11) Disconnect connectors and then detach com-
bination switch assembly.
12) Remove lighting switch and wiper switch from
roll connector.
B5M0940
B: ADJUSTMENT
1. CENTERING ROLL CONNECTOR
Before installing steering wheel, make sure to cen-
ter roll connector built into combination switch.
1) Make sure that front wheels are positioned
straight ahead.
2) Install steering gearbox, steering shaft and
combination switch properly. Turn roll connector
pin (A) clockwise until it stops.
3) Then, back off roll connector pin (A) approxi-
mately 2.5 turns until ªGº marks aligned.
H5M0663B
C: INSTALLATION
CAUTION:
Failure to do this might damage roll connector.
1) Install lighting switch and wiper switch to roll
connector.
2) Before installing combination switch, check to
ensure that combination switch is off and front
wheels are set in the straight ahead position.
3) Install combination switch assembly and then
connect connectors.
4) Install column cover and centering roll connec-
tor.
5) Install steering wheel in neutral position. Care-
fully insert roll connector pin (A) into hole on steer-
ing wheel.
NOTE:
If steering wheel angle requires fine adjustment,
adjust tie-rod.
H5M0663B
6) Install airbag module and lower cover in the
reverse order of removal.
15
[W8C0]5-5SERVICE PROCEDURE
8. Roll Connector
