINCE ZIP CODE/
POSTAL CODE
OWNER'S SIGNATURE
DEALER'S SIGNATURE

Key
s an d Lock s

If the system repeatedly does not
recognize the coding of your key, contact your Acura dealer.
This indicator will also blink several times when you turn the ignition
switch from ON (II) to ACCESSORY
(I) or LOCK (0).
Do not attempt to alter this system
or add other devices to it. Electrical
problems could result that may make your car undriveable.
If you have lost your key and you cannot start the engine, contact your
Acura dealer. As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any
interference received, including
interference that may cause undesired
operation.

Changes or modifications not expressly approved by the party responsible for
compliance could void the user's
authority to operate the equipment.
This device complies with Industry

Canada Standard RSS-210.

Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must
accept any interference that may cause undesired operation of the device. Ignitio
n Switc h
The ignition switch is on the right
side of the steering column. It has
four positions: LOCK (0)
ACCESSORY (I)
ON (II)
START (III)
Instrument s an d Control s

Sea
t Adjustment s
To change the angle of the seat-back, pull up on the lever on the outside of
the seat bottom. Move the seat-back
to the desired position and release
the lever. Let the seat-back latch in
the new position. Driver'
s Sea t Heigh t Adjustmen t
The height of your driver's seat is adjustable. Turn the front dial on the
outside of the seat cushion to raise
the front of the seat bottom and turn
the rear dial to raise the rear. Driver'
s Lumba r Suppor t
Vary the lumbar support by moving
the lever on the right side of the
seat-back. Pivot the lever forward
until it stops, then let it return. Doing this several times adjusts the lumbar
support through its full range.
Instrument s an d Control s

Audi
o Syste m

If you turn the system off while a CD

is playing, either with the PWR/VOL
knob or by turning off the ignition,

the disc will stay in the drive. When

you turn the system back on, the CD

will begin playing where it left off.

Press the eject button to remove the
disc from the drive.

If you eject the disc, but do not
remove it from the slot, the system

will automatically reload the disc
after 15 seconds and put the CD

player in pause mode. To begin

playing the disc, press the CD button.
You can use the TUNE and SEEK
bars while a disc is playing to select

passages and change tracks.

To move rapidly within a track, press
and hold the TUNE bar. Press the
side to move forward, or the

side to move backward.

Release the bar when the system

reaches the point you want.
Each time you press the side of
the SEEK bar, the system skips
forward to the beginning of the next track. Press the side to skip
backward to the beginning of the
current track. Press it again to skip
to the beginning of the previous track.
REPEA T — To activate the Repeat
feature, press and release the Repeat
button. You will see RPT in the
display. The system continuously
replays the current track. Press the
Repeat button again to turn it off. RANDO
M PLA Y — This feature,
when activated, plays the tracks on the CD in random order, rather than
in the order they are recorded on the
CD. To activate Random Play, press and hold the A. SEL/RPT button
until you see A. SEL in the display.
The system will then select and play tracks randomly. This continuesuntil you deactivate Random Play by
pressing A. SEL/RPT again.
If the system is in Repeat mode, you
must turn it off by pressing A. SEL/
RPT before you can select Random
Play. Then press and hold the button
again until you see A. SEL displayed.
Comfor t an d Convenienc e Feature s

Towin
g a Traile r

Checking Load s
The best way to confirm that vehicle and trailer weights are within limits
is to have them checked at a public
scale.

Using a suitable scale or a special
tongue load gauge, check the tongue
load the first time you set up a towing combination (a fully-loaded
vehicle and trailer), then recheck the
tongue load whenever the conditions

change.
Towin
g Equipmen t an d

Accessorie s

Towing can require a variety of equipment, depending on the size of
your trailer, how it will be used, and
how much load you are towing.
Discuss your needs with your trailer
sales or rental agency, and follow the
guidelines in the rest of this section.
Also make sure that all equipment is properly installed and that it meets
federal, state, province, and local
regulations.

Hitches

Any hitch used on your vehicle must be properly bolted to the underbody.

Drivin g

Exceeding load limits or

improperly loading your vehicle
and trailer can cause a crash in
which you can be seriously
injured or killed.

Check the loading of your
vehicle and trailer carefully before starting to drive.

