1998 Volvo S90
WARNING!
As its name implies, SRS is designed to be a
SUPPLEMENT to - not a replacement for - the
three-point belt system. For maximum
protection, wear seat belts at all times. Be
aware that no system can prevent all possible
injuries that may occur in an accident.
VOLVO SRS (cont.) pg. 5
A self-diagnostic system incorporated in the sensor
monitors the SRS. This system does not, however,
monitor the SIPS airbags. If a fault is detected, the
"SRS" warning light will illuminate. The light is
included in the warning/indicator light cluster in the
instrument panel. Normally, the SRS warning lamp
should light up when the ignition is switched on
and should go out after 10 seconds or when the
engine is started. Check that this light is
functioning properly every time the car is started.
The following items are monitored by all the self-
diagnostic system:
l Sensor unit
l Cable harness
There is no maintenance to perform on the SRS
yourself. The only periodic maintenance
recommended on the SRS is that the air bag
modules and front seat belts (including tensioners)
should be replaced approximately every ten years
and that the other components in the system
(wiring, connectors, etc.) should also be inspected
at this time. The SRS decal on your car shows the
month and year servicing is due. This service must
be performed by an authorized Volvo retailer.
Should you have any questions about the SRS
system, please contact your authorized Volvo
Retailer or Volvo Customer Support.
file:///K|/ownersdocs/1998/1998_SV90/98S90_004.htm (2 of 7)12/30/2006 \
1:52:34 PM
1998 Volvo S90
High-mounted brake light
To remove: (Sedans)
Turn off ignition.
Depress catch with a screwdriver. Pull
cover upward to remove it.
To remove: (Wagons)
Turn off ignition.
Grasp the cover with both hands and pull
it towards you.
Bulb Power CP(W) Socket US Bulb No.
High-mounted brake light 32(21) BA15s
1156 Depress catches and fit new bulb.
To fit:
Fit the reflector and check that the light
works.
4-door models
Press the cover into position, noting the
position of the alignment pin at the top.
Wagons
Align the catches and press the cover into
position.
Replacing bulbs pg. 87
Interior light and reading lights
Take hold of the front section of the light
as shown and pull straight down.
Press lens out from inside and replace
bulb. Check operation before reinstalling
lamp housing.
NOTE:
The wiring should not be pinched when
the lamp housing is reinstalled.
Bulb Power Socket
Interior light 10 W SV 8.5
Reading light 5 W W2.1x9.5d
Reading lamps, rear
The bulb in the adjustable reading lamps
can be changed as follows: insert a
screwdriver as shown and twist off the
lamp. Withdraw the bulb and fit a new one.
Replacing bulbs pg. 88
file:///K|/ownersdocs/1998/1998_SV90/98S90_081.htm (5 of 6)12/30/2006 \
1:52:45 PM
