1998 VOLVO S90 lock

1998 Volvo S90
swing the cushion up and toward the
back of the front seats.
Move the backrest release lever rearward
and fold the backrest down.
When the backrest is raised, the outboard
head restraints return to their normal
position and must be raised manually if
required.
The backrest must lock into place. The
red lock indicator will not be visible if
the seat has locked into place
correctly. seat is returned to normal position. WARNING! When the rear seat is
folded down, do not place heavy
objects against the backs of the front
seats. This places a severe strain on
the folded down backrest of the rear
seat. Be sure to secure cargo. Cargo
must not be stacked higher than the
top of seatbacks. This will reduce the
possibility of luggage, etc. becoming
projectiles during sudden maneuvers,
rapid braking or an accident. The red
lock indicator is visible when the
backrest is NOT locked in position
and not visible when the backrest is
correctly locked in place. When the
backrest is in the upright position, it
must always be correctly locked in
place.
Removing seat cushions, Tool box, Securing cargo (wagon) pg. 44

Lift the seat cushion part way and
remove the seat.

Removing seat cushions

The seat cushion can be easily removed
to provide a slightly larger cargo storage
area. To remove, lift the seat cushion out
of the hinges.

Tool box

Tool box

The tool box can be released by turning
the catch.

WARNING! Do not place extremely
heavy articles the front seats, as the
backrest which is folded down is then
placed under severe strain.
Be sure to secure cargo. Hard and sharp
articles could otherwise damage the
frontseat backrest and/or cause injury to
passengers in the event of rapid braking
or a collision.
Always secure cargo

Securing cargo

As a safety precaution, the cargo space
is equipped with six eyelets to which
straps can be attached to secure
luggage.

file:///K|/ownersdocs/1998/1998_SV90/98S90_042.htm (2 of 4)12/30/2006 \
1:52:40 PM

1998 Volvo S90
l To slide open the sun roof :
press the lower section of the
switch.
l To close the sun roof :press
the upper section of the
switch until the sun roof has
closed completely .
l To open the rear edge of
the sun roof (ventilation
position): press the upper
section of the switch. Press
the lower section of the
switch to return the sun roof
to the closed position.
with the sun roof when the sun roof slides
back (not when the sun roof is opened to
the ventilation position).
l The sun shade can also be opened
manually even if the sun roof is closed.
l The sun shade will not close
automatically with the sun roof. It must be
closed manually.

WARNING! (SUN ROOF): The sun
roof must never be obstructed in any
way when in operation.
an overload protecting circuit breaker
(fuse no. 26) which is activated when an
object blocks the sun roof. Should this
occur, remove the object and wait 20
seconds for the circuit breaker to reset.
The sun roof should then function
normally.
l To help alleviate "rumbling" wind
noise when the sun roof is open, adjust the
position slightly (open/close).
Long load storage (sedan) pg. 50



Long load storage

In the panel behind the rear seat is a door
which makes it possible to carry long
loads such as skis, etc.
WARNING!
Cover sharp edges on load to help
prevent injury to occupants. Secure
load to help prevent shifting during
sudden stops.
Protective covers (for skis) should
also be used to avoid soiling or
tearing the upholstery. Please note
that the flap in the rear seat is only
intended for light loads such as skis,
carpets, etc.
Max. length of load 6 1/2 ft = 2m.
Max. weight of load 33 lbs = 15 kg.


file:///K|/ownersdocs/1998/1998_SV90/98S90_048.htm (2 of 4)12/30/2006 \
1:52:40 PM

1998 Volvo S90
WARNING!
Always turn engine off and apply
parking brake when loading/
unloading the vehicle. Place
transmission selector in P (PARK)
position to help prevent
inadvertent movement of selector.
Alarm pg. 51

Alarm LED


Alarm

To lock: Press the lock/panic button
once to lock all doors and trunk/tailgate
and arm the security system. Lamps will
flash to acknowledge that the vehicle is
locked and the security system is armed.
To unlock: Press the unlock button once
to unlock the driver's door only and
disarm the security system.
Press the unlock button again (within 10
seconds) to unlock all doors and trunk/
tailgate.
Emergency function

To activate the " panic alarm
"function:
Press and hold lock/panic button for at
least 3 seconds. The car's lights will
flash and an alarm will sound for
approximately 30 seconds.







