1999 GMC C-SERIES check engine

yellowblue
2-59
Air Brake System Warning Light
Vehicles with air brake systems have one brake system
warning light on the instrument panel.
The LOW AIR warning
light should come on, as a
check, whenever you start
the engine.
However, it is designed to come on, and stay on, when
brake reservoir pressure has dropped below 60 to 70 psi
(410 to 480 kPa).When this warning light comes on, you will also hear a
warning tone. If the warning light and tone come on
while you are driving, you should drive only as far as
the nearest point of safety and then stop the vehicle.
Here's a very important thing for you to know:
CAUTION:
If the LOW AIR warning light comes on and the
warning tone sounds, the vehicle can stop
suddenly and without further warning. This is
because the parking brake will come on if the
pressure falls below 40 to 45 psi (275 to 310 kPa).
You or others could be injured. If the LOW AIR
warning light comes on and the warning tone
sounds, stop as soon as you can. You won't
know how quickly the system is losing pressure,
so be aware that the parking brake may come
on suddenly.
ProCarManuals.com

yellowblue
2-60 Apply Park Brake Warning Light (Option)
This light warns the driver
that the ignition has been
turned off without applying
the parking brake. The
warning light should come
on, as a check, when you
start the engine.
When it comes on, you will also hear a warning tone.
Leaving the vehicle in this condition could result in your
vehicle moving and will discharge the battery.
Parking Brake Warning Light
This light turns on as a
check when the engine is
first started and any time the
system needs adjustment or
there is a malfunction in the
electric/hydraulic parking
brake system.
When the SERVICE PARK BRAKE light comes on,
you will also hear a warning tone. If this light comes on,
have the system repaired immediately.
CAUTION:
If the SERVICE PARK BRAKE warning light
comes on and the warning tone sounds, your
vehicle can stop suddenly and without further
warning. You or others could be injured. If the
SERVICE PARK BRAKE warning light and the
warning tone come on, pull over to the side of the
road and apply the parking brake immediately.
Parking Brake Indicator Light
Vehicles with hydraulic or
air brakes have a parking
brake indicator light. When
the ignition is on, this light
will come on when you set
your parking brake.
The light will stay on if your parking brake doesn't
release fully.
This light should also come on when you turn the
ignition key to START. If it doesn't come on then, have
it fixed so it will be ready to remind you if the parking
brake is applied or hasn't released fully.
ProCarManuals.com

yellowblue
2-62 Low Coolant Warning Light
You have a LOW
COOLANT warning light.
If this light comes on,
your system is low on
coolant and the engine
may overheat.
The warning light should come on briefly, as a check,
when you turn on the ignition.
When it comes on, you will also hear a warning tone at
five beats per second for 10 seconds. See ªEngine
Coolantº in the Index and have your vehicle serviced as
soon as you can.
This light may also come on if your vehicle is equipped
with the optional automatic engine shutdown system and
engine shutdown has begun. SeeªEngine Automatic
Shutdownº in the Index.
Manual Fast Idle Indicator Light
(If Equipped)
If your vehicle is equipped
with an electronically
controlled diesel engine or
gasoline engine, you may
have this indicator light. It
is located next to the FAST
IDLE switch on the lower,
driver's side of the
instrument panel.
This light will illuminate whenever the manual FAST
IDLE feature is engaged. For more details about this
system, see ªFast Idle Systemº in the Index.
ProCarManuals.com

yellowblue
2-64 Service Trans Filter Indicator Light
(If Equipped)
If your vehicle has this
light, you'll find it
below the cluster on the
instrument panel.
It monitors the transmission fluid filter. If it ever
goes on, it means your transmission filter is dirty and
requires replacement.
Malfunction Indicator Lamp
(Check Engine Light)
If your vehicle is equipped
with either a gasoline
engine or an electronically
controlled diesel engine,
you will have this light.
If this light comes on or flashes while you are driving,
two things may happen.
First, you won't notice any difference in engine
performance, but your tail pipe emissions may increase.
Second, your engine may not run properly or may stall
without warning. If either of these things happen, drive
or tow your vehicle to your dealer for service.
ProCarManuals.com