Engin
e Oi l
Changin g th e Oi l an d Filte r
Always change the oil and filter according to the time and distance
(miles/kilometers) recommenda- tions in the maintenance schedule.
The oil and filter collect contami- nants that can damage your engine if
they are not removed regularly.
Changing the oil and filter requires
special tools and access from
underneath the car. The car should
be raised on a service station-type
hydraulic lift for this service. Unless you have the knowledge and proper
equipment, you should have this
maintenance done by a skilled

mechanic.
1. Run the engine until it reaches
normal operating temperature,
then shut it off.
2. Open the hood and remove the engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.
3. Remove the oil filter and let the
remaining oil drain. A special
wrench (available from your Acura dealer) is required to remove the

filter.

4. Install a new oil filter according to instructions that come with it.

Maintenanc e
OI
L FILTE R
OI L DRAI N BOL T WASHE R

Storin
g You r Ca r
If you need to park your car for an extended period (more than one
month), there are several things you should do to prepare it for storage.
Proper preparation helps prevent deterioration and makes it easier to
get your car back on the road. If
possible, store your car indoors. Fill the fuel tank.
Change the engine oil and filter
(see page 170).

Wash and dry the exterior
completely.

Clean the interior. Make sure the

carpeting, floor mats, etc. are
completely dry.
Leave the parking brake off. Put
the transmission in Reverse (5- speed manual) or Park

(automatic).
Block the rear wheels. If the car is to be stored for a
longer period, it should be
supported on jackstands so the
tires are off the ground.
Leave one window open slightly (if
the car is being stored indoors).
Disconnect the battery.
Support the front wiper blade
arms with a folded towel or rag so
they do not touch the windshield. To minimize sticking, apply a
silicone spray lubricant to all door
and trunk seals. Also, apply a
vehicle body wax to the painted surfaces that mate with the door
and trunk seals. Cover the car with a "breathable"
cover, one made from a porous
material such as cotton.
Nonporous materials, such as
plastic sheeting, trap moisture,
which can damage the paint. If possible, run the engine for a
while periodically (preferably once a month).
If you store your car for 12 months
or longer, have your Acura dealer perform the inspections called for in
the 24 months/30,000 miles (48,000 km) maintenance schedule (NormalConditions) as soon as you take it
out of storage (see page 158). The
replacements called for in the
maintenance schedule are not
needed unless the car has actually
reached that time or mileage.

Maintenanc e

Inde
x

SRS, Additional Information
SRS Components......................... 45

SRS Service................................... 47

SRS Indicator............................. 47, 55

START (Ignition Key Position) ..... 71
Starting the Engine........................ 133 In Cold Weather at HighAltitude................................... 133
With a Dead Battery................. 227
Steam Coming from Engine......... 229

Steering Wheel
Adjustment................................... 65

Anti-theft Column Lock.............. 71

Stereo Sound System...................... 98
Storing Your Car............................ 210
Supplemental Restraint System..... 45 Servicing....................................... 47

SRS Indicator......................... 47, 55

System Components.................... 45
Synthetic Oil................................... 169
Tachometer...................................... 57
Taillights, Changing Bulbs in....... 204 Taking Care of the Unexpected.. 219
Tape Player..................................... 111

Technical Descriptions
Driving In Foreign Countries... 251

Emissions Control Systems...... 252

Oxygenated Fuels...................... 250
Three Way Catalytic Converter................................ 254
Technical Information................... 243
Temperature Gauge........................ 58
Tether Attachment Points.............. 40
Three Way Catalytic Converter... 254
Time, Setting the............................. 83
Timing Belt..................................... 191
Tire Chains..................................... 197 Tire, How to Change a Flat.......... 221
Tires................................................ 192 Air Pressure............................... 192
Checking Wear.......................... 194Compact Spare........................... 220
DOT Tire Quality Grading....... 248
Inflation....................................... 192
Inspection................................... 194
Maintenance............................... 194
Replacing.................................... 195
Rotating....................................... 195
Snow............................................ 197
Specifications............................. 247

Tools, Tire Changing.................... 221

Towing
A Trailer...................................... 147

Emergency Wrecker................. 241

Transmission
Checking Fluid Level,
Automatic............................... 178

Checking Fluid Level, Manual.................................... 179
Fluid Selection............................ 178

Identification Number............... 244

Shifting the Automatic..............136
Shifting the Manual................... 134

Treadwear...................................... 248

Trip Meter........................................ 57

Trunk................................................. 73

Opening......................................... 73

Open Monitor Light.................... 55

Turn Signals..................................... 62

Underside, Cleaning...................... 216
Unexpected, Taking Care of the........................................... 219