1999 Lexus LS400 battery

KEYS AND DOORS
18
1Locking the doors and sounding an alarm
2Unlocking the doors
3Indicator light
4Unlocking the trunk lid
NOTE: *This feature can be set inoperative as
vehicle theft deterrent measure in case of the loss ofthe wireless remote control key. Ask your Lexusdealer for details.
When you operate any button on the key, push it slowly
and surely.
The operational range of the wireless remote control is
approximately 1 meter (3 ft.). The effective range may
vary with different conditions. To activate the wireless
remote control without fail, do it approximately 1 meter
(3 ft.) from your Lexus. In the following cases, the battery in the key may be
discharged. If this is a case, replace it using a special
screwdriver.

The remote control does not work.
 The operational range of wireless remote control
becomes extremely short.
 The indicator light on the key is dimmed or does not
come on.
For the replacement of the battery, see ºReplacing the
batteryº on page 26. You can also have the battery of the
key replaced by your Lexus dealer.
If you lose the wireless key, contact your Lexus dealer
as soon as possible to avoid the possibility of theft, or an
accident.
You can use up to 4 wireless remote control keys for the
same vehicle. Contact your Lexus dealer for detailed
information.
The wireless remote control key is an electronic
component. Observe the following instructions in
order not to cause damage to the key.
 Do not leave the wireless remote control key on
places where the temperature becomes high such as
on the dashboard.
 Do not disassemble it.
 Avoid knocking it hard against other objects or

KEYS AND DOORS
26
CAUTION
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
For vehicles sold in CanadaThis device complies with RSS±210 of Industry
Canada.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may
cause undesired operation of the device.Replacing the battery
When you replace the battery, prepare a lithium battery
CR1616 and a special screwdriver.

KEYS AND DOORS
27
CAUTION
Special care should be taken that small children do not
swallow the removed battery or components.
NOTICE
When replacing the battery, be careful not to lose thecomponents, screws and O±ring.
11L028±1
1. Remove the screw, and then the cover while pushing
it in the arrow direction.

KEYS AND DOORS
28
11L029±1
2. Remove the module from the key frame.
11L030±1
3. Remove the 2 screws to take out the lid of the module.
4. Take out the discharged battery and put a new battery
with the positive side up.

KEYS AND DOORS
29
NOTICE
Make sure the positive side and negative sideof the battery should be faced correctly.
Be careful not to bend the electrode of thebattery insertion and that dust or oils do notadhere to the inside of the module.
Take care not to lose the screws and O±ring.
5. Install the lid with the O±ring and 2 screws.
NOTICE
Take care not to damage or bend the O±ring wheninstalling.
6. Install the module into the key frame and secure the
cover with the screw.
7. When pushing any switch on the wireless key, make
sure the indicator light comes on.
DOORS
Locking with key

SWITCHES
37
The automatic light control sensor is on top of the
driver's side instrument panel.
Do not place anything on the instrument panel, and/or do
not affix anything on the windshield to block this sensor.
When the headlights come on, the lights automatically
turn off about 30 seconds after any of the doors is
opened and closed with the ignition key turned to the
ºACCº or ºL
OCKº position.** To turn them on again, turn
the ignition key to the ºONº position, or turn the headlight
switch off and then twist the knob until the first or second
clickstop. If you are going to park for over one week,
make sure the headlight switch is off.
When the headlight switch is on with all the doors locked,
pushing the ºLOCKº button on the wireless remote
control key turns off the headlights.
NOTE: *The operating condition or sensitivity can be changed. **The time before turning off the lights can
be changed. Ask your Lexus dealer for details.
Daytime Running Light System
The headlights turn on at reduced intensity when the
parking brake is released with the engine started, even
with the light switch in the ºOFFº position. They will not
go off until the ignition switch is turned off.
To turn on the other exterior lights and instrument panel
lights, twist the knob to the first clickstop.
Twist the knob to the second clickstop to turn on the
headlights to full intensity for driving at night.
When setting the knob to the third clickstop (ºAUTOº),
the headlights will automatically adjust to full intensity
and/or turn on the other lights depending on the
darkness of the surroundings. Likewise, as the
surroundings become brighter, the headlights will turn to
reduced intensity, ultimately turning off the other lights.
NOTICE
To prevent the battery from being discharged, do not leave the lights on longer than necessarywhen the engine is not running.

SWITCHES
46
CAUTION
Since the mirror surfaces can get hot, keep your hands
off them when the rear window and outside rear view
mirror defogger switch is on.
If further defrosting or defogging is desired, simply
actuate the switch again. When the surface has cleared,
push the switch once again to turn the defogger off.
Continuous use may cause the battery to discharge,
especially during stop±and±go driving. The defogger is
not designed to dry rain water or to melt snow.
If the outside rear view mirrors are heavily coated with
ice, use a spray de±icer before operating the switch.
NOTICE
When cleaning the inside of the rear window, be
careful not to scratch or damage the heater wires.
To prevent the battery from being discharged,do not operate the defogger continuouslylonger than necessary.
POWER WINDOW SWITCHES
12L009-2

SWITCHES
53
To turn on the emergency flashers, push the switch.
All the turn signal lights will flash. The emergency
flashers
will work with the engine running or off and with
or without the ignition key.
Turn on the emergency flashers to warn other drivers if
you must stop your vehicle where it might be a traffic
hazard.
Always pull your vehicle as far off the road as possible.
The turn signal light switch will not work when the
emergency flashers are in operation.
NOTICE
To prevent the battery from being discharged, do not leave the switch on longer than necessarywhen the engine is not running.
SEAT HEATER SWITCHES
12L013a