yellowblue
2-65
This light should come on when the ignition is on, but
the engine is not running, as a check to show you it is
working. If it does not come on at all, have it repaired.
NOTICE:
If you keep driving your vehicle with this light
on, after a while, your emission controls may not
work as well, your fuel economy may not be as
good and your engine may not run as smoothly.
This could lead to costly repairs that may not be
covered by your warranty.
Engine Oil Pressure Gage
Gasoline Engine Diesel Engine
The engine oil pressure gage, on the lower right portion
of your instrument cluster, shows engine oil pressure
in psi (pounds per square inch) or in kPa (kilopascals).
Oil pressure may vary with outside temperature and oil
viscosity, but readings of 30 to 40 psi (205 to 275 kPa)
on gasoline engines at operating temperature and
moderate road speeds are normal. If you have a diesel
engine, the normal operating range should be between
35 and 70 psi (240 to 480 kPa).
ProCarManuals.com

yellowblue
2-66
A reading in the low pressure zone may be caused by a
dangerously low oil level or other problem.
If you have a Caterpillar

diesel engine, also see your
Caterpillar
Operation & Maintenance Manual.
CAUTION:
Don't keep driving if the oil pressure is low. If
you do, your engine can become so hot that it
catches fire. You or others could be burned.
Check your oil as soon as possible and have your
vehicle serviced.
NOTICE:
Damage to your engine from neglected oil
problems can be costly and is not covered by
your warranty.
Change Oil Light (If Equipped)
The CHANGE OIL light
should come on briefly as a
bulb check when you start
the engine. If the light
doesn't come on, have
it serviced.
If the CHANGE OIL light comes on and stays on after
you start the engine, have the oil changed.
For additional information, see ªEngine Oil, When to
Changeº in the Index. To reset the Oil Life Monitor, see
ªEngine Oil Life Monitorº in the Index.
ProCarManuals.com

yellowblue
2-67 Daytime Running Lamps (DRL)
Indicator Light
This light is located on the
upper cluster portion of the
instrument panel. It goes on
whenever the Daytime
Running Lamps are on. See
ªDaytime Running Lampsº
in the Index.
When it begins to get dark, the DRL indicator light is a
reminder to turn on your headlamps.
Check Gages Indicator Light (If Equipped)
This light will come on as
you're starting the engine,
just as a check.
If it ever comes on and stays on while you are driving,
however, it means that either your engine coolant
temperature gage or your engine oil pressure gage may
be showing a reading in the warning zone.
When the CHECK GAGES light comes on, you will
also hear a warning tone. The tone and the light will stay
activated until the problem is corrected.
This light may also come on if your vehicle is equipped
with the optional automatic engine shutdown system and
engine shutdown has begun. See ªEngine Automatic
Shutdownº in the Index.
ProCarManuals.com

yellowblue
3-5
OFF
Press this button to turn the air conditioning/heating
system off. Pressing OFF will erase the present mode of
operation from the system's memory. Outside air will
still come out of the heater outlet whenever the vehicle
is moving forward.
If the OFF button is pressed, you must press A/C,
MAX or one of the BLEND buttons to turn the system
back on.
Air Conditioning
When you first turn on your vehicle's air conditioning,
open the windows long enough to clear the vehicle of
hot air, then close them. Using the MAX button can also
help. See ªMAX Buttonº earlier in this section for
more information.
For normal cooling on hot days, use A/C with the
temperature selector toward C.
When you press the A/C button to turn the air
conditioner off, the system will operate in the vent
mode. When you turn the air conditioner back on, the
system will operate in the mode you last selected unless
the OFF button was pressed.If your air conditioner develops high system pressure, it
will automatically go into the MAX mode and REC will
light on your display. The A/C system will remain in the
MAX mode, even if you press the MAX button, until
system pressure returns to a normal level.
Heating
On cold days, use HEATER with the temperature
selector all the way toward H. When the inside of the
vehicle has reached a comfortable temperature, maintain
it by using the temperature selector bar.
If your vehicle is equipped with a diesel engine, and the
engine has been idling for a long time when it's cold
outside, your heater may blow out cool air. This is
normal. When you increase the engine speed under load,
your heater should blow out warmer air. If it doesn't,
your coolant level may be low. See ªEngine Coolantº in
the Index to check your coolant level.
While idling your diesel engine, you can use the MAX
button to recirculate the air in the cab to help maintain
interior heat. This will preserve engine coolant temperature
and cab heat when idling cannot be avoided.
Using the MAX button while driving is not recommended
because interior window fogging can result.
ProCarManuals.com