1999 Lexus LS400 warning light

COMFORT ADJUSTMENT
156The indicator comes on when the ignition key is
turned to the ºACCº or ºONº position. It goes off
after about 6 seconds. This means the SRS is
operating properly.
The SRS warning light system monitors the airbag
sensor assemblies, inflators, seat belt pretensioners,
warning
light, interconnecting wiring and power sources.
(For details, see ºService reminder indicators and
warning buzzersº on page 62 for instructions.)
16L029

COMFORT ADJUSTMENT
163


1Side airbag module (airbag and inflator)
2Airbag module for front passenger
(airbag and inflator)
3Side airbag sensor assembly
4Seat belt pretensioner
5Airbag module for driver (airbag and inflator)
6SRS warning light
7Airbag sensor assembly
The SRS airbag sensor assemblies consist of a safing
sensor and driver and front passenger airbag sensor.
In a severe frontal impact, the driver and front passenger
airbag sensor detects deceleration and the system
triggers the front airbag inflators and seat belt
pretensioners. In a severe side impact, the side airbag
sensor triggers the side airbag inflator. Then a chemical
reaction in the inflators momentarily fills the airbags with
non±toxic gas to help restrain the forward or lateral
motion of the occupants. Then the inflators fill the
airbags and the seat belts are quickly drawn back in by
the retractors to help restrain forward motion of the
occupants.
When the SRS operates, it produces a fairly loud noise
and release some smoke and residue along with
non±toxic gas. This does not indicate a fire. This gas is
normally harmless, however, for those who have
delicate skin, it may cause minor skin irritation. Be sure
to wash off any residue as soon as possible to prevent
minor skin irritation. Deployment of the airbags happens in a fraction of a
second, so the airbags must inflate with considerable
force. While the system is designed to reduce serious
injuries, it may also cause minor burns or abrasions and
swellings.
Parts of the airbag module (steering wheel hub,
dashboard, front seats) may be hot for several minutes,
but the airbags themselves will not be hot. The airbags
are designed to inflate only once.
A crash severe enough to inflate the driver and front
passenger airbags may break the windshield as the
vehicle buckles. In vehicles with a front passenger
airbag, the windshield may also be damaged by
absorbing some of the force of the inflating airbag.

STARTING AND DRIVING
301
Resuming the preset speed
If the preset speed is cancelled by pulling the control
lever or by depressing the brake pedal, pushing the lever
up in the ºRES/ACCº direction will restore the speed set
prior to cancellation. However, once the vehicle speed
falls below about 40 km/h (25 mph), the preset speed will
not be resumed.
Cruise control failure warning
If the ºCRUISEº indicator light in the instrument cluster
flashes when using the cruise control, push the main
switch to turn the system off and then push it again to
turn it on.
If any of the following conditions then occurs, there is
some trouble in the cruise control system.
 The indicator light does not come on.
 The indicator light flashes again.
 The indicator light goes out after it comes on.
If this is the case, contact your Lexus dealer and have
your Lexus inspected.
ELECTRONICALLY
MODULATED AIR SUSPENSION
(U.S.A. ONLY)
This electronically modulated air suspension
adjusts the damping effect on the shock absorbers
and the vehicle height. This adjustment is
automatically made in response to the driving
conditions to provide good riding comfort and
stability in all driving conditions.

STARTING AND DRIVING
304
31L016-2
The indicator light shows ºHIGHº mode is selected.
When you turn the ignition key to the ºONº position, the
indicator light will come on for 2 seconds in any mode.
NOTICE
For vehicles equipped with the height controlswitch, be sure to turn the ignition switch offbefore jacking. If this is not done, the vehicleheight adjustment function will operate, whichmay cause body damage.
(b) Malfunction warning
If the ºHIº indicator light blinks, there is a malfunction in
this system. Have the system checked by your Lexus
dealer at the first opportunity.
TRACTION CONTROL SYSTEM
The traction control system automatically helps
control the spinning of the rear wheels which may
occur when accelerating on slippery road surfaces,
thus assisting driver to control the driving power of
the rear wheels.

STARTING AND DRIVING
310
Vehicle skid control failure warning
31L073
In the following cases, the warning message
appears and the reminder light next to the warning
message and the ºVSC OFFº indicator light come
on. And the warning tone also sounds.
(a) After the removal of the battery terminals (See ºInitial
adjustment of vehicle skid control systemº described
below.)
(b) If the vehicle skid control system malfunctions
If the message appears for the cause of (b), have your
vehicle checked by Lexus dealer as soon as possible.
Although the message appears, there is no problem to
continue your normal driving.
Initial adjustment of vehicle skid control
system

STARTING AND DRIVING
311
After the battery terminals are disconnected, an initial
adjustment should be made. At this time, the reminder
light
comes on and the warning message appears in the
multi information display.
Make an initial adjustment in the following ways:
1. Apply the parking brake and put the transmission in
ºPº.
2. Connect the battery terminals.
3. Turn the ignition switch on. At this time, the ºVSC
OFFº indicator light comes on and then about 6 seconds
later, the reminder light comes on and the ºCHECK VSCº
warning message appears in the multi information
display.
4. The warning message and the ºVSC OFFº indicator
light go out about 15 seconds after the ignition switch is
turned on. If the vehicle is shaken after the ignition
switch is t urned to ºONº, it may take longer to go out the
warning message.
If the warning message does not go out about 1 minute
after you turn the ignition switch on, turn it off and then
on again.
If the vehicle is on the moving object like a ship or
turntable, an accurate adjustment cannot be made.
Move the vehicle on the ground (or the part not causing
vibrations to the vehicle) and make an adjustment from
step 1.

STARTING AND DRIVING
313
BRAKE SYSTEM
The tandem master cylinder brake system is a hydraulic
system with two separate sub±systems. If either
sub±system should fail, the other will still work.
However, the pedal will be harder to press, and your
stopping distance will be longer. Also, the brake system
warning light may come on.
CAUTION
Do not drive your vehicle with only a single brake
system. Have your brakes fixed immediately.
Brake booster
The brake booster uses engine vacuum to power±assist
the brakes. If the engine should quit while you are
driving, you can bring the vehicle to a stop with normal
pedal pressure. There is enough reserve vacuum for
one or two stops but no more!

STARTING AND DRIVING
317
ºABSº warning light
31L019-2