30-39
Repair Manual, 2.7 Liter V6 5V BiTurbo Engine
Mechanical, Engine Code(s): APB, Repair Group 13
2 -
Bolt
Vehicles with dual-mass flywheel: tighten
bolt to 60 Nm, then turn a further 180 Always replace
3 -
Clutch plate
Install with spring pack (coil springs) or the
word "Getriebeseite" towards pressure
plate and transmission Centering Page 30
-45
Do not greaseClutch plate diameter from Page 00
-3
Pa
ge 4 of 10 Clutch, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.3
30-45
Removing and installing clutch with SAC pressure plate
Note:
The adjuster ring in the SAC pressure plate has to be reset ( Page 30
-42
) before assembly when replacing the clutch plate on its own.
Clutch lining and contact surface of pressure plate must make full
contact with flywheel before securing bolts are inserted. To avoid damaging centering holes in pressure plate and centering
pins on flywheel, tighten securing bolts evenly and in several stages in
diagonal sequence.
- Position of clutch plate: spring pack (coil springs) or marking
"Getriebeseite" towards pressure plate and transmission.
- Loosen and tighten bolts gradually in diagonal sequence and in several
stages to 22 Nm.
- Reverse position of counter-hold tool 10-201 when removing.
- Use mandrel 3176 to center clutch plate.
Pa
ge 10 of 10 Clutch, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.3