This function can be switched off at
any time by pressing either of the
buttons.

Programming a transmitter

New transmitters (max. 4) must be
programmed to function with your
alarm system. To do this:
l Make sure all doors, hood and
trunk/tailgate are closed.
l Turn the ignition on and off 5
times within 10 seconds. On the
fifth try, leave the ignition on.
l Press either button on the
transmitter. NOTE: The first transmitter must be
programmed within 15 seconds, the
others within 10 second intervals.
When the alarm system accepts the
codes from each transmitter, the
LED on the dash will glow steadily
for several seconds.
l Switch the ignition off and test the
transmitter(s).

Batteries

The remote transmitter is powered
by 2 three-volt batteries, type CR
1220. If three short signals are
audible from the transmitter each
time you lock/unlock the car, this
indicates that the batteries are weak.
Replacement: Remove the battery
cover on the back of the transmitter
with a coin. Replace the batteries.
Reinstall the cover, making sure it is
secured tightly to help protect the
transmitter.

NOTE: If only the driver's door is
unlocked, the lock will automatically
reengage (re-lock) and the alarm will
reset after 30 seconds unless the
door has been opened.
If all of the doors were unlocked (by
pushing button 2 twice within 10
seconds) and no door/trunk/tailgate
was opened within two minutes, all
locks will reengage and the alarm
will reset. This is to prevent the
vehicle from being left unlocked if
the unlock button is inadvertently
pressed.
The lock/unlock and alarm features
file:///K|/ownersdocs/1998/1998_SV90/98S90_048.htm (3 of 4)12/30/2006 \
1:52:40 PM

1998 Volvo S90
can also be utilized by using the
keys. See section: Keys, Doors and
Locks on page 32.
If the alarm LED glows
continuously for 5 seconds, this
indicates a fault in the system or that
a door is not properly closed.




Contents | Top of Page
file:///K|/ownersdocs/1998/1998_SV90/98S90_048.htm (4 of 4)12/30/2006 \
1:52:40 PM

1998 Volvo S90
(check when tires are cold). items and others are checked at
the standard Maintenance
Service intervals.

NOTE: Since using (D)rive
improves fuel economy, it
should be used as often as
possible.
Starting the engine pg. 57
Starting and stopping a
car equipped with
automatic transmission

1 Fasten the seat belt.
WARNING! Before
starting, check that the seat
is adjusted properly. Make
sure the brake pedal can be
depressed completely. Move
the seat closer if necessary.
Refer to section "Front
seats".

2 Apply the parking brake, if
not already set. The gear
selector is locked in the (P)ark
position (SHIFTLOCK).

3Without touching the
accelerator pedal ,turn the
ignition key to the starting
position. Allow the starter to
operate for 5-10 seconds.
Release the key as soon as the
engine starts. If the engine fails
to start, repeat step 3.

5 Select desired gear. The gear
engages after a slight delay,
especially noticeable when
selecting R.
CAUTION: Engine should
be idling; never accelerate
until after you feel the gear
engage! Too rapid
acceleration immediately
after selecting a gear will
cause harsh engagement and
premature transmission
wear.

NOTE:Your car is equipped
with a KEYLOCK system.
When the engine is switched
off, the gear selector must be in
the (P)ark position before the
key can be removed from the
ignition switch.

Engine warm-up - initial
driving procedure

Engines in vehicles driven short
distances are subject to
abnormally rapid wear because
the engine never reaches normal
operating temperature. It is
therefore beneficial to reach
normal operating temperature as
soon as possible. This is best
achieved by driving with a light
foot on the accelerator pedal for
a few minutes after starting,
rather than prolonged idling.

B6304 S Engine


This engine features hydraulic
valve lifters which means that
valve clearance is adjusted
automatically. It is possible that
the valve lifters will produce a
ticking sound for the first few
seconds after the engine is
started, while the oil pressure is
increasing.
If the car has not been used for a
long period of time, this ticking
sound may last for up to 15
minutes. This is entirely normal.
file:///K|/ownersdocs/1998/1998_SV90/98S90_053.htm (5 of 6)12/30/2006 \
1:52:41 PM

1998 Volvo S90
For cold starts at altitudes
above 6000 ft (1800 m),
depress the accelerator pedal
halfway and turn the key to the
starting position. Release the
accelerator pedal slowly when
the engine starts.

