1999 Lexus ES300 ignition switch

EXTERIOR EQUIPMENT
105
15E010a

1Lower 2Tilt up
To tilt up the rear end of the moon roof, push the
switch on the ºTILT UPº side or on the opposite side
to lower it.
To operate the moon roof, the ignition key must be in the
ºONº position. However, even if the ignition key is turned
to the ºACCº or ºLOCKº position, the moon roof can be
operated until a front door is opened ( or for about 45
seconds).
To tilt up the slide±opened moon roof:
Push the switch on the ºTILT UPº side to cl ose the moon
roof fully. After releasing the switch, push the switch on
the same side again.
Operating the moon roof from outside
the vehicle
The moon roof can be closed or opened using an ignition
key.
Insert the ignition key into the key hole on the
driver's door.
To close the moon roof: Turn the key in the locking
direction and hold it.
After the door is locked, the moon roof begins to close.
To stop in the middle, return the key.
To open the moon roof: Turn the key in the unlocking
direction and hold it.
After the door is unlocked, the moon roof begins to open.
To stop in the middle, return the key.

EXTERIOR EQUIPMENT
107
To avoid serious personal injury, you must do the
following.
While the vehicle is moving, always keep the head,
hands and other parts of the body of all occupants
away from the roof opening. Otherwise, you could be
seriously injured if the vehicle stops suddenly or if
the vehicle is involved in an accident.
 Always make sure nobody places his/her head,
hands and other parts of the body in the roof opening
before you close the roof. If someone's neck, head or
hands gets caught in the closing roof, it could result
in a serious injury. When anyone closes the roof, first
make sure it is safe to do so.
 Never leave small children alone in the vehicle,
especially with the ignition key still inserted. They
could use the moon roof switches and get trapped in
the roof opening. Unattended children can become
involved in serious accidents.
 Never sit on top of the vehicle around the roof
opening.

COMFORT ADJUSTMENT
191
Conditions for memorized position activation

Ignition key ºONº and selector lever in ºPº position
All parts of the memorized positions can be activated.
However, if the brake pedal is being depressed, the
seat position will not change.
 Key not in ignition switch and within 30 seconds of
opening driver's door.
The memorized position can be activated.
If any driving position memory switch is pushed while
one of the memorized driving position profiles is being
activated, the operation will stop.
To activate the system, push the desired button (º1º or
º2º) again.
The driving position memory control system cannot be
operated while the vehicle is moving.
If the vehicle's battery is disconnected, the computer's
memory will be erased and the memorized positions will
have to be set again.

THEFT DETERRENT
195
If you lock them with wireless remote control, the turn
signals flash once.
The flashing indicator light will change to stay on when
all the doors, trunk and hood are closed and locked.
3. After 30 seconds, the indicator starts flashing
and the system is set.
Cancelling the system
When
you unlock any door or trunk using an ignition
key or wireless remote control, the system is
cancelled.
If you unlock any door or trunk with wireless remote
control, the turn signals flash twice.
Activating the system
The alarm sounds for 60 seconds if any of the following
are operated:

Unlocking any door or trunk without using an ignition
key or wireless remote control.

Opening the hood forcibly.

Reconnecting the battery.
If any door is unlocked and the ignition key is not in the
ignition switch during the alarm sounding, its door is
automatically locked. To stop the alarm: Use either of the following methods.


Unlock the door or trunk using an ignition key or
wireless remote control.

Turn the ignition switch on.
Testing the system
1. Open all the windows.
2. Set the system as described above.
The front doors should be locked with the ignition key or
wireless remote control. Be sure to wait until the
indicator light starts flashing.
3. Unlock one of the doors from the inside.
The system should activate the alarm.
4. Unlock any of the doors with a key or the wireless
remote control to cancel the system.
5. Repeat this operation for the other doors and
hood.
When testing the hood, also check that the system is
activated when the battery terminal is disconnected and
then reconnected.
If the system does not work properly, have it checked by
your Lexus dealer.

SECTION 3 ± 1
250
STARTING AND DRIVING
Starting and driving
Three±way catalytic converter250
. . . . . . . . . . . . . . . . . .
Engine exhaust caution 253
. . . . . . . . . . . . . . . . . . . . . . . .
Before starting the engine 255
. . . . . . . . . . . . . . . . . . . . . .
Ignition switch with steering lock 256
. . . . . . . . . . . . . . . .
Parking brake 259
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
How to start the engine 260
. . . . . . . . . . . . . . . . . . . . . . . .
Automatic transmission 261
. . . . . . . . . . . . . . . . . . . . . . . .
Cruise control 274
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Electronic modulated suspension 278
. . . . . . . . . . . . . . .
Traction control system 278
. . . . . . . . . . . . . . . . . . . . . . . .
Vehicle skid control system 282
. . . . . . . . . . . . . . . . . . . . .
Brake system 286
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Brake pad wear limit indicators 292
. . . . . . . . . . . . . . . . .
Types of tires 292
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
THREE±WAY CATALYTIC
CONVERTER

STARTING AND DRIVING
256
IGNITION SWITCH WITHSTEERING LOCK
31E036

With the brake pedal depressed, shift while hold-
ing the lock release button in. (The ignition
switch must be in the ºONº position)
Shift while holding the lock release button in.
STARTING AND DRIVING
261
AUTOMATIC TRANSMISSION
Your automatic transmission has a shift lock system
to minimize the possibility of incorrect operation.
This means you can only shift out of ºPº position
when the brake pedal is dep ressed (with the ignition
switch in ºONº position and the lock release button
pressed in). ( )
31E005
1
Lock release button

STARTING AND DRIVING
275
Turning on the system
31L013
To operate the cruise control, push the main switch. This
turns the system on. The indicator light in the instrument
cluster shows that you can now set your desired cruising
speed. Another push on the switch will turn the system
completely off.
When the ignition key is turned off, the main switch is
also automatically turned off. To use the cruise control
again, push the main switch again to turn it on.
CAUTION
To avoid accidental cruise control engagement, keep
the main switch off when not using the cruise control.