1999 AUDI A8 fuel

24-12


Note:
In order to assure sufficiently secure fitting, switches must not be installed
more than once.
Adjusting switch:
Repair Manual, Brake System, ABS, ABS/EDL, Repair Group 46
Fig. 9 Component location Brake Light Switch -F- and Brake
Vacuum Vent Valve Switch For Cruise Control/Diesel Fuel
Injection, Clutch Vacuum Vent Valve Switch -F36-
1 - Clip
2 - Brake Light Switch -F-, Brake Vacuum Vent Valve Switch For Cruise
Control/Diesel Fuel Injection -F47-
3 - Clutch vacuum vent valve switch -F36-

Secondary Air Injection (AIR) Pump Relay -J299- (arrow) in 3-pin relay
carrier in E-box, plenum chamber. Fig. 10 Component location for Secondary Air Injection (AIR)
Pump Relay -J299-
Pa
ge 14 of 78 Motronic in
jection s
ystem, servicin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.1

24-13


Fuel Pump (FP) Relay -J17- is located at position 4 of central electrics in
driver's footwell, left. Fig. 11 Component locations Fuel Pump (FP) Relay -J17-

Data Link Connector (DLC) in knee bolster on driver's side. Fig. 12 Component location of Data Link Connector (DLC)
Pa
ge 15 of 78 Motronic in
jection s
ystem, servicin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.1

24-30

Fuel pressure regulator and residual
pressure, checking


Note:
Fuel pressure regulator regulates fuel pressure
according to intake manifold pressure. This
ensures that the pressure drop at the fuel
injectors remains the same for each speed and
load range of the engine.

Special Tools and Equipment

Test requirements:
Repair Manual, Fuel Supply System, Repair Group 20; Fuel supply Front Wheel Drive or fuel supply
- All Wheel Drive

VAG 1318 with VAG 1318/7 adapter, VAG 1318/8 pressure hose with
connectors and VAG 1318/15 adapter Fuel Pump (FP) OK, checking Page 24
-49
.
Fuel Pump (FP) OK, checking: Fuel filter OK Battery voltage at least 12.7 V Vehicles with automatic transmission Selector lever in P or N.
Pa
ge 35 of 78 Motronic in
jection s
ystem, servicin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.1

24-31

WARNING!

Fuel system is under pressure! Place a cloth
around the connection point before opening
system. Then release pressure by carefully
loosening connection point.

Checking system pressure - Remove engine cover (arrows).

Note:
If fuel should escape at the vacuum connection of the pressure regulator
during the following pressure test, replace pressure regulator. - Connect VAG1318 pressure gauge using adapters
VAG1318/7, /1318/8 pressure hose with connectors and 1318/15
adapter in supply line.
- Disconnect vacuum hose from pressure regulator to intake manifold at
pressure regulator and seal line.
- Start engine and let run at idle.
Pa
ge 36 of 78 Motronic in
jection s
ystem, servicin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.1

24-32

- Measure fuel pressure.


Specification: 3.8 to 4.2 bar

- If the specified value is not reached, replace
pressure regulator on a trial basis and repeat
pressure test.

- If the specified value is not reached again, check
Fuel Pump (FP) or supply line for damage (e.g.
pinched areas) and replace if necessary.

- If the specified value is exceeded, check return
line for damage (e.g. pinched areas) and replace
if necessary.

Note:
During the following test, the engine must not run
for an unnecessarily long period of time with the
vacuum hose removed. Otherwise, the higher
fuel pressure can cause enrichment of the fuel to
air ratio, which under some circumstances can
cause the oxygen sensor control limits to be
exceeded, causing a DTC to be stored.

- Start engine and let run at idle.

-
Switch of electrical consumers (A/C system
Pa
ge 37 of 78 Motronic in
jection s
ystem, servicin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.1

24-33

- Fuel pressure must drop by approx. 0.5 bar
when connecting the vacuum hose.

If the pressure change does not occur, the
following tests must be performed:


Check vacuum hose for tears and
damage.

Check vacuum hose at intake manifold for
throughput by disconnecting from pressure
regulator and blowing into it.

- If no leaks can be detected and if the vacuum
hose has throughput, replace the pressure
regulator.

Checking residual pressure

- Residual pressure 10 minutes after switching
engine off (minimum pressure).

Specified value with a cold engine: approx.
2.2 bar

Specified value with the engine at operating
temperature: approx. 3.0 bar
Pa
ge 39 of 78 Motronic in
jection s
ystem, servicin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.1

Note:
Pressure increase for an engine at operating
temperature limited by the fuel expansion is
normal.
Pa
ge 40 of 78 Motronic in
jection s
ystem, servicin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.1

24-34

- Start engine and let run at idle.

The following malfunction are possible if the pressure does not drop:
Repair Manual, Fuel Supply System, Repair Group 20; Fuel supply
-
Front Wheel Drive or fuel supply
- All Wheel Drive

Note:
Pressure gauge displays the pressure behind the stopcock "intake
manifold side" after the stopcock is closed (in direction of fuel injector, fuel
pressure regulator). If the pressure drops in front of the stopcock (in
direction of fuel tank), the device cannot detect it. For this reason, the
center of this page states "If the pressure does not drop...". - Wait until pressure has dropped, and then switch off ignition.
Simultaneously close shut-off valve of VAG1318 pressure gauge (lever
perpendicular to direction of flow -arrow-).
There is a leak in the threaded connection between the pressure
gauge and the fuel supply line There is a leak at the supply line at fuel tank.There is a leak in the check valve in the Fuel Pump (FP).
Pa
ge 41 of 78 Motronic in
jection s
ystem, servicin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.1