4 To release the gear selector,
depress the brake pedal .See
page 61 for instructions on
manually overriding the
SHIFTLOCK system if the
lever cannot be moved. Do not
race a cold engine immediately
after starting. Oil flow may not
reach some lubricating points
fast enough to prevent engine
damage. WARNING!
Never leave car unattended
with engine running.
Always open the garage
doors fully before starting
the engine inside a garage to
ensure adequate ventilation.
The exhaust gases contain
carbon monoxide, which is
invisible and odorless but
very poisonous.

NOTE:
l Do not exceed 3000rpm until
the ticking sound disappears.
l Selecting position P or N
when idling at a standstill for
prolonged periods of time will
help prevent overheating of the
transmission oil.




Contents | Top of Page
file:///K|/ownersdocs/1998/1998_SV90/98S90_053.htm (6 of 6)12/30/2006 \
1:52:41 PM

1998 Volvo S90
Chapter 4 (cont)
Automatic transmission
pg. 58

P(Park)

Use this position when
starting the engine or parking
the car.
Never use P while car is in
motion.
The transmission is
mechanically locked when in
position P. Also use the
parking brake when parking
on grades.
The gear selector is locked in
the P position (Shift lock). To
release the selector, start the
engine and depress the brake
pedal. See page 61 for
instructions on manually
releasing the gear selector. WARNING!
Never leave the car when
the engine is running. If, by
mistake, the gear selector is
moved from P the car may
start moving.


R(Reverse)

Never engage R while car is
moving forward.

N(Neutral)

Neutral position = no gear is
engaged.
Use parking brake. The
engine can be started with
the gear selector in this
position.

D(Drive)

D is the normal driving
position and should be used
as often as possible to help
improve fuel economy.
When modes E or S are
selected, upshift and
downshift of the forward
gears occur automatically
and are governed by
accelerator pedal position
and vehicle speed.

3 (Intermediate position)

Automatically shifts up and
down between first second

L (Low gear)

The gearbox does not upshift in
position L! Select position L if you
wish to drive in first or second gear
and you do not wish to shift up (when
driving in hilly terrain, for example, as
position L provides the best engine
braking power). The transmission will
conspicuously shift down from second
to first if road speed drops to below 25
or 20 mph (40 km/h or 30 km/h)
(engines B6304 and B6254
respectively) when driving in
Economy mode. When driving in
Sport mode, the same very noticeable
shift takes place if the speed drops to
below 6 mph (10 km/h).
file:///K|/ownersdocs/1998/1998_SV90/98S90_058.htm (1 of 7)12/30/2006 \
1:52:42 PM

1998 Volvo S90
obtained by depressing the
selector knob prior to moving
the selector.
Slightly depressing the selector
knob allows selection of
positions N, D, 3 and L. Fully
depressing the selector knob
allows selection of positions R
and P. This is also necessary
when initially bringing the
selector out of position P. Fully
depressing the selector knob
thus permits shifting freely
between all positions.Mode selector

The push-buttons to the left of
the gear lever are for selection of
modes E, S and W. Any mode
can be selected while the car is
on the move.

Winter/Wet mode
Enhanced Vehicle Traction
This mode may be selected for
starting/moving off on slippery
roads or to lower downshift
speeds if the transmission is in
"L".
In this mode:
l In position D*, the gearbox
starts in third gear and changes
up to fourth gear.
l In position 3*, second gear is
locked and there is no change up
to third gear.
l In position L, first gear is
locked.
*These positions always offer
the kick-down feature.
CAUTION: Driveability and
fuel economy will be
adversely affected by
prolonged driving in mode W .
Volvo recommends using this
mode only when starting in
extremely slippery conditions.

Sport Mode
This mode is adapted to "sporty"
driving characteristics. The
transmission upshifts at higher
engine speeds and less
accelerator pedal pressure is
required to initiate a downshift.

Economy Mode
This mode is used normally. The
gearbox changes gears at a
lower engine speed to achieve
the best possible fuel
consumption.

"Lock-up"
The automatic gearbox has a
"lock-up" function. It reduces
engine speed and saves fuel. The
"lock-up" function can
sometimes be felt as an
additional gear change.
Points to remember pg. 60
file:///K|/ownersdocs/1998/1998_SV90/98S90_058.htm (3 of 7)12/30/2006 \
1:52:42 PM