1999 CHEVROLET C/K engine

yellowblue
4-50 If You Do Decide To Pull A Trailer
If you do, here are some important points:

There are many different laws, including speed limit
restrictions, having to do with trailering. Make sure
your rig will be legal, not only where you live but
also where you'll be driving. A good source for this
information can be state or provincial police.

Consider using a sway control if your trailer will
weigh less than the capacity stamped on your step
bumper. You should always use a sway control if
your trailer will weigh more than the capacity
stamped on your step bumper. You can ask a hitch
dealer about sway controls.

Don't tow a trailer at all during the first 500 miles
(800 km) your new vehicle is driven. Your engine,
axle or other parts could be damaged.

Then, during the first 500 miles (800 km) that you
tow a trailer, don't drive over 50 mph (80 km/h) and
don't make starts at full throttle. This helps your
engine and other parts of your vehicle wear in at the
heavier loads.
If you have an automatic transmission, you can tow
in OVERDRIVE (
). You may want to shift the
transmission to THIRD (3) or, if necessary, a lower
gear selection if the transmission shifts too often
(e.g., under heavy loads and/or hilly conditions).
If you have a manual transmission and you are
towing a trailer, it's better not to use FIFTH (5) gear.
Just drive in FOURTH (4) gear (or, as you need to, a
lower gear).
Three important considerations have to do with weight:

the weight of the trailer,

the weight of the trailer tongue

and the weight on your vehicle's tires.
Weight of the Trailer
How heavy can a trailer safely be?
It depends on how you plan to use your rig. For
example, speed, altitude, road grades, outside
temperature and how much your vehicle is used to pull a
trailer are all important. And, it can also depend on any
special equipment that you have on your vehicle.

yellowblue
4-51
Use one of the following charts to determine how much
your vehicle can weigh, based upon your vehicle model
and options.
Maximum trailer weight is calculated assuming the
driver and one passenger are in the tow vehicle and it
has all the required trailering equipment. The weight of
additional optional equipment, passengers and cargo in
the tow vehicle must be subtracted from the maximum
trailer weight.
Above the 2,000 lbs. (908 kg) trailer rating, the engine
oil cooler is required on C/K
-2500 models with gas
engines. Refer to the Trailering Guide for oil cooler
recommendations.C
-1500 (2WD)
Engine (Trans.) Axle Ratio Max. Trailer Wt.
5.0L 3.08 4,500 lbs. (2 043 kg)
3.42 5,500 lbs. (2 497 kg)
3.73 6,500 lbs. (2 951 kg)
5.7L 3.08 5,000 lbs. (2 270 kg)
3.42 6,000 lbs. (2 724 kg)
3.73 7,000 lbs. (3 178 kg)
K
-1500 (4WD)
Engine (Trans.) Axle Ratio Max. Trailer Wt.
5.0L 3.42 5,000 lbs. (2 270 kg)
3.73 6,000 lbs. (2 724 kg)
5.7L 3.42 5,500 lbs. (2 497 kg)
3.73 6,500 lbs. (2 951 kg)
6.5L Diesel 3.42 6,000 lbs. (2 724 kg)
3.73 7,000 lbs. (3 178 kg)

yellowblue
4-52
C-2500 (2WD)
Engine (Trans.) Axle Ratio Max. Trailer Wt.
5.7L 3.42 6,000 lbs. (2 724 kg)
3.73 7,000 lbs. (3 178 kg)
4.10 8,000 lbs. (3 632 kg)
6.5L Diesel 3.42 6,500 lbs. (2 951 kg)
3.73 7,500 lbs. (3 405 kg)
4.10 8,500 lbs. (3 859 kg)
7.4L 3.73 9,000 lbs. (4 086 kg)
4.10 11,000 lbs.* (4 994 kg)
*Fifth
-wheel hitch rating; weight-distributing hitch
rating is limited to 10,000 lbs. (4 540 kg).K
-2500 (4WD)
Engine (Trans.) Axle Ratio Max. Trailer Wt.
5.7L 3.73 6,000 lbs. (2 724 kg)
4.10 7,500 lbs. (3 405 kg)
6.5L Diesel 3.73 6,500 lbs. (2 951 kg)
4.10 8,000 lbs. (3 632 kg)
7.4L 3.73 8,500 lbs. (3 859 kg)
4.10 10,500 lbs.* (4 767 kg)
*Fifth
-wheel hitch rating; weight-distributing hitch
rating is limited to 10,000 lbs. (4 540 kg).

yellowblue
4-53
C-3500 (2WD)
Engine (Trans.) Axle Ratio Max. Trailer Wt.
5.7L 4.10 7,500 lbs. (3 405 kg)
4.56 9,000 lbs. (4 086 kg)
6.5L Diesel 4.10 8,000 lbs. (3 632 kg)
7.4L 4.10 10,500 lbs.* (4 767 kg)
4.56 12,500 lbs.* (5 675 kg)
*Fifth
-wheel hitch rating; weight-distributing hitch
rating is limited to 10,000 lbs. (4 540 kg).
K
-3500 (4WD)
Engine (Trans.) Axle Ratio Max. Trailer Wt.
5.7L 4.10 7,000 lbs. (3 178 kg)
6.5L Diesel 4.10 7,500 lbs. (3 405 kg)
7.4L 4.10 10,000 lbs. (4 540 kg)
4.56 12,000 lbs.* (5 448 kg)
*Fifth
-wheel hitch rating; weight-distributing hitch
rating is limited to 10,000 lbs. (4 540 kg).C
-3500 Crew Cab (2WD)
Engine (Trans.) Axle Ratio Max. Trailer Wt.
5.7L 4.10 7,000 lbs. (3 178 kg)
4.56 8,500 lbs. (3 859 kg)
6.5L Diesel 4.10 8,000 lbs. (3 632 kg)
7.4L 4.10 10,500 lbs.* (4 767 kg)
4.56 12,500 lbs.* (5 675 kg)
*Fifth
-wheel hitch rating; weight-distributing hitch
rating is limited to 10,000 lbs. (4 540 kg).
K
-3500 Crew Cab (4WD)
Engine (Trans.) Axle Ratio Max. Trailer Wt.
5.7L 4.10 6,500 lbs. (2 951 kg)
4.56 8,000 lbs. (3 632 kg)
6.5L Diesel 4.10 7,500 lbs. (3 405 kg)
7.4L 4.10 10,000 lbs.* (4 540 kg)
4.56 12,000 lbs.* (5 448 kg)
*Fifth
-wheel hitch rating; weight-distributing hitch
rating is limited to 10,000 lbs. (4 540 kg).

yellowblue
4-54
C-3500 HD Chassis Cab
Engine (Trans.) Axle Ratio Max. Trailer Wt.
6.5L Diesel
(Auto.)4.63 9,000 lbs. (4 086 kg)
5.13 10,000 lbs.* (4 540 kg)
7.4L 4.63 12,000 lbs.* (5 448 kg)
5.13 12,000 lbs.* (5 448 kg)
*Fifth
-wheel hitch rating; weight-distributing hitch
rating is limited to 10,000 lbs. (4 540 kg).
You can ask your dealer for our trailering information or
advice, or you can write us at the address listed in your
Warranty and Owner Assistance Information Booklet.
In Canada, write to:
General Motors of Canada Limited
Customer Communication Centre
1908 Colonel Sam Drive
Oshawa, Ontario L1H 8P7
Weight of the Trailer Tongue
The tongue load (A) of any trailer is an important
weight to measure because it affects the total or gross
weight of your vehicle. The Gross Vehicle Weight
(GVW) includes the curb weight of the vehicle, any
cargo you may carry in it, and the people who will be
riding in the vehicle. And if you will tow a trailer, you
must add the tongue load to the GVW because your
vehicle will be carrying that weight, too. See ªLoading
Your Vehicleº in the Index for more information about
your vehicle's maximum load capacity.

