1999 LAND ROVER DEFENDER instrument panel

CONTENTS
01 INTRODUCTION
04 GENERAL SPECIFICATION DATA
05 ENGINE TUNING DATA
07 GENERAL FITTING REMINDERS
09 LUBRICANTS, FLUIDS AND CAPACITIES
10 MAINTENANCE
12 ENGINE
17 EMISSION CONTROL
18 ENGINE MANAGEMENT SYSTEM
19 FUEL SYSTEM
26 COOLING SYSTEM
30 MANIFOLD AND EXHAUST SYSTEM
33 CLUTCH
37 MANUAL GEARBOX
41 TRANSFER GEARBOX
47 PROPELLER SHAFTS
57 STEERING
60 FRONT SUSPENSION
64 REAR SUSPENSION
70 BRAKES
76 CHASSIS AND BODY
77 PANEL REPAIRS
82 AIR CONDITIONING
84 WIPERS AND WASHERS
86 ELECTRICAL
88 INSTRUMENTS
01
04
05
07
09
10
12
17
18
19
26
30
33
37
41
47
57
60
64
70
76
77
82
84
86
88
ProCarManuals.com

GENERAL SPECIFICATION DATA
9
INFORMATION BULBS
REPLACEMENT BULBS TYPE
Headlamps 12V 60/55W Halogen
Front side lamps 12V 5W
Side repeater lamps 12V 5W
Tail lamps 12V 21W
Cente High Mounted Stop Lamp 12V 21W
Direction indicator lamps 12V 21W
Number plate lamp 12V 4W
Reverse lamp 12V 21W
Rear fog guard lamp 12V 21W
Interior roof lamps 12V 10W
Instrument illumination 12V 1.2W
Warning light panel 12V 1.2W
Hazard warning switch 12V 1.2W
CAUTION: The fitting of new bulbs with wattages in excess of those specified will result in damage
to vehicle wiring and switches.
ProCarManuals.com

CHASSIS AND BODY
19
REPAIR LOWER FASCIA PANEL - UP TO 02MY
Service repair no - 76.46.05
Remove
1.Disconnect battery negative lead.
2.Remove steering wheel.See STEERING,
Repair.
3.Remove 7 screws securing nacelle to steering
column.
4.Remove 2 halves of nacelle from steering
column.
5.Remove instrument pack.See ELECTRICAL,
Repair.
6.Remove 3 screws securing heater control cable
assembly to end of fascia.
7.Release heater control cable assembly from
fascia and move aside.
8.Release HRW, Rear Fog Guard Lamp, and
Hazard Warning switches from fascia.
9.Disconnect multiplugs and Lucars from switches.
10.Collect switches.
11.Remove locking rings from both front speakers.
12.Remove 4 screws securing each speaker to
fascia.
13.Disconnect multiplugs from speakers and
remove both front speakers.
ProCarManuals.com

CHASSIS AND BODY
23
REPAIR 59.Fit radio housing to fascia and secure with trim
studs.
60.Position radio to fascia and connect multiplugs
and aerial.
61.Fit radio to fascia.
62.Fit crash pad to fascia and secure with screws.
63.Fit both demister vents to crash pad and secure
with screws.
64.Fit grab handle to fascia and secure with screws.
65.Fit Land Rover decal to grab handle.
66.Position both front speakers to fascia and
connect multiplugs.
67.Fit speakers to fascia and secure with screws.
68.Fit locking rings to speakers.
69.Connect multiplugs and Lucars to HRW, Rear
Fog Guard Lamp, and Hazard Warning
Switches.
70.Fit switches to fascia.
71.Position heater controls to fascia and secure
with screws.
72.Fit instrument pack.See ELECTRICAL,
Repair.
73.Fit 2 halves of nacelle to steering column and
secure with screws.
74.Fit steering wheel.See STEERING, Repair.
75.Reconnect battery negative lead.PANEL - MOUNTING - FRONT DOOR - FROM 02MY
Service repair no - 76.11.28
Remove
1.Remove plastic sheet.See this Section.
2.Lower glass and remove 2 bolts securing door
glass to regulator.
3.Release glass from regulator, raise and wedge
in raised position.
ProCarManuals.com

CHASSIS AND BODY
27
REPAIR FACIA CONSOLE - FROM 02MY
Service repair no - 76.25.03
Remove
1.Disconnect battery earth lead.See
ELECTRICAL, Repair.
2.Remove radio.See ELECTRICAL, Repair.
3.Remove 4 screws securing instrument pack and
release pack from fascia.
4.Disconnect 2 multiplugs from warning lamp
panel.
5.Disconnect instrument pack multiplug from main
harness.
6.Remove instrument pack.
7.Remove 3 screws securing heater control and
release control from fascia.
8.Carefully prise Land Rover decal from grab
handle.
9.Remove 2 screws securing grab handle and
remove handle.
10.Remove 4 screws and remove demister vents.
ProCarManuals.com

CHASSIS AND BODY
29
REPAIR 25.Position console and connect Lucar and
multiplug to cigar lighter.
26.Connect multiplugs to remaining switches.
27.Fit console and secure with screws.
28.Fit crash pad and secure with screws.
29.Fit demister vents and secure with screws.
30.Fit grab handle, secure with screws and fit Land
Rover decal.
31.Fit heater control to fascia and secure with
screws.
32.Position instrument pack and connect multiplugs.
33.Fit instrument pack to fascia and secure with
screws.
34.Fit radio.See ELECTRICAL, Repair.
35.Connect battery earth lead.See ELECTRICAL,
Repair.GLASS - REAR DOOR - FROM 02MY
Service repair no - 76.31.02
Remove
1.Remove rear door mounting panel.See this
Section.
2.Loosen 2 nuts and remove door check strap
torsion bar and plate.
3.Remove check strap.
4.Remove inner and outer waist seal.
5.Remove screw from each glass channel.
6.Lower glass to bottom of door, lift over lower
edge and withdraw from door.
ProCarManuals.com

WIPERS AND WASHERS
5
REPAIR
9.Remove cable ties securing washer tube to
windscreen wiper rack tube.
10.Loosen fully 4 nuts securing backplates to wheel
boxes and remove windscreen wiper rack tubes.
11.Remove seals from wheel box spindles.
12.Remove 2 nuts securing wheel boxes and
remove sealing washers.
13.Carefully pull fascia support rail from bulkhead
sufficiently to remove wheel boxes.
Refit
14.Loosen fully but do not remove nuts securing
wheel box back plates.
15.Grease wheel boxes.
16.Fit wheel boxes, fit sealing washers and tighten
nuts to5 Nm (3.7 lbf.ft).
17.Fit spindle seals.
18.Fit wiper rack tubes and tighten wheel box back
plate nuts sufficiently to hold tubes. Tighten
wheel box back plate nuts to6 Nm (4 lbf.ft)
after fitting windscreen wiper motor.
19.Align washer tube to rack tube and secure with
cable ties.
20.Align fascia support rail and secure with screws.
21.Fit steering column support bracket and tighten
bolt and nut and bolt to45 Nm (33 lbf.ft).
22.Fit demister duct to tube, align relay bracket and
secure duct with screws.
23.Position heater fan switch and secure with
screws.
24.Fit wiper motor and drive rack.See this
Section.
25.Fit steering column nacelle.See STEERING,
Repair.
26.Connect battery negative lead.See
ELECTRICAL, Repair.RELAY - WIPER DELAY - FROM 02MY
Service repair no - 84.15.37
Remove
1.Disconnect battery negative lead.See
ELECTRICAL, Repair.
2.Remove 4 screws securing instrument pack and
release pack from fascia.
3.Disconnect 2 multiplugs from warning lamp
panel.
4.Disconnect instrument pack multiplug from main
harness.
5.Remove instrument pack.
ProCarManuals.com

86ELECTRICAL
16
REPAIR LAMP ASSEMBLY - CENTRE HIGH MOUNTED
STOP LIGHT (CHMSL) - FROM 02MY
Service repair no - 86.41.32
Remove
1.Open rear door.
2.Remove 2 screws and cover from CHMSL.
3.Remove insulated cover from Lucar connector,
release catch’s and disconnect Lucar’s taking
care not to damage screen element.
4.Remove nuts securing lamp to rear screen,
withdraw lamp assembly, collect seals and
washers.
5.Remove rubber backing pad, taking care not to
damage screen obscuration band.
Refit
6.Clean obscuration band and fit new backing pad.
7.Fit lamp assembly, seals and washers. Fit nuts
and tighten to3 Nm (2.2 lbf.ft).
8.Insulate Lucar connector.
9.Connect Lucars to heated rear screen.
10.Fit cover to CHMSL and secure with screws.FLASHER UNIT - HAZARD WARNING - FROM
02MY
Service repair no - 86.55.12
Service repair no - 86.55.15
NOTE: This procedure also covers
removal of the Heated Front Screen Timer
Relay, 86.55.15.
Remove
1.Disconnect battery negative lead.See this
Section.
2.Remove 4 screws securing instrument pack and
release pack from fascia.
3.Disconnect 2 multiplugs from warning lamp
panel.
4.Disconnect instrument pack multiplug from main
harness.
5.Remove instrument pack.
ProCarManuals.com