1999 FORD CONTOUR fuel cap

Instrumentation
11 The check engine indicator light
illuminates when the ignition is first
turned to the ON position to check
the bulb. If it comes on after the
engine is started, one of the
engineÕs emission control systems
may be malfunctioning. The light
may illuminate without a
driveability concern being noted.
The vehicle will usually be drivable
and will not require towing.
What you should do if the check
engine light illuminates
Light turns on solid:
This means that the OBD II system
has detected a malfunction.
Temporary malfunctions may cause
your check engine light to
illuminate. Examples are:
¥ The vehicle has run out of fuel.
(The engine may misfire or run
poorly)
¥ Poor fuel quality or water in the
fuel.
¥ The fuel cap may not have been
securely tightened.
12CInen 3/25/99 1:24 PM Page 11

Instrumentation
12These temporary malfunctions can
be corrected by filling the fuel tank
with good quality fuel and/or
properly tightening the fuel cap.
After three drive cycles without
these or any other temporary
malfunctions present, the check
engine light should turn off. (A
driving cycle consists of a cold
engine startup followed by mixed
city/highway driving.). No
additional vehicle service is
required.
If the check enginelight remains
on, have your vehicle serviced at
the first available opportunity.
Light is blinking:
Engine misfire is occuring which
could damage your catalytic
converter. You should drive in a
moderate fashion (avoid heavy
acceleration and deceleration) and
have your vehicle serviced at the
first available opportunity.
Under engine misfire
conditions, excessive
exhaust temperatures could
damage the catalytic converter,
the fuel system, interior floor
coverings or other vehicle com-
ponents, possibly causing a fire.
12CInen 3/25/99 1:24 PM Page 12

Maintenance and care
190
Automotive fuels can cause
serious injury or death if
misused or mishandled.
IMPORTANT FUEL
INFORMATON
Important safety precautions
Do not overfill the fuel tank.
The pressure in an overfilled
tank may cause leakage and lead
to fuel spray and fire.
If you do not use the proper
fuel cap, the pressure in the
fuel tank can damage the fuel
system or cause it to work
improperly in a collision.
The fuel system may be
under pressure. If the fuel
cap is venting vapor or if you hear
a hissing sound, wait until it stops
before completely removing the
cap.
31CMCen 3/25/99 3:45 PM Page 190

Maintenance and care
191
Observe the following guidelines
when handling automotive fuel:
¥ Extinguish all smoking materials
and any open flames before fueling
your vehicle.
¥ Always turn off the vehicle before
fueling.
¥ Make sure the fuel cap is
correctly fitted after fueling. Failure
to do so may cause the on board
diagnostic system to illuminate the
CHECK ENGINE light.
¥ Automotive fuels can be harmful
or fatal if swallowed. If fuel is
swallowed, call a physician
immediately, even if no symptoms
are immediately apparent. The
toxic effects of fuel may not be
visible for hours.
¥ Fuels can also be harmful if
absorbed through the skin. If fuel is
splashed on the skin, promptly
remove contaminated clothing and
wash skin thoroughly with soap and
water.
¥ If fuel is splashed in the eyes,
remove contact lenses (if worn),
flush with water for 15 minutes and
seek medical attention.
¥ Be particularly careful if you are
taking ÒAntabuseÓ or other forms of
disulfiram for the treatment of
alcoholism. Breathing gasoline
vapors or skin contact could cause
an adverse reaction. Consult a
physician immediately.
31CMCen 3/25/99 3:45 PM Page 191

Maintenance and care
194
The fuel system may be
under pressure. If the fuel
filler cap is venting vapor or if you
hear a hissing sound, wait until it
stops before completely removing
the fuel filler cap. Otherwise fuel
may spray out and injure you or
others.
Fuel filler cap
If the Òcheck engineÓ indicator
comes on and stays on when you
start the engine, the fuel filler cap
may not be properly installed. Turn
off the engine, remove the fuel
filler cap and reinstall it being
careful to align the cap properly.
If you must replace the fuel
filler cap, replace it with an
authorized Motorcraft part.
The customer warranty may be
void for any damage to the fuel
tank or fuel system if an
authorized Motorcraft fuel
filler cap is not used.
Cleaner air
Ford approves the use of gasolines
to improve air quality, including
reformulated gasolines that contain
oxygenates such as a maximum of
10% ethanol or 15% MTBE. There
should be no more than 5%
methanol with cosolvents and
additives to protect the fuel
system.
31CMCen 3/25/99 3:45 PM Page 194

217
Capacities and specifications
* Refer to Vehicle Emission Control Information (VECI) decal for spark plug and gap specifications.
** If a spark plug is removed for examination, it must be reinstalled in the same cylinder.
If a spark plug needs to be replaced, use only spark plugs with the service part number suffix
letter ÒFEÓ as shown on the engine decal.
Motorcraft parts
Component
Spark plug*
Air filter
Passenger compartment
air filter
Fuel filter
Oil filter
Battery
PCV valve
Crankcase ventilation
filter
2.0 litre engine
AZFS-22F # 1+2**
AZFS-22FE# 3+4
FA-1612
FP4
FG-800A
FL-2005
BXT-40R
EV-224
FA-1621
2.5 litre engine
AWSF-32F
FA-1613
FP4
FG-800A
FL-820
BXT-40R
EV-152
Ñ
Part number
32CCSen 3/25/99 3:50 PM Page 217

Capacities and specifications
218
* Total capacity
** with automatic transaxle
Engine oil
- with filter
- without
Manual transaxle1.9 l (2.0 qts)
Automatic transaxle
with oil cooler
Power steering
Cooling system with heating
Windshield washer fluid
Fuel tank
Braking system
4.25 l (4.5 qts)
3.75 l (4.0 qts)
8.5 l (9.0 qts.)
6.6 l (7.0 qts)*
7.1 l (7.5 qts)**
Fill to MAX mark
Fill to top of reservoir
58.5 l (15.4 gallons)
Fill to MAX mark
5.5 l (5.8 qts)
5.0 l (5.3 qts)
9.6 l (10.2 qts)
9.5 l (10.0 qts)*
9.7 l (10.2 qts)**
Capacities2.0 litre
engine2.5 litre
engine
32CCSen 3/25/99 3:50 PM Page 218

Capacities and specifications
220Engine data
* Mechanical valve adjuster
2.0 litre
Engine2.5 litre
Engine
1988 2544
96 (125)
5500125 (170)
6250
176 (130)
4000220 (162)
4250
61506700
6375 6925
800±50
(880±50)725±50
(725±50)
1-3-4-2 1-4-2-5-3-6
1.3
Electronically controlled Idle speed
(manual transaxle)Engine
cm
3Capacity
kW (HP)
at rpm Power output
Nm (lb-ft)
at rpm Max. torque
Fuel required87 Octane
rpm Continuous engine
speed
rpm Max. intermittent
engine speed
rpm
Mixture preparation
Injection system
Firing order
mm
Spark plug gap
Ignition system
0.14 mm
0.30 mm Valve Inlet
clearances ExhaustHydraulic valve
adjusters 0.11-0.18*
0.27-0.34*
32CCSen 3/25/99 3:50 PM Page 220