1999 Lexus LS400 brake fluid

INTRODUCTION
393
Checking brake fluid
Parts (if level is low):

FMVSS No. 116 DOT 3 or SAE J1703 brake fluid
Tools:

Funnel (only for adding fluid)
Checking power steering fluid
Parts (if level is low):

Automatic transmission fluid DEXRON
II or III
Tools:

Rag or paper towel

Funnel (only for adding fluid)
Checking battery condition
Non±maintenance batteries
Tools:

Warm water

Baking soda

Grease

Conventional wrench (for terminal clamp bolts)
Maintenance type batteries Parts (if level is low):


Distilled water
Tools:

Warm water

Baking soda

Grease

Conventional wrench (for terminal clamp bolts)

Coin (for vent plugs)

Funnel (only for adding distilled water)
Checking and replacing the blade type
fuses
Parts (if replacement is necessary):

Fuse with same amperage rating as original
Checking the cartridge type fuses
Parts (if replacement is necessary):

Genuine Lexus fuse or equivalent with same
amperage rating as original

SECTION 6 ± 3
414
SERVICE PROCEDURES AND
SPECIFICATIONS
Chassis
Specifications415
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking brake fluid 417
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking power steering fluid 419
. . . . . . . . . . . . . . . . . .
Checking tire pressure 421
. . . . . . . . . . . . . . . . . . . . . . . . .
Rotating tires 423
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking and replacing tires 425
. . . . . . . . . . . . . . . . . . .
Installing snow tires and chains 429
. . . . . . . . . . . . . . . . .
Replacing wheels 431
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Aluminum wheel precautions 431
. . . . . . . . . . . . . . . . . . .
Suspension and chassis 432
. . . . . . . . . . . . . . . . . . . . . . .

CHASSIS
415
SPECIFICATIONS
± AUTOMATIC TRANSMISSIONFluid capacity Drain and refill
Fluid type
1.9 L (2.0 qt., 1.7 lmp.qt.)
Automatic transmission fluid Type T ± IV or
equivalent
± DIFFERENTIAL
Oil capacity
Oil type
Oil viscosity
1.3 L (1.4 qt., 1.1 lmp.qt.)
Hypoid gear oil API GL±5
Above ±18 C (0F): SAE 90
Below ±18 C (0F): SAE 80W or SAE 80W±90
± BRAKES
Pedal clearance
Pedal freeplay
Brake pad wear limit
Parking brake lining wear limit
Parking brake adjustment
Fluid type
70 mm (2.8 in.) Min. *1
1 ± 6 mm (0.04 ± 0.24 in.)
1.0 mm (0.04 in.)
1.0 mm (0.04 in.)
5 ± 7 clicks *
2
SAE J1703 or FMVSS No. 116 DOT 3
*1: Minimum pedal clearance when depressed with the pressure of 490 N (50 k\
gf, 110 lbf.) with the engine running
*
2: Parking brake adjustment when depressed with the pressure of 294 N (30 \
kgf, 66.1 lbf.)

CHASSIS
417
CHECKING BRAKE FLUID
63L001a
To check the fluid level, simply look at the
see±through reservoir. The level should be between
the ºMAXº and ºMINº lines on the tank.
It is normal for the brake fluid level to go down slightly as
the brake pads wear. So be sure to keep the reservoir
filled.
If the reservoir needs frequent refilling, it may indicate a
serious mechanical problem.
If the level is low, add FMVSS No.116 DOT 3 or SAE
J1703 brake fluid to the brake reservoir.
Remove and replace the reservoir cover by hand. Add
brake fluid up to the ºMAXº line.
Use only newly opened brake fluid. Once opened, brake
fluid absorbs moisture from the air, and excess moisture
can cause a dangerous loss of braking efficiency.

CHASSIS
418
CAUTION
Take care when filling the reservoir because brake fluid
can harm your hands or eyes and damage painted
surfaces. If fluid gets in your hands or eyes, flush them
with clean water.