Page 10 of 472
PICTORIAL INDEX
ix
INSTRUMENT CLUSTER (Vehicles sold in U. S. A.) (Type A)
PE015
Page 12 of 472
PICTORIAL INDEX
xi
INSTRUMENT CLUSTER (Vehicles sold in Canada) (Type A)
PE016
Page 14 of 472
PICTORIAL INDEX
xiii
INSTRUMENT CLUSTER (Vehicles sold in U. S. A.) (Type B)
PE002±2
Page 16 of 472
PICTORIAL INDEX
xv
INSTRUMENT CLUSTER (Vehicles sold in Canada) (Type B)
PE003±2
Page 23 of 472

BE003±4
Note: When the cruise control is being used, even if you downshift the transmi\
ssion by turning off the overdrive switch, engine
braking will not be applied because the cruise control is not cancelled. For th\
e operation to decrease the vehicle speed, see page
277.
Parking, engine starting and key
removal position
Reverse position
Neutral position
Normal driving position
Position for engine braking
Position for stronger engine braking
than that in º2º position
With the brake pedal depressed,
shift while holding the lock release
button in. (The ignition switch must
be in ºONº position.)
Shift while holding the lock release
button
Overdrive switch
ºOFFº position
(Shifting into
overdrive not
possible)
ºO/D OFFº indicator
light on the instrument
cluster
For selecting either a three±speed or
four±speed transmission
ºONº position
(Shifting into
overdrive possible)
Lock release button (To prevent misshifting)
BASIC OPERATION ± QUICK REFERENCE
3
3. AUTOMATIC TRANSMISSION
Page 34 of 472

KEYS AND DOORS
14The engine immobiliser system is a theft prevention
system. When you insert the key in the ignition
switch, the transponder chip in the key's head
transmits an electronic code to the vehicle. The
engine will start, only when the electronic code in
the chip corresponds to the registered ID code for
the vehicle.
The system is automatically set when the key is
removed from the ignition switch. At this time, the
security indicator light at the bottom of the instrument
cluster flashes. When you insert the key in the ignition
switch, the security indicator light goes out and the
system is canceled automatically, which enables the
engine to start.
For your Lexus dealer to make you a new key with
built±in
transponder chip, your dealer will need your key
number and master key. However, there is a limit to the
number of additional keys your Lexus dealer can make
for you. If you make your own duplicate key, you will not be
able to cancel the system or start the engine.
For vehicles sold in U.S.A.
FCC ID: MOZ RI±4ATY MADE IN JAPAN
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
CAUTION
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
Page 49 of 472
SWITCHES
29
To turn the lights on, twist the knob on the end of the
lever.
FIRST CLICKSTOP: Only the parking, tail, license
plate, side marker and instrument panel lights turn on.
SECOND CLICKSTOP: Headlights also turn on.
THIRD CLICKSTOP (ºAUTOº): The headlights and all
other lights automatically turn on depending on the
darkness of the surroundings.
Vehicles sold in U.S.A.:
When the headlights are on,
the headlight indicator lights up in the instrument cluster.
Vehicles sold in Canada: When the tail lights are on,
the tail light indicator lights up in the instrument cluster.
Manually twist the knob to the second clickstop to
turn on the headlights if they are needed
immediately when entering a dark tunnel, parking
structure, etc. When
the headlight switch is turned to the first or second
clickstop, the brightness of the instrument cluster will be
reduced slightly unless the instrument panel light control
knob is turned fully on.
12E002
Page 51 of 472
SWITCHES
31
HEADLIGHT DIMMER ANDTURN SIGNAL SWITCH
12E003±1
For high beam, push the lever forward. Pull it back
for low beam. For the headlight flasher, pull it
further back.
A blue light in the instrument cluster indicates high beam
or headlight flasher is on.
The headlight flasher works even when the headlight
switch is off.