HEA TE R S YSTE M
1999 D odge P ic ku p R 1500
1999 HEATER SYSTEMS
RWD Trucks & Vans
CHRYSLER
Dakota, Durango, Ram Pickup, Ram Van/Wagon
DESCRIPTION
All models use a blend-air system. Outside air enters heater
through cowl opening and passes through a plenum chamber to heater
core. Blend air door in heater housing controls temperature by either
directing air through or around heater core. Air flow is then directed
through dash panel to air distribution duct in passenger compartment.
On Durango, air taken from the front heater system is fed
back through an air duct into the center console. At the rear of the
center console, passengers can operate a 3 mode switch to adjust air
flow. Temperature and blower speeds are controlled by the front heater
control panel.
WARNING: To avoid injury from accidental air bag deployment, read and
carefully follow all SERVICE PRECAUTIONS and DISABLING &
ACTIVATING AIR BAG SYSTEM procedures in AIR BAG SYSTEM SAFETY
article.
OPERATION
HEATER CONTROL PANEL
Blower Motor Switch
Fan speed is controlled with a rotary blower motor switch.
There are 4 different fan speed settings: one low speed, 2 medium
speeds, and one high speed.
Mode Control Knob
A rotary mode switch is used to control air flow. There are 5
different modes of operation: panel, floor/panel, floor,
floor/defrost, and defrost.
Temperature Control Knob
Rotary control knob determines discharge air temperature by
positioning blend/air door. On Dakota and Durango, temperature blend-
air door is cable operated. On Ram Pickup and Ram Van/Wagon,
temperature blend-air door is electrically operated. When a hot
temperature is selected, all air flows through heater core.
ADJUSTMENTS
TEMPERATURE CONTROL CABLE ADJUSTMENT
Dakota & Durango
1) Ensure temperature control cable housing and core are
connected at both heater control panel and heater assembly. Ensure
heater control panel is properly installed.
2) Rotate temperature control knob so that knob pointer is at
12 o'clock position. Pull temperature control knob straight out from
heater control panel until perimeter of knob (not knob pointer)
protrudes about .25" (6 mm) from face of heater control panel.
3) Rotate temperature control knob clockwise so that knob
