1999 Lexus LS400 light

ELECTRICAL COMPONENTS
459
ADDING WASHER FLUID
64L017
If the washer tank becomes nearly empty, add
washer fluid.
You may use plain water as washer fluid. However, in
cold areas where temperatures range below the
freezing point, use washer fluid containing antifreeze.
This product is available at your Lexus dealer and most
auto parts stores. Follow the manufacturer's directions
for how much to mix with water.
NOTICE
Do not use engine antifreeze or any othersubstitute because it may damage your vehicle'spaint.
CHECKING THE HEADLIGHT AIM
(Vehicles with discharge headlight
only)

ELECTRICAL COMPONENTS
460
64L073a

1Vertical movement adjusting bolt 1
2Vertical movement adjusting bolt 2
Before checking the headlight aim:
1. Be sure that the body around the headlight is not
deformed.
2. Park the vehicle on a level spot.
3. The driver gets into the driver's seat and puts the
vehicle in a state readying for a driving (with a full tank).
4. Bounce the vehicle several times.
Adjusting the vertical aiming

ELECTRICAL COMPONENTS
462
64L076a
2. Turn the vertical movement adjusting bolt 2 the same
number of turns and in the same direction at step 1.REPLACING LIGHT BULBS
The illustration on the following pages show the
locations of light bulbs. If it is necessary to replace a
bulb, take your vehicle to your Lexus dealer as soon as
possible. Use bulbs with the bulb numbers and wattage
ratings given in the table.

ELECTRICAL COMPONENTS
463
CAUTION
Do not disassemble, repair or take apart the low beam
headlight bulbs, connector, power supply circuits
and rotated components. Or you may be injured by
electric shocks. Call your dealer when the headlights
fail to work or have to be replaced or disposed of.
 Halogen bulbs have pressurized gas inside and
require special handling. They can burst or shatter if
scratched or dropped. Hold a bulb only by its plastic
or metal case. Do not touch the glass part of a bulb
with bare hands.
NOTICE
Only use a bulb of the listed type.
LIGHT LOCATION
64L022-5

ELECTRICAL COMPONENTS
464Light Bulbs Bulb No. W T
ype
1 Headlights (High beam) HB3 60
A
2 Parking lights ±±± 5
D
3 Headlights (Low beam)
Discharge bulbs D2R 35
B
Halogen bulbs HB4 51
C
4 Front turn signal lights ±±± 21
D
5 Front side marker lights 194 3.8
D
6 Fog lights HB4 51
C

ELECTRICAL COMPONENTS
466Light Bulbs Bulb No. W T
ype
1 High mounted stoplight 921 18
D
2 Trunk light 194 3.8
D
3 License plate lights ±±± 5
D
4 Back±up lights ±±± 21
D
5 Stop and tail lights ±±± 21/5
D
6 Rear turn signal lights ±±± 21
D
7 Rear side marker lights ±±± 5
D

ELECTRICAL COMPONENTS
468Light Bulbs Bulb No. W T
ype
1 Front personal lights ±±± 8
F
2 Front interior light ±±± 8
E
3 Rear interior light ±±± 8
D
Rear personal light ±±± 5
F
4 Rear personal light ±±± 5
F
5 Door courtesy lights 194 3.8
D
6 Footlights ±±± 1.4
D
7 Glove box light ±±± 1.2
D
8 Vanity lights ±±± 3
E A: HB3 halogen bulbs
B: D2R discharge bulbs
C: HB4 halogen bulbs
D: Wedge base bulbs
E: Double end bulbs
F: Single end bulbs

BODY
476
Leather Interior
The selected leather is used in your Lexus. Due to a
leather product, some parts of leather may be rough,
uneven or scratched originally.
To keep good appearance, we recommend you to clean
it periodically twice a year.
Remove dirt on the leather in the following ways:
1. Wipe it off lightly using a soft cloth (e.g. gauze)
dampened with 5% solution of neutral detergent for
wool.
2. Wring water from a clean cloth and thoroughly wipe
off all traces of detergent with it.3. Wipe off
the surface of the leather with a dry soft cloth.
Allow the leather to dry in a ventilated shaded area.
Excess of wet may cause the hardening or shrinking of
the leather.
NOTICE