COMFORT ADJUSTMENT
169
1. Adjust the driver's seat, tilt and telescopic steering and
outside rear view mirrors to the desired position.
2. While pushing the ºSETº button, push button º1º or
º2º until the signal beeps.
The beep sound means that the positions are recorded in the
computer 's memory.
By repeating these two steps and pressing the remaining
button, the driving position for another driver can be
recorded.
To set a new memorized position, select the desired position
and perform step 2. The previous memory will be erased and
the new position will be set.
To make only slight changes to an already memorized
position, the easiest way is to first activate the memorized
position, then make the desired changes and perform step 2
above.Activating a memorized position
COMFORT ADJUSTMENT
170
When you push button º1º or º2º, the signal beeps and the
driving position automatically adjusts to the position
recorded for that button.
Conditions for memorized position activation
Ignition key ºONº
Selector lever in ºPº position
All parts of the memorized positions can be activated.
However, if the brake pedal is being depressed, the seat
position will not change.
Key not in ignition switch
Within 30 seconds of opening driver's door
The memorized position can be activated, except for the
tilt and telescopic steering. If any driving position memory switch is pushed while one of
the memorized driving position profiles is being activated,
the operation will stop.
To activate the system, push the desired button (º1º or º2º)
again.
The driving position memory control system cannot be
operated while the vehicle is moving.
If the vehicle's battery is disconnected, the computer's
memory
will be erased and the memorized positions will have
to be set again.
