Page 157 of 495

COMFORT ADJUSTMENT
141
CAUTION
Persons should ride in their seats properly wearing
their seat belts whenever the vehicle is moving.
Otherwise, they are much more likely to suffer serious
bodily injury in the event of sudden braking or a
collision.
When using the seat belts, observe the following:
Use the belt for only one person at a time. Do not use
a single belt for two or more people ± even children.
Avoid reclining the seatbacks too much. The seat
belts provide maximum protection when the
seatbacks are in the upright position. (See
ºAdjusting seatback angleº.)
Be careful not to damage the belt webbing or
hardware. Take care that they do not get caught or
pinched in the seat or doors.
Inspect the belt system periodically. Check for cuts,
fraying, and loose parts. Damaged parts should be
replaced. Do not disassemble or modify the system.
Keep the belts clean and dry. If they need cleaning,
use a mild soap solution or lukewarm water. Never
use bleach, dye, or abrasive cleaners ± they may
severely weaken the belts. (See ºCleaning the
interiorº on page 475 for instructions.)
Page 179 of 495

COMFORT ADJUSTMENT
163
1Side airbag module (airbag and inflator)
2Airbag module for front passenger
(airbag and inflator)
3Side airbag sensor assembly
4Seat belt pretensioner
5Airbag module for driver (airbag and inflator)
6SRS warning light
7Airbag sensor assembly
The SRS airbag sensor assemblies consist of a safing
sensor and driver and front passenger airbag sensor.
In a severe frontal impact, the driver and front passenger
airbag sensor detects deceleration and the system
triggers the front airbag inflators and seat belt
pretensioners. In a severe side impact, the side airbag
sensor triggers the side airbag inflator. Then a chemical
reaction in the inflators momentarily fills the airbags with
non±toxic gas to help restrain the forward or lateral
motion of the occupants. Then the inflators fill the
airbags and the seat belts are quickly drawn back in by
the retractors to help restrain forward motion of the
occupants.
When the SRS operates, it produces a fairly loud noise
and release some smoke and residue along with
non±toxic gas. This does not indicate a fire. This gas is
normally harmless, however, for those who have
delicate skin, it may cause minor skin irritation. Be sure
to wash off any residue as soon as possible to prevent
minor skin irritation. Deployment of the airbags happens in a fraction of a
second, so the airbags must inflate with considerable
force. While the system is designed to reduce serious
injuries, it may also cause minor burns or abrasions and
swellings.
Parts of the airbag module (steering wheel hub,
dashboard, front seats) may be hot for several minutes,
but the airbags themselves will not be hot. The airbags
are designed to inflate only once.
A crash severe enough to inflate the driver and front
passenger airbags may break the windshield as the
vehicle buckles. In vehicles with a front passenger
airbag, the windshield may also be damaged by
absorbing some of the force of the inflating airbag.
Page 184 of 495
COMFORT ADJUSTMENT
168
16L178±2
Do not lean against the front door when the
vehicle is in use. The side airbag inflates with
considerable speed and force; you may be
killed or seriously injured.
Do not apply excessive weight to the outer side
of the front seats on vehicles with side airbags.
The child head should not be leaned against
the vicinity of the part where the side airbag
activates.
Page 188 of 495

COMFORT ADJUSTMENT
172
Do not use accessories for the seats which
cover the parts where the side airbags should
inflate. Such accessories may prevent the side
airbags from activating correctly, causing
death or serious injury.
Do not modify or remove any wiring. Do not
modify, remove, strike or open any
components, such as the steering wheel pad,
steering wheel, column cover, front passenger
airbag cover, front seats, airbag sensor
assembly or seat belt assemblies. Doing any of
these may cause sudden SRS operation or
disable the system, which could result in death
or serious injury.
Do not modify or replace the seats or surface of
the front seats with side airbags. Such
changes may disable the system or cause the
side airbags to inflate, resulting in death or
serious injury. Consult your Lexus dealer.
Failure to follow these instructions can result in
death or serious injuries.NOTICE
Do not perform any of the following changes without consulting your Lexus dealer. Suchchanges can interfere with proper operation of the
SRS in some cases.
Installation of electronic items such as a mobile two±way radio, cassette tape player orcompact disc player.
Modification of the suspension system.
Modification of the front end structure and sidestructure of the passenger compartment.
Attachment of a grille guard (bull bar, kangaroobar, etc.), snow plow, winches or any otherequipment to the front end.
Repairs made on or near the front fenders, front
end structure, console, steering column, steering wheel, dashboard near the frontpassenger airbag, front seats or seat belt
assembly.
Page 191 of 495
COMFORT ADJUSTMENT
175
In the following cases, contact your Lexus dealer as
soon as possible:
Any of the SRS airbags have been inflated.
If either front seat belt does not retract or cannot be
pulled out due to a malfunction or activation of the
pretensioner.
The front seat belt retractor assembly or surrounding
area has been damaged.
The front part of the vehicle and portion of the doors
(shaded in the illustration) were involved in an
accident that did not cause the SRS to work.
The surface of the seats with the side airbags or the
pad section of the steering wheel or front passenger
airbag cover (shaded in the illustration) is scratched,
cracked, or otherwise damaged.
NOTICE
Do not disconnect the battery cables before
contacting your Lexus dealer.
Page 398 of 495

MAINTENANCE
382
Vehicle interior
Items listed below should be checked regularly, e.g.
while performing periodic services, cleaning the
vehicle, etc.
Lights
Make sure the headlights, stop lights, tail lights, turn
signal lights, and other lights are working. Check
headlight aim.
Service reminder indicators and warning buzzers
Check that all service reminder indicators and warning
buzzers function properly. Steering wheel
Check that it has the specified freeplay. Be alert for
changes in steering condition, such as hard steering,
excessive freeplay or strange noise.
Seats
Check
that all front seat controls such as seat adjusters,
seatback recliner, etc. operate smoothly. Check that the
head restraints move up and down smoothly and that the
locks hold securely in any latched position.
Seat belts
Check that the seat belt system such as buckles,
retractors and anchors operate properly and smoothly.
Make sure the belt webbing is not cut, frayed, worn or
damaged.
Accelerator pedal
Check the pedal for smooth operation and uneven pedal
effort or catching.
Brake pedal
Check the pedal for smooth operation and the proper
clearance and freeplay. Check the brake booster
function.
Brakes
At a safe place, check that the brakes do not pull to one
side when applied.