1999 LEXUS SC300 engine oil

ENGINE
341
USED ENGINE OIL
CAUTION

Used engine oil contains potentially harmful contaminants
which may cause skin disorders such as inflammation or
skin cancer, so care should be taken to avoid pr olonged and
repeated contact with it. To remove used engine oil from
your skin, wash thoroughly with soap and water.

Do not leave used oil within the reach of children.

Dispose of used oil and used oil filters only in a safe and
acceptable manner. Do not dispose of used oil and used oil
filters in household trash, in sewers or onto the ground.
Call your Lexus dealer or a service station for information
concerning recycling or disposal.

ENGINE
342
CHECKING THE ENGINE OILLEVEL
With the engine at operating temperature and turned off,
check the oil level on the dipstick.
1. To get a true reading, the vehicle should be on a level spot.
After turning off the engine, wait a few minutes for the oil to
drain back into the bottom of the engine.
2. Pull out the dipstick, and wipe it clean with a rag.
3. Reinsert the dipstick and push it in as far as it will go, or
the reading will not be correct.

ENGINE
343
4. Pull the dipstick out and look at the oil level on the end.
If it is between the full line (full level mark) and the low line
(low level mark), it is O.K.

ENGINE
345
If the oil level is below or only slightly above the low line
(low
level mark), add engine oil of the same type as alr eady
in the engine.
Remove the oil filler cap and add engine oil a little at a time,
checking the dipstick. The approximate quantity of oil
needed to fill between the low line (low level mark) and the
full line (full level mark) on the dipstick is indicated below for
reference. When the level reaches within the correct range, return the
filler cap and turn the cap clockwise until you hear a click.
Oil quantity. L (qt., lmp. qt.) SC400, SC300 ± 1.5 (1.6,
1.3)
NOTICE
Avoid
overfilling, or the engine could be damaged. Check
the oil level on the dipstick once again after adding the oil.

ENGINE
346
Engine oil selection
Use API SJ, ºEnergy±Conservingº multigrade engine oil or
ILSAC multigrade engine oil.
Recommended viscosity (SAE):
SAE 5W±30 is the best choice for your vehicle, for good
fuel economy, and good starting in cold weather.
If you use SAE 10W±30 engine oil in extremely low
temperatures, the engine may become difficult to start, so
SAE 5W±30 engine oil is recommended.

ENGINE
347
Oil identification marks
Either or both API registered marks are added to some oil
containers to help you select the oil you should use.

The API Service Symbol is located anywhere on the
outside of the container.
The top portion of the label shows the oil quality by API
(American Petroleum Institute) designation such as SJ.
The center portion of the label shows the SAE viscosity
grade such as SAE 5W±30. ºEner gy±Conservingº, shown
in the lower portion, indicates that the oil has fuel±saving
capabilities.

The ILSAC (International Lubricant Standardization and
Approval Committee) Certification Mark is displayed on
the front of the container.CHECKING THE ENGINE
COOLANT LEVEL

CHASSIS
355
SPECIFICATIONS (SC400)
± AUTOMATIC TRANSMISSIONFluid capacity Drain and refill
Fluid type
1.9 L (2.0 qt., 1.7 lmp.qt.)
Automatic transmission fluid Type T ± IV or equivalent
± DIFFERENTIAL
Oil capacity
Oil type
Oil viscosity
1.35 L (1.42 qt., 1.19 lmp.qt.)
Hypoid gear oil API GL±5
Above ±18C (0F): SAE90
Below ±18C (0F): SAE80W or SAE80W±90
± BRAKES
Pedal clearance *
1
Pedal freeplay
Brake pad wear limit
Parking brake lining wear limit *
2
Parking brake adjustment
Fluid type
89 mm (3.5 in.) Min.
1 ± 6 mm (0.04 ± 0.24 in.)
1.0 mm (0.04 in.)
1.0 mm (0.04 in.)
5 ± 8 clicks
SAE J1703 or FMVSS No. 116 DOT 3
*1: Minimum pedal clearance when depressed with the pressure of 490 N (50 k\
gf, 110 lbf.) with the engine running
*
2: Parking brake adjustment when pulled with the force of 196 N (20 kgf, 4\
4 lbf.)

CHASSIS
357
SPECIFICATIONS (SC300)
± AUTOMATIC TRANSMISSIONFluid capacity Drain and refill
Fluid type
1.6 L (1.7 qt., 1.4 lmp.qt.)
Automatic transmission fluid D±II or DEXRONIII
(DEXRONII)
± DIFFERENTIAL
Oil capacity
Oil type
Oil viscosity
1.35 L (1.42 qt., 1.19 lmp.qt.)
Hypoid gear oil API GL±5
Above ±18C (0F): SAE90
Below ±18C (0F): SAE80W or SAE80W±90
± BRAKES
Pedal clearance *
1
Pedal freeplay
Brake pad wear limit
Parking brake lining wear limit *
2
Parking brake adjustment
Fluid type
89 mm (3.5 in.) Min.
1 ± 6 mm (0.04 ± 0.24 in.)
1.0 mm (0.04 in.)
1.0 mm (0.04 in.)
5 ± 8 clicks
SAE J1703 or FMVSS No. 116 DOT 3
*1: Minimum pedal clearance when depressed with the pressure of 490 N (50 k\
gf, 110 lbf.) with the engine running
*
2: Parking brake adjustment when pulled with the force of 196 N (20 kgf, 4\
4 lbf.)