28-11
Checking voltage supply to ignition coils
Note:
Voltage is supplied to ignition coils via Fuel
Pump (FP) relay.
Test requirement:
Fuse for ignition coils OK
Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder
If LED does not light up: - Connect VAG1527B voltage tester as follows:Harness connector
Terminal
Measure to
1 Engine Ground (GND)
- Operate starter.
LED must light up.
- Check the wire connection for open circuit:
Pa
ge 13 of 65 I
gnition s
ystem, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.28.1
28-31
Test requirements:
Fuse for Engine Control Module (ECM) OK
Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder
Battery voltage at least 12.7 V
Generator OK
Test sequence
- Connect VAG1598/31 test box at wiring harness
to ECM, do not connect ECM Page 24
-17
.
- Switch ignition on.
Note:
The plus voltage supply for the Engine Control
Module (ECM) travels via connector terminal 3
(terminal 15) and connector terminal 62
(terminal 30).
Ground (GND) supply of the Engine Control
Pa
ge 34 of 65 I
gnition s
ystem, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.28.1
