1999 LEXUS SC300 ECU

DRIVING TIPS
265
Hitches

If you wish to install a trailer hitch, your Lexus dealer
should be consulted.

Use only a hitch which is recommended by Lexus dealer
and conforms to the total trailer weight requirement.

Follow the directions supplied by the hitch manufacturer.
Lubricate the hitch ball with a light coat of grease.

Lexus recommends removing the trailer hitch whenever
you are not towing a trailer to reduce the possibility of
additional damage caused by the hitch if your vehicle is
struck from behind. After removing the hitch, seal any
mounting holes in the vehicle body to prevent entry of
pollutants such as exhaust fumes, dirt, water, etc.

Remove the trailer hitch whenever you are not towing a
trailer so that the rear license plate can be seen clearly.
NOTICE

Install the trailer hitch using only the position
recommended by your Lexus dealer. Do not install the
trailer hitch on the bumper; this may cause body
damage.

Do not use axle±mounted hitches as they can cause
damage to the axle housing, wheel bearings, wheels or
tires.
Brakes and safety chains

Lexus recommends trailers with brakes that conform
to any applicable federal and state/provincial
regulations.

A safety chain must always be used between the towing
vehicle and the trailer. Leave sufficient slack in the
chain for turns. The chain should cross under the
trailer tongue to prevent the tongue from dropping to
the ground in case it becomes damaged or separated.
For correct safety chain procedur es, follow the hitch or
trailer manufacturer's recommendations.
CAUTION

If the total trailer weight exceeds 450 kg (1000 lb.), trailer
brakes are required.

Never tap into your vehicle's hydraulic system as it will
lower its braking effectiveness.

Never tow a trailer without using a safety chain securely
attached to both the trailer and the vehicle. If damage
occurs to the coupling unit or hitch ball, there is possible
danger of the trailer wandering over into another lane.

DRIVING TIPS
266
Tires

Ensure that your vehicle's tires are properly inflated.
Adjust the tire pressure to the recommended cold tire
pressure indicated below:
SC400, SC 300 ± Front 220 kPa (2.2 kgf/cm
2 or bar, 32 psi)
Rear 220 kPa (2.2 kgf/cm2 or bar, 32
psi)

The trailer tires should be inflated to the pressure
recommended by the trailer manufacturer in respect to the
total trailer weight.
Trailer lights

Trailer lights must comply with federal, state/provincial
and local regulations. See your local recreational vehicle
dealer or rental agency for the correct type of wiring and
relays for your trailer. Check for correct operation of the
turn signals and stop lights each time you hitch up. Direct
splicing may damage your vehicle's electrical system and
cause a malfunction of your lights.
Break±in schedule

Lexus recommends that you do not tow a trailer with a new
vehicle or a vehicle with any new power train component
(engine, transmission, differential, wheel bearing, etc.) for
the first 800 km (500 miles) of driving.
Maintenance

If you tow a trailer, your vehicle will require more frequent
maintenance due to the additional load. For this
information, please refer to the scheduled maintenance
information in the ºOwner's Manual Supplement/
Maintenance Scheduleº.

Retighten all fixing bolts of the towing ball and bracket
after approximately 1000 km (600 miles) of trailer driving.
Pre±towing safety check

Check that your vehicle remains level when a loaded or
unloaded trailer is hitched. Do not drive if the vehicle has
an abnormal nose±up or nose±down condition, and check
for improper tongue load, overload, worn suspension or
other possible causes.

Make sure the trailer cargo is securely loaded so that it
cannot shift.

Check that your rear view mirrors conform to any federal,
state/provincial or local regulation. If they do not, install
required rear view mirrors appropriate for towing
purposes.

IN CASE OF AN EMERGENCY
285
When removing the jack, turn the joint by hand in the
CONTRACT direction until the jack is free. When storing,
turn the joint by hand in the EXPAND direction until the jack
is firmly secured to prevent it from flying forward during a
collision or sudden braking.

IN CASE OF AN EMERGENCY
294
8. Lower the vehicle completely and tighten the wheel
nuts.
Turn the jack handle counterclockwise to lower the vehicle.
Use only the wheel nut wrench to tighten the nuts. Do not use
other tools or any additional leverage other than your hands,
such as a hammer, pipe or your foot. Make sure the wrench
is securely engaged over the nut.
Tighten each nut a little at a time in the order shown. Repeat
the process until all the nuts are tight.

IN CASE OF AN EMERGENCY
2969. After
changing the wheel, check the air pr essure of the
replaced tire. Stow all the tools, jack and flat tire securely.
If the pressure of the replaced tire is low, drive slowly to the
nearest service station and fill to the correct pressure.
Do not forget to reinstall the tire valve cap as dirt and moisture
could get into the valve core and possible cause air leakage.
If the cap is missing, put a new one on as soon as possible.
This is the same procedure for changing or rotating your tires.
CAUTION
Before driving, make sure all the tools, jack and flat tire are
securely in place in their storage location to reduce the
possibility of personal injury during a collision or sudden
braking.

IN CASE OF AN EMERGENCY
304If towing is necessary, we recommend you to have it done
by your Lexus dealer or a commercial tow truck service.
If towing service is not available in an emergency, your
vehicle may be temporarily towed by a cable or chain
secured to the emergency towing eyelet. Use extreme
caution when towing the vehicle.
A driver must be in the vehicle to steer it and operate the
brakes.
Towing in this manner may be done only on hard±surfaced
roads
for a short distance and at low speeds. Also, the wheels,
axles, drive train, steering and brakes must all be in good
condition.

IN CASE OF AN EMERGENCY
305
CAUTION
Use extreme caution when towing the vehicle. Avoid sudden
starts or erratic driving maneuvers which would place
excessive stress on the emergency towing eyelet and towing
cable or chain. The eyelet and towing cable or chain may
break and cause serious injury or damage.
NOTICE
Use only a cable or chain specifically intended for use in
towing vehicles. Securely fasten the cable or chain to the
towing eyelet provided.
Before towing, release the parking brake and put the
transmission in ºNº. The ignition key must be in ºACCº
(engine off) or ºONº (engine running).
CAUTION
If the engine is not running, the power assist for the brakes and
steering will not work so steering and braking will be much
harder than usual.

MAINTENANCE
312
GENERAL MAINTENANCE
Listed below are the general maintenance items that should be
performed at the intervals specified. It is recommended that
any problem you notice be brought to the attention of your
Lexus dealer or qualified service shop for their advice.
CAUTION
Make these checks only where adequate ventilation can be
obtained if you run the engine.
Vehicle exterior
Items listed below should be performed from time to time,
unless otherwise specified.
Tire pressure
Check the pressure with a gauge every two weeks, or at least
once a month and adjust as shown on the tire pressure label.
See page 363 for additional information.
Tire surface
Check the tires carefully for cuts, damage or excessive wear.
See page 365 for additional information.
Wheel nuts
When checking the tires, make sure to check the nuts for
looseness. Tighten them if necessary. Tire rotation
Rotate the tires every 12000 km (7500 miles). See page 365
for additional information.
Fluid leaks
Check underneath for leaking fuel, oil, water or other fluid
after
the vehicle has been parked for a while. If you smell fuel
fumes or notice any leak, have the cause found and corrected
immediately.
Doors and engine hood
Check that all doors, including trunk lid, operate smoothly
and all latches lock securely. Make sure the engine hood
secondary latch secures the hood when the primary latch is
released.