1999 GMC C-SERIES reset

yellowblue
6-17
Engine Oil
(Caterpillar
Diesel Engines)
See your Caterpillar
Operation & Maintenance Manual
for information on oil quality and viscosities as well as
the temperature range chart.
Air Filter Restriction Indicator
Your engine has an indicator that lets you know when
the air filter is dirty and needs to be serviced. It is in the
air intake tube below the air cleaner on the passenger's
side of the engine.
When the yellow indicator
reaches the red ring in the
sight glass, it's time to
service the air filter.After the air filter is properly serviced, the indicator can
be reset by pushing the button on top of the indicator.
Engine Air Cleaner/Filter
Your GM Maintenance Schedule says when to replace
the air filter.
Gasoline Engine Caterpillar
Diesel
Engine
ProCarManuals.com

yellowblue
6-22
Surge Tank Pressure Cap
(Diesel Engines)
The surge tank pressure cap
must be tightly installed
with the arrows on the cap
lined up with the top tube of
the coolant surge tank.
When you replace your surge tank pressure cap, an
ACDelco

cap is recommended.
NOTICE:
Your surge tank pressure cap is a 9 psi (62kPa)
pressure
-type cap for use with medium duty
cooling systems only. It must be tightly installed
to prevent coolant loss and possible engine
damage from overheating. Be sure the arrows on
the cap line up with the top tube of the coolant
surge tank.
Thermostat
Engine coolant temperature is controlled by one or more
thermostats in the engine cooling system. The
thermostat stops the flow of coolant through the radiator
until the coolant reaches a preset temperature.
When you replace your thermostat, an ACDelco


thermostat is recommended for gasoline engines.
Caterpillar
parts are recommended for diesel engines.
ProCarManuals.com

yellowblue
6-29 What to Use
To determine what kind of fluid to use, see
ªRecommended Fluids and Lubricantsº in the Index.
NOTICE:
When adding power steering fluid or making a
complete fluid change, always use the proper
fluid. Failure to use the proper fluid can cause
leaks and damage hoses and seals.
If your power steering fluid level is low, this can
cause the PRIMARY BRAKE or AUX BRAKE
warning lights to come on. If either light remains
on after you have added power steering fluid to
the proper level, then shut off the engine for
10 seconds. This should reset the brake warning
lights. If one or both lights stay on, though,
then see ªHydraulic Brake Warning Lightsº in
the Index.
Windshield Washer Fluid
What to Use
When you need windshield washer fluid, be sure to read
the manufacturer's instructions before use. If you will be
operating your vehicle in an area where the temperature
may fall below freezing, use a fluid that has sufficient
protection against freezing.
Adding Washer Fluid
Open the cap labeled WASHER FLUID ONLY.
Add washer fluid until the tank is full.
ProCarManuals.com

yellowblue
6-51 When It's Time for New Tires
Replace your tires when the tread depth is down to
1/8 of an inch (3.2 mm) for the front tires, or 1/16 of
an inch (1.6 mm) for a rear tire. Also, you need a new
tire if:

You can see cord or fabric showing through the
tire's rubber.

The tread or sidewall is cracked, cut or snagged deep
enough to show cord or fabric.

The tire has a bump, bulge or split.

The tire has a puncture, cut or other damage that
can't be repaired well because of the size or location
of the damage.
CAUTION:
Mixing tires could cause you to lose control while
driving. If you mix tires of different types
-- like
radial and bias
-belted tires -- the vehicle may not
handle properly, and you could have a crash.
Be sure to use the same type of tires all around.
When you replace tires, make sure they are the same
size, load range, speed rating and construction type
(bias, bias
-belted or radial) as your original tires.
Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned at the
factory to give you the longest tire life and best
overall performance.
Proper front wheel alignment must be maintained in
order to ensure efficient steering, good directional
stability, and prevent abnormal tire wear. If you notice
unusual tire wear or your vehicle is pulling one way or
the other, the alignment may need to be reset. If you
notice your vehicle vibrating when driving on a smooth
road, your wheels may need to be balanced.
ProCarManuals.com

yellowblue
7-18 Footnotes

= The U.S. Environmental Protection Agency or the
California Air Resources Board has determined that the
failure to perform this maintenance item will not nullify
the emission warranty or limit recall liability prior to the
completion of the vehicle's useful life. We, however,
urge that all recommended maintenance services be
performed at the indicated intervals and the maintenance
be recorded.
(1) = If your vehicle has an Allison automatic
transmission, your GM Owner's Manual is
supplemented by an Allison Transmission Operator's
Manual. Always refer to these manuals for related
maintenance services.
(2) = Check the fluid level in the manual transmission.
(3) = An Emission Control Service.
(4) = A Noise Emission Control Device.
(5) = Applies only to vehicles sold in the United States.
(6) = Check fluid level in brake master cylinder, clutch
master cylinder (if equipped), power steering pump,
axle, transmission and hydraulic spring parking brake
pump (if equipped). A low fluid level in the brake
master cylinder can indicate worn brake linings and
should be checked accordingly.(7) = Inspect brake lines and hoses for proper hook
-up,
binding, leaks, cracks, chafing, etc. Inspect disc brake
pads for wear and rotors for surface condition. Check
brake pedal for excessive free play or travel (or every
6 months, whichever occurs first) and have serviced if
needed. Check brakes more often if driving habits and
conditions result in frequent braking.
(8) = Inspect hydraulic parking brake drum and linings
for wear or cracks and check linkage and adjustment.
Check spring brake actuator and pump for leaks.
Note: The spring brake section of the actuator is
non
-serviceable.
(9) = This vehicle has an Engine Oil Life Monitor. This
monitor will show you when to change the engine oil
and filter
-- usually between 3,000 miles (5 000 km) and
7,500 miles (12 500 km) since your last oil change.
Under severe conditions, the indicator may come on
before 3,000 miles (5 000 km). Never drive your vehicle
more than 7,500 miles (12 500 km) or 12 months
without an oil and filter change.
The system won't detect dust in the oil. So if you drive
in a dusty area, be sure to change your oil and filter
every 3,000 miles (5 000 km) or sooner if the Change
Oil Light comes on. Remember to reset the Oil Life
Monitor whenever the oil is changed. For more
information, see ªChange Oil Lightº in the Index.
ProCarManuals.com