34-41
- Remove driveshaft -1- from transmission and rest it on heat shield -2-.
- Secure driveshaft to fuel line bracket -3- using wire (arrow).
- Place VAG1306 underneath and drain gear oil.
Note:
Illustration is shown with transmission removed.
Torsen differential cover, servicing, removing and installing Page 34
-68
- Remove cover -A- together with Torsen differential from transmission
cover -B-.
- Remove compression spring -C- from drive pinion.
Pa
ge 3 of 4 Cover with Torsen differential, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.4
34-42
Installing
Install in reverse order of removal, note the
following:
- Clean sealing surfaces and coat with AMV 188
000 02.
Repair Manual, Engine Mechanical, Repair Group 26
Tightening torque - Make sure dowel sleeves for Torsen differential cover -A- are installed
in transmission cover -B- (arrows).
- Install compression spring -C- over drive pinion onto hollow shaft
- Install driveshaft Page 39
-71
.
- Check oil level in transmission and top up if necessary Page 34
-38
.
- Align exhaust system free of stress.Component
Tightening
torque
Cover with Torsen differential to transmission 25 Nm (18 ft lb)
Driveshaft to transmission 55 Nm (41 ft lb)
Heat shield for driveshaft to Torsen differential
cover 25 Nm (18 ft lb)
Pa
ge 4 of 4 Cover with Torsen differential, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.4