yellowblue
4-58 Driving On Grades
Reduce speed and shift to a lower gear before you start
down a long or steep downgrade. If you don't shift
down, you might have to use your brakes so much that
they would get hot and no longer work well.
If you have an automatic transmission, you can tow in
AUTOMATIC OVERDRIVE (
). You may want to
shift the transmission to THIRD (3) or, if necessary, a
lower gear selection if the transmission shifts too often
(e.g., under heavy loads and/or hilly conditions).
If you have a manual transmission and you are towing a
trailer, it's better not to use FIFTH (5) gear. Just drive in
FOURTH (4) gear (or, as you need to, a lower gear).
When towing at high altitude on steep uphill grades,
consider the following: Engine coolant will boil at a
lower temperature than at normal altitudes. If you turn
your engine off immediately after towing at high altitude
on steep uphill grades, your vehicle may show signs
similar to engine overheating. To avoid this, let the
engine run while parked (preferably on level ground)
with the automatic transmission in PARK (P) (or the
manual transmission out of gear and the parking brake
applied) for a few minutes before turning the engine off.
If you do get the overheat warning, see ªEngine
Overheatingº in the Index.
Parking on Hills
CAUTION:
You really should not park your vehicle, with a
trailer attached, on a hill. If something goes
wrong, your rig could start to move. People can
be injured, and both your vehicle and the trailer
can be damaged.
But if you ever have to park your rig on a hill, here's
how to do it:
1. Apply your regular brakes, but don't shift into
PARK (P) yet for an automatic transmission, or into
gear for a manual transmission.
2. Have someone place chocks under the trailer wheels.
3. When the wheel chocks are in place, release the
regular brakes until the chocks absorb the load.
4. Reapply the regular brakes. Then apply your
parking brake and shift into PARK (P) for an
automatic transmission, or REVERSE (R) for a
manual transmission.

yellowblue
4-59
5. If you have a four-wheel-drive vehicle, be sure
the transfer case is in a drive gear and not in
NEUTRAL (N).
6. Release the regular brakes.
CAUTION:
It can be dangerous to get out of your vehicle if
the shift lever is not fully in PARK (P) with the
parking brake firmly set. Your vehicle can roll.
If you have left the engine running, the vehicle
can move suddenly. You or others could be
injured. To be sure your vehicle won't move, even
when you're on fairly level ground, use the steps
that follow.
Always put the shift lever fully in PARK (P) with
the parking brake firmly set.
If the transfer case on four-wheel drive vehicles is
in NEUTRAL (N), your vehicle will be free to
roll, even if your shift lever is in PARK (P). So, be
sure the transfer case is in a drive gear
-- not in
NEUTRAL (N).
When You Are Ready to Leave After
Parking on a Hill
1. Apply your regular brakes and hold the pedal down
while you:

Start your engine;

Shift into a gear; and

Release the parking brake.
2. Let up on the brake pedal.
3. Drive slowly until the trailer is clear of the chocks.
4. Stop and have someone pick up and store the chocks.
Maintenance When Trailer Towing
Your vehicle will need service more often when you're
pulling a trailer. See the Maintenance Schedule for more
on this. Things that are especially important in trailer
operation are automatic transmission fluid (don't
overfill), engine oil, axle lubricant, belt, cooling system
and brake system. Each of these is covered in this
manual, and the Index will help you find them quickly.
If you're trailering, it's a good idea to review these
sections before you start your trip.
Check periodically to see that all hitch nuts and bolts
are tight.

yellowblue
4-63 Using a Transfer Case Mounted Power
Take-Off (Automatic Transmission)
1. Set the parking brake.
2. Turn the ignition off.
3. Shift the transfer case into NEUTRAL (N).
4. Shift the transmission into NEUTRAL (N).
5. Engage the PTO.
If you are going to drive the vehicle, shift the
transfer case into the range you want. Turn the
ignition to START. Then apply the regular brakes
and release the parking brake.
6. Shift the transmission to THIRD (3) to start the PTO.
7. Release the regular brakes to drive the vehicle.
Disengaging a Power Take-Off
1. Turn the ignition off.
2. Put the transmission in PARK (P).
3. Release the PTO
4. Restart the engine.
Step-Bumper Pad
If your vehicle has a rear step bumper, it may
be equipped with a rear step pad at the center of
the bumper.
If you will be using the
bumper to tow a trailer, you
must remove the center
cutout circle to install the
trailer ball. You must
also remove both outer
cutouts to attach the
trailer safety chains.
To remove the pad, lift the
edge of the pad from the
rear of the bumper and
swing it forward. When the
pad releases from the
bumper holes, lift the
pad off.