1998 VOLVO S90 key

1998 Volvo S90
can also be utilized by using the
keys. See section: Keys, Doors and
Locks on page 32.
If the alarm LED glows
continuously for 5 seconds, this
indicates a fault in the system or that
a door is not properly closed.




Contents | Top of Page
file:///K|/ownersdocs/1998/1998_SV90/98S90_048.htm (4 of 4)12/30/2006 \
1:52:40 PM

1998 Volvo S90
(check when tires are cold). items and others are checked at
the standard Maintenance
Service intervals.

NOTE: Since using (D)rive
improves fuel economy, it
should be used as often as
possible.
Starting the engine pg. 57
Starting and stopping a
car equipped with
automatic transmission

1 Fasten the seat belt.
WARNING! Before
starting, check that the seat
is adjusted properly. Make
sure the brake pedal can be
depressed completely. Move
the seat closer if necessary.
Refer to section "Front
seats".

2 Apply the parking brake, if
not already set. The gear
selector is locked in the (P)ark
position (SHIFTLOCK).

3Without touching the
accelerator pedal ,turn the
ignition key to the starting
position. Allow the starter to
operate for 5-10 seconds.
Release the key as soon as the
engine starts. If the engine fails
to start, repeat step 3.

5 Select desired gear. The gear
engages after a slight delay,
especially noticeable when
selecting R.
CAUTION: Engine should
be idling; never accelerate
until after you feel the gear
engage! Too rapid
acceleration immediately
after selecting a gear will
cause harsh engagement and
premature transmission
wear.

NOTE:Your car is equipped
with a KEYLOCK system.
When the engine is switched
off, the gear selector must be in
the (P)ark position before the
key can be removed from the
ignition switch.

Engine warm-up - initial
driving procedure

Engines in vehicles driven short
distances are subject to
abnormally rapid wear because
the engine never reaches normal
operating temperature. It is
therefore beneficial to reach
normal operating temperature as
soon as possible. This is best
achieved by driving with a light
foot on the accelerator pedal for
a few minutes after starting,
rather than prolonged idling.

B6304 S Engine


This engine features hydraulic
valve lifters which means that
valve clearance is adjusted
automatically. It is possible that
the valve lifters will produce a
ticking sound for the first few
seconds after the engine is
started, while the oil pressure is
increasing.
If the car has not been used for a
long period of time, this ticking
sound may last for up to 15
minutes. This is entirely normal.
file:///K|/ownersdocs/1998/1998_SV90/98S90_053.htm (5 of 6)12/30/2006 \
1:52:41 PM

1998 Volvo S90
For cold starts at altitudes
above 6000 ft (1800 m),
depress the accelerator pedal
halfway and turn the key to the
starting position. Release the
accelerator pedal slowly when
the engine starts.

4 To release the gear selector,
depress the brake pedal .See
page 61 for instructions on
manually overriding the
SHIFTLOCK system if the
lever cannot be moved. Do not
race a cold engine immediately
after starting. Oil flow may not
reach some lubricating points
fast enough to prevent engine
damage. WARNING!
Never leave car unattended
with engine running.
Always open the garage
doors fully before starting
the engine inside a garage to
ensure adequate ventilation.
The exhaust gases contain
carbon monoxide, which is
invisible and odorless but
very poisonous.

NOTE:
l Do not exceed 3000rpm until
the ticking sound disappears.
l Selecting position P or N
when idling at a standstill for
prolonged periods of time will
help prevent overheating of the
transmission oil.




Contents | Top of Page
file:///K|/ownersdocs/1998/1998_SV90/98S90_053.htm (6 of 6)12/30/2006 \
1:52:41 PM

1998 Volvo S90




Shiftlock release

The gear selector is locked in
the P position. To manually
release the shift lock, turn the
starting (ignition) key to
position I and press firmly on
the "OVERRIDE" button
(located under the cover near
the base of the gear selector -
see illustration). While
holding the override button
down, move the gear selector
from the (P)ark position. Electrical system

When replacing the battery or
when carrying out work
involving the electrical
system, the following should
be observed:
l A battery connection to the
wrong terminal will damage
the diodes. Before
connections are made, check
the polarity of the battery
with a voltmeter.
l If booster batteries are used
for starting, they must be
properly connected to
minimize the risk of the diode
being damaged.
For correct connection, see
"Jump starting" section.
l Never disconnect the
battery circuit (for example,
to replace the battery) while
the engine is running, as this
will immediately ruin the
generator. Always make sure
that all the battery
connections are properly
tightened.
l If any electrical-welding
work is performed on the
vehicle, the battery's ground
lead (negative cable) and all
the connecting cables of the
generator must be
disconnected and the welder
cables placed as near the
welding point as possible.
l The radio must be turned
off before the battery is
disconnected.
l If the radio has an antitheft
code and the battery has been

