1999 AUDI A6 battery

28-38

- Connect multimeter for voltage measurement as
follows:

VAG1598/31 test box
Socket
Measure to
1 B+
2 B+
62 Engine Ground (GND)


Specification: approx. battery voltage

- Connect multimeter for voltage measurement as
follows:

VAG1598/31 test box
Socket
Measure to
3 Engine Ground (GND)

- Switch ignition on.


Specification: approx. battery voltage
If specified values are not obtained:
Pa
ge 40 of 59 I
gnition s
ystem, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.28.1

28-39

- Connect multimeter for voltage measurement as
follows:

VAG1598/31 test box
Socket
Measure to
121
1)

Engine Ground (GND)

1) The motronic Engine Control Module (ECM)
power supply relay -J271- continues to direct
current to terminal 121 of the Engine Control
Module (ECM) for up to 15 minutes after ignition
is switched off.

- Switch ignition on.


Specification: approx. battery voltage
If specified value is not obtained:

- Check wire connections.

Electrical Wiring Diagrams, Troubleshooting &
Component Locations

-
Check motronic Engine Control Module (ECM)
Pa
ge 42 of 59 I
gnition s
ystem, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.28.1

28-48
If LED does not blink:

Checking voltage supply

- Disconnect connector at Camshaft Position
(CMP) sensor.

Checking signal wire - Connect multimeter for voltage measurement as follows:Harness connector
Terminal
Measure to
1 Engine Ground (GND)
- Switch ignition on.

Specification: about 5 V
- Connect multimeter for voltage measurement as follows:
Harness connector
Terminal
Measure to
2 Engine Ground (GND)
- Switch ignition on.

Specification: approx. battery voltage
Pa
ge 52 of 59 I
gnition s
ystem, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.28.1