1999 Lexus ES300 child restraint

COMFORT ADJUSTMENT
175
4. To remove the infant seat, press the buckle±release
button and allow the belt to retract completely.
The belt
will move freely again and be ready to work for an adult
or older child passenger. (B) Convertible seat installation
16E104±2
A convertible seat is used in forward±facing and
rear±facing positions depending on the age and size of
the child. When installing, follow the manufacturer's
instructions about the appropriate age and size of the
child as well as directions for installing a child restraint
system.

COMFORT ADJUSTMENT
176
16E101-1
CAUTION
Never put a rear±facing child restraint system in the
front seat because the force of the rapid inflation of
the passenger airbag can cause death or serious
injury to the child.

COMFORT ADJUSTMENT
177
16L146

Move seat fully back
A forward±facing child restraint system should
be put on the front seat only when it is
unavoidable. Always move the seat as far back
as possible, because the force of a deploying
airbag could cause death or serious injury to
the child. Do not allow the child to lean over the
front door or around the front door even if the
child is seated in a child restraint system. It is
dangerous if the side airbag inflates, and the
impact could cause death or serious injury to
the child.

COMFORT ADJUSTMENT
181
16E114±1
CAUTION
Push and pull the child restraint system in different
directions to be sure it is secure. Follow all the
installation instructions provided by its manufacturer.
16E115b

COMFORT ADJUSTMENT
184
CAUTION
A forward±facing child restraint system should be put
on the front seat only when it is unavoidable. Always
move the seat as far back as possible, because the
force of a deploying airbag could cause death or serious
injury to the child. Do not allow the child to lean over the
front door or around the front door even if the child is
seated in a child restraint system. It is dangerous if the
side airbag inflates, and the impact could cause death
or serious injury to the child.
16E116±2

COMFORT ADJUSTMENT
186
16E117b
2. To remove the child restraint system, press the
buckle±release button and allow the belt to retract.Top strap anchors and locations
16E032
If your child restraint system requires the use of a
top strap, latch the hook onto the anchor bracket
and tighten the top strap.
See the following instructions to install the anchor
bracket.

COMFORT ADJUSTMENT
188
16E034±1

1Bolt 2Anchor bracket 3Spacer
3. Insert a 15 mm (0.6 in.) spacer, and tighten down the
anchor bracket for your child restraint system with a bolt.
Torque the bolt to 16.5 ± 24.7 N´m (1.68 ±2.52 kgf´m,
12.2 ± 18.2 ft´lbf.).
To comply with Canadian Motor Vehicle Safety
Standards, this model sold in Canada is provided with a
bracket set in the glovebox, designed for use with any of
the 3 anchor locations shown in the illustration.
DRIVING POSITION MEMORY SYSTEM
The micro computer can memorize the position of the
driver's seat. Two different driving position profiles can
be entered into the computer's memory.
Recording a driving position in the computer's memory
can only be done when the ignition key is in the ºONº
position and the selector lever is in the ºPº position.
Setting a driving position
16E047