WARNING!
The Supplemental Restraint
System is grounded under the
driver's seat. Do not loosen the two
screws grounding the unit. Do not
ground other electrical
components using these screws or
any other points near them. Faults
in the system could occur if it is
improperly grounded.
file:///K|/ownersdocs/1998/1998_SV90/98S90_058.htm (5 of 7)12/30/2006 \
1:52:42 PM

1998 Volvo S90
No. Lubricating hint / Lubricant
1 Hood lock and latch / Oil
2 Hood hinges / Oil
3 Door stop and hinges / Oil
4 Sun roof wind deflector / Oil
Sun roof mechanism / Grease
5 Door lock catch plate / Oil
6 Trunk lid lock / Low temperature
keyhole and hinges / grease

No. Lubricating hint / Lubricant
7 Window regulator/ Oil, grease
locking device low temperature
(on inside of door) / grease
8 Front seat slide rail
and latch / Oil
9 Door lock keyhole / Low temperature grease or Volvo Teflon lock spray \

To avoid rattles and unnecessary wear, the body should be lubricated at \
regular service intervals. This should be done by
an authorized Volvo retailer.
Brake fluid, Power steering fluid pg. 116

Brake fluid reservoir
Power steering fluid

The fluid level should lie between the MIN and MAX on the
side of the dipstick. The space between the marks
corresponds to 0.2 US qts/liters.

Fluid type: ATF
Replace: no fluid change required.Brake fluid

The fluid level should be between the MIN and MAX
marks.

Fluid type: DOT 4+
Replace*: every second year or 30,000 miles (48,000
km). The brake fluid should be replaced once a year or
every 15,000 miles (25,000 km) when driving under
extremely severe conditions (mountain driving, hot
climate, high humidity etc.)

file:///K|/ownersdocs/1998/1998_SV90/98S90_114.htm (2 of 5)12/30/2006 \
1:52:50 PM

1998 Volvo S90
Anti-theft code

The radio features anti-theft
circuitry. If the set is removed
from the vehicle or if the
battery power is disconnected, a
special code must be entered to
enable operation of the set.
Refer to the radio code card
supplied with your vehicle or
ask your retailer for the
correct code.
When the car is parked with
ignition key removed the anti-
theft LED will flash. To enter the code

After installation or when the
set has been disconnected from
power, the set displays "CODE"
when it is switched on.
Enter the 4-digit code using the
preset buttons.
If the correct code is entered the
set is entered the set is ready to
use.
If you enter an incorrect code
you must enter the correct code
again from the beginning.
Incorrect code

If an incorrect code has been
entered "rPt" is displayed. Enter
the correct code. After three
unsuccessful coding attempts the
set will lock and remain locked
for two hours.
"OFF" is displayed.
During this waiting period:
l the battery must be connected
l the ignition key must be
turned to position I
l the unit must be turned on
Make sure the headlights are
turned off to help prevent battery
drain (please refer to page 20 for
information on turning the
headlights off).
Enter the code again once this
time has elapsed.
Radio SC-813 pg. 134
file:///K|/ownersdocs/1998/1998_SV90/98S90_131.htm (3 of 6)12/30/2006 \
1:52:52 PM

1998 Volvo S90

Anti-theft code

The radio features anti-theft
circuitry. If the set is removed
from the vehicle or if the
battery power is disconnected, a
special code must be entered to
enable operation of the set.
Refer to the radio code card
supplied with your vehicle or
ask your retailer for the
correct code.
When the car is parked with
ignition key removed the anti-
theft LED will flash. To enter the code

After installation or when the
set has been disconnected from
power, the set displays "CODE"
when it is switched on.
Enter the 4-digit code using the
preset buttons.
If the correct code is entered the
set is entered the set is ready to
use.
If you enter an incorrect code
you must enter the correct code
again from the beginning.
Incorrect code

If an incorrect code has been
entered "EEEE" is displayed.
Enter the correct code. After
three unsuccessful coding
attempts the set will lock and
remain locked for two hours.
"OFF" is displayed.
During this waiting period:
l the battery must be connected
l the ignition key must be
turned to position I
l the unit must be turned on
Make sure the headlights are
turned off to help prevent battery
drain (please refer to page 20 for
information on turning the
headlights off).
file:///K|/ownersdocs/1998/1998_SV90/98S90_145.htm (2 of 6)12/30/2006 \
1:52:53 PM