
Chapter 1 - Occupant safety
pg. 1 Occupant safety
Occupant  safety
Despite our strongest recommendations, and  your best intentions,  not wearing a  seat belt is like believing "It'll  never
happen to me!". Volvo urges you and  all adult occupants of your car to wear  seat belts and  ensure that children are
properly restrained,  using an  infant, car or booster  seat determined by age, weight and  height. 
Fact: In every state and  province, some type of child-restraint legislation has been passed. Additionally, most  states
and  provinces have already  made it mandatory for occupants of a  car to use seat belts. 
So, urging you to "buckle  up" is not just  our recommendation - legislation in your state or province may mandate seat
belt usage. The few seconds it takes to buckle up may one  day  allow you to say, "It's a  good thing I was wearing my
seat belt". 
Seat belts2
Volvo SRS4
Side Impact Protection  System - (SIPS) air bag8
Child safety9
Occupant safety12
Reporting Safety Defects12
pg. 2 Seat belts
Seat belts
 
Always fasten the seat belts before you drive or  ride.  
Two lights above the rear view  mirror will be  illuminated for 4-8 seconds after the starting (ignition) key  is turned to
the driving position. A chime  will sound at the same time if the driver has not fastened his seat belt. The rear seats  are
provided with self -retracting inertia reel belts. The front  seats  are provided with single roller belts with tensioners. 
Adjusting the shoulder belt
Lap portion  of the seat belt should sit  low
ProCarManuals.com 

Chapter 4 - Starting and driving
pg. 55 Starting and driving
Starting and  driving
 
This section on starting and  driving contains items such as starting the engine, operating the gear selector, towing,
trailers, etc. 
Break-in period
56
Fuel requirements, Refueling56-57
Driving economy58
Starting the engine59
Manual transmission60
Automatic transmission61
Points to remember64
Emergency towing66
Vehicle towing information67
Jump  starting68
Three-way catalytic converter69
Brake system, ABS70
Trailer towing71
Winter driving72
Long distance trips73
pg. 56 Break-in  period, Fuel  requirements
A new car should  be broken -in
 
Refrain from  utilizing your car's full driving potential during the first 1,200 miles (2,000 km) including the "kick -
down"  function (automatic transmission). 
NOTE - ENGINE  OIL:  
Although some oil consumption occurs during normal engine operation, more oil