Page 33 of 37
44-34
Extending the springs (standard, sport and
heavy duty (1BP) suspensions
CAUTION!
Make sure that the wheels do not lose
contact with the turntables during the lifting
operation.
If wheels do lose contact, do not move the
turntables. Otherwise incorrect
measurements will result.
- Raise vehicle at front jacking points.
Vehicle is now in position B2 page 44
-27
- Lift cylinders out of threaded spindles and secure in position using
locking pins.
- Make sure locking pins (arrows) are correctly positioned.
- Lower vehicle down onto spacer gauge.
Pa
ge 33 of 37 Wheel ali
gnment
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.44.2
Page 34 of 37
44-35
Extending the springs (heavy duty
suspension (1BB)
CAUTION!
Make sure that the wheels do not lose
contact with the turntables during the lifting
operation.
If wheels do lose contact, do not move the
turntables. Otherwise incorrect
measurements will result.
- Raise vehicle at front jacking points.
Vehicle is now in position B2 page 44
-27
- Lift cylinders out of threaded spindles and secure in position using
locking pins.
- Make sure locking pins (arrows) are correctly positioned.
- Remove VAG1925/6 adapter.
- Lower vehicle down onto spacer gauge.
Pa
ge 34 of 37 Wheel ali
gnment
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.44.2
Page 37 of 37
44-38
Front axle toe-in, setting
- Loosen lock nut -B-.
Make sure that the boots are not twisted after turning the tie rods
Note:
Twisted boots will wear out quickly.
After tightening lock nut -B- it is possible that the toe value may deviate
slightly.
If the measured toe lies within the tolerances, the adjustment is correct. - Adjust toe on left and right at hex -A-.
- Tighten lock nut -B- and check toe-in again.
Tightening torque: 40 Nm (30 ft lb)
Pa
ge 37 of 37 Wheel ali
gnment
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.44.2
