1999 Lexus ES300 warning

GAUGES, METERS AND SERVICE REMINDER INDICATORS
56

ºODO/TRIPº knob
This meter displays the odometer and two trip
meters. To change the mode indication, push the
ºODO/TRIPº knob briefly. Each time you push the
knob,
the mode changes in order from the odometer
to trip meter A to trip meter B, then back to the
odometer, etc.
The odometer records the total distance the vehicle
has been driven. The twin trip meter records two
different distances independently.
For example, you can use one meter to calculate the fuel
economy and the other to measure the distance on each
trip.
To set the A trip meter to zero, display the A meter
reading, push the knob and hold it. The same
applies for the B trip meter.
The data of trip meters will be cancelled if the electrical
power source is disconnected.
SERVICE REMINDER
INDICATORS AND WARNING BUZZERS
IF THIS INDICATOR
OR BUZZER COMES
ON ... DO THIS.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
58(n) Low fuel level Fill up tank.
warning light
(o) Key reminder buzzer Remove key.
(a) Brake System Warning Light
This light has the following two functions:
Parking brake reminder
If this light is on, make sure the parking brake is fully
released. The light should go off.
Low brake fluid level warning
If this light comes on and stays on while you are driving,
slow down and pull off the road. Then stop the vehicle
carefully. Remember that stopping distance and pedal
effort may be increased. There may be a problem
somewhere in the brake system. Check the fluid level
of the see±through reservoir.
To make sure the parking brake has not caused the
warning light to come on, check to see that the parking
brake is fully released.
If the brake fluid level is low ...
At a safe place, test your brakes by starting and
stopping.
 If you judge that the brakes still work adequately, drive
cautiously to your nearest dealer or shop for repairs.
 If the brakes are not working, have the vehicle towed
in for repairs. (For towing information, see page 337.)

GAUGES, METERS AND SERVICE REMINDER INDICATORS
60If the brake fluid level is correct ...
Have
the warning system checked by your Lexus dealer.
(b) Seat Belt Reminder Light and Buzzer
Once the ignition key is turned to ºONº or ºSTARTº, the
reminder light and buzzer come on if the driver's seat
belt is not fastened. Unless the driver fastens the belt,
the light stays on and the buzzer stops after about 4 to
8 seconds.
(c) SRS Warning Light
The indicator comes on when the ignition key is
turned to the ºACCº or ºONº position. It goes off
after about 6 seconds. This means the SRS is
operating properly.
The SRS warning light system monitors the airbag
sensor assemblies, front airbag sensors, inflators, seat
belt pretensioners, warning light, interconnecting wiring
and power sources.
If either of the following conditions occurs, this indicates
a malfunction somewhere in the parts monitored by the
warning light system. Contact your Lexus dealer as
soon as possible to service the vehicle.
The light does not come on as described above.
 The light stays on or flashes.
 The light comes on or starts flashing while driving.
If the light stays on, it indicates that the driver and front
passenger airbags fail. If the light flashes, the side
airbags and/or seat belt pretensioners fail.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
61
(d) Discharge Warning Light
This light warns that the battery is being discharged.
If it comes on while you are driving, stop the vehicle, turn
off the engine, and check for the cause. Look first at the
engine drive belt.
If it is loose or broken, the generator will not charge
the battery properly.
 If the belt is O.K., there is a problem somewhere in the
charging system.
The engine ignition will continue to operate, however,
until the battery is discharged. Turn off the air
conditioning, blower, radio, etc., and drive directly to the
nearest Lexus dealer or repair shop.
NOTICE
Do not continue driving if the engine drive belt is broken or loose.
(e) Low Oil Pressure Warning Light
This light warns that the engine oil pressure is too low.
If it flickers or stays on while you are driving, pull off the
road to a safe place and stop the engine immediately.
Call a Lexus dealer or qualified repair shop for
assistance.
The light may occasionally flicker when the engine is
idling or it may come on briefly after a hard stop. There
is no cause for concern if it then goes out when the
engine is accelerated slightly.
The light may come on when the oil level is extremely
low. It is not designed to indicate low oil level, and the
oil level must be checked using the oil level dipstick.
NOTICE
Do not drive the vehicle with the warning light on± even for one block. It may ruin the engine.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
62
(f) Low Engine Oil Level Warning Light
This light warns that the engine oil level is too low. Add
oil as soon as possible. (For instructions, see ºChecking
the engine oil levelº on page 378.)
While driving on steep inclines or rough roads which
causes the vehicle to substantially sway or on curves,
this light may come on due to the movement of engine
oil in the engine.
NOTICE
Continued engine operation with low engine oilwill damage the engine.
(g) Malfunction Indicator Lamp
This lamp comes on in the following cases.
a. The fuel tank is completely empty. (See ºFuel gaugeº
on page 50 for instructions.)
b. The fuel tank cap is not tightened securely. (See
ºFuel tank capº on page 100 for instructions.)
c. There is a problem somewhere in your engine or
automatic transmission electrical system.
If it comes on while you are driving in case ºc.º, have your
vehicle checked/repaired by your Lexus dealer as soon
as possible.
(h) ºABSº Warning Light
This light warns that there is a problem somewhere in
your anti±lock brake system.
If the light comes on while you are driving, have your
vehicle checked by your Lexus dealer as soon as
possible.
The light will come on when the ignition key is turned to
ºONº, and will go off after about a few seconds.
When the ºABSº warning light is on (and the brake
system warning light is off), the brake system operates
conventionally but anti±lock brake system is not
assisting brake performance so that the wheels could
lock up during a sudden brake or braking on slippery
road surfaces.
(i) Open Door Warning Light
This light remains on until all the doors are completely
closed.
(j) Rear Light Failure Warning Light
If this light comes on when the headlight switch is turned
on (at the first or second clickstop), it indicates that one
or more of the tail lights are burned out.
If it comes on when the brake pedal is depressed, one
or more stop lights are burned out.
Have defective bulbs replaced as soon as possible.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
63
(k) Vehicle Skid Control System WarningLights (Vehicles with Vehicle Skid
Control System only)
These lights warn that when there is a problem
somewhere in the vehicle skid control system or traction
control system.
If the ºVSCº warning light and ºVSC OFFº indicator light
come on, have your vehicle checked by Lexus dealer as
soon as possible.
The lights will come on when the ignition key is turned to
ºONº, and will go off after about a few seconds.
If the ºVSCº warning light and ºVSC OFFº indicator light
come on, the vehicle skid control system and traction
control system do not work. However, as conventional
braking operates when applied, there is no problem to
continue your driving.
(l) ºTRAC OFFº Indicator/Warning Light (Vehicles with Traction Control
System only)
This light comes on when the ignition key is turned to
ºONº, and will go off after a few seconds. This means
that the system is operating properly.
If the light comes on or flashes, this indicates a
malfunction in the traction control system. Contact your
Lexus dealer as soon as possible to service the vehicle.
(m) Low Washer Fluid Warning Light
This light comes on when the fluid level in the tank
becomes nearly empty. F ill the tank as soon as possible.
(n) Low Fuel Level Warning Light
This light comes on when the fuel level in the tank
becomes nearly empty. F ill the tank as soon as possible.
On inclines or curves, due to the movement of fuel in the
tank, the low fuel level warning light may come on earlier
than usual.
(o) Key Reminder Buzzer
This buzzer reminds you to remove the key when you
open the driver's door with the ignition key in the ºACCº
or ºLOCKº position.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
64
How to check all the service reminder
indicators
(except the low fuel level warning light):
1. Apply the parking brake.
2. Open the door.
The following service reminder indicator should come
on. It goes off when you close the door completely.
3. Turn the ignition key to ºACCº.
The following service reminder indicator should come
on. It goes off after 6 seconds.
4. Turn the ignition key to ºONº.
The following service reminder indicators should come
on.
or

or
w069

and
The following service reminder indicators go off after a
few seconds.
or

and
w069
5. Turn the ignition key to ºSTARTº.
The following service reminder indicators should come
on.

If any service reminder indicator or warning buzzer does
not function, either the bulb is burned out or circuit is in
need of repair. Have it checked by your Lexus dealer as
soon as possible.

INTERIOR EQUIPMENT
84Do not use the HomeLink
 universal transmitter with
any garage door opener that lacks the safety stop and
reverse feature as required by Federal Safety
Standards. This includes any garage door opener
model manufactured before April 1, 1982.
CAUTION
When programming or operating the garage door
opener, make sure there is no one around the moving
door. It is dangerous if someone is caught.
(b) Operating the garage door opener
Push the appropriate button to activate the garage door
opener. The indicator light comes on. The garage door
opener continues to send the signal for up to 20 seconds
as long as the button is pushed.
(c) Erasing the garage door opener memory
Push and hold down the 2 outside buttons for about 20
seconds until the indicator light flashes. All memorized
data will be erased. FCC ID: CB2V94800
CANADA: 1763 102 264
This device complies with FCC Rules part 15.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference that may be received,
including interference that may cause undesired
operation. WARNING: This transmitter has
been tested and complies with FCC and
DOC/MDC rules. Changes or modifications
not expressly approved by the partly
responsible for compliance could void the
user's authority to operate the device.