1999 LEXUS SC300 headlight

SWITCHES
33
To turn the lights on, twist the knob on the end of the lever.
FIRST CLICKSTOP: Only the parking, tail, license plate,
side marker and instrument panel lights turn on.
SECOND CLICKSTOP: Headlights also turn on.
THIRD CLICKSTOP (ºAUTOº): The headlights and all
other lights automatically turn on depending on the darkness
of the surroundings.
When the headlights are on, the headlight indicator lights up
in the instrument cluster.
Manually twist the knob to the second clickstop to turn on
the headlights if they are needed immediately when
entering a dark tunnel, parking structure, etc.

SWITCHES
34
The automatic light control sensor is on top of the driver's
side instrument panel.
Do not place anything on the instrument panel, and/or do not
affix anything on the windshield to block this sensor.
The lights automatically turn off when the driver's door is
opened with the ignition key turned to the ºACCº or ºLOCKº
position. To turn them on again, turn the ignition key to the
ºONº position or turn the headlight switch off and then twist
the knob until the first or second clickstop. If you are going
to park for over one week, make sure the headlight switch is
off.
When the headlight switch is turned to the first or second
clickstop, the brightness of the instrument cluster will be
reduced slightly unless the instrument panel light control
knob is turned fully on.

SWITCHES
35
Daytime Running Light System
The headlights turn on at reduced intensity when the parking
brake is released with the engine started, even with the light
switch in the ºOFFº position. They will not go off until the
ignition switch is turned off.
To turn on the other exterior lights and instrument panel
lights, twist the knob to the first clickstop.
Twist the knob to the second clickstop to turn on the
headlights to full intensity for driving at night.
When setting the knob to the third clickstop (ºAUTOº), the
headlights will automatically adjust to full intensity and/or
turn on the other lights depending on the darkness of the
surroundings. Likewise, as the surroundings become
brighter, the headlights will turn to reduced intensity,
ultimately turning off the other lights.
NOTICE
To prevent the battery from being discharged, do not leave
the lights on longer than necessary when the engine is not
running.
HEADLIGHT DIMMER AND
TURN SIGNAL SWITCH

SWITCHES
36
For high beam, push the lever forward. Pull it back for
low beam. For the headlight flasher, pull it further back.
A blue light in the instrument cluster indicates high beam or
headlight flasher is on.
The headlight flasher works even when the headlight switch
is off.

SWITCHES
37
For signaling turns, move the lever up or down in the
conventional manner.
The ignition key must be in the ºONº position.
The turn signal is self±cancelling after a turn, but after a lane
change, you may have to cancel it by hand. You can also
signal a lane change by moving the turn signal lever partway
and holding it there.
If the green light in the instrument cluster flashes faster than
normal, it indicates that the front or rear turn signal bulb has
burned out. If this indicator light does not come on,
the fuse
or the indicator light itself has probably failed.
FOG LIGHT SWITCH
To turn on the fog lights, turn the switch to the ºONº
position. The fog lights come on only when the headlights
are on low beam.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
58
(i) Open Door Warning Light
This light remains on until all the doors are completely closed.
(j) Rear Light Failure Warning Light
If this light comes on when the headlight switch is turned on
(at the first or second clickstop), it indicates that one or more
of the tail lights are burned out.
If it comes on when the brake pedal is depressed, one or more
stop lights are burned out.
Have defective bulbs replaced as soon as possible.
(k) ºTRAC OFFº Indicator/Warning Light
This light comes on when the ignition key is turned to ºONº,
and will go off after about a few seconds. This means that the
system is operating properly.
If either of the following conditions occurs, this indicates a
malfunction somewhere in the parts monitored by the
warning light system. Contact your Lexus dealer as soon as
possible to service the vehicle.

The light remains on more than a few seconds after the
ignition switch is turned on.

The light comes on while driving even if the ºTRAC OFFº
switch is not pushed.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
64
INSTRUMENT PANEL LIGHTCONTROL
To adjust the brightness of the instrument panel lights,
turn the knob.
When the headlight switch is in the first or second click stop,
you can also adjust the brightness of the displays on the audio
and air conditioning systems using this knob.

COMFORT ADJUSTMENT
109
OUTSIDE REAR VIEWMIRRORS
Adjust the mirror so that you can just see the side of your
vehicle in the mirror.
Be careful when judging the size or distance of any object
seen in the outside rear view mirror on the passenger's side.
It is a convex mirror with a curved surface. Any object seen
in a convex mirror will look smaller and farther away than if
seen in a normal flat mirror.
When the inside rear view mirror darkens in ºAUTOº mode,
the outside rear view mirrors also darken to reduce the
reflection of the headlights of the following vehicle. For
details, see ºInside rear view mirrorº on page 113.
When you push the rear window defogger switch, the heater
panels in the outside rear view mirrors will quickly clear the
mirror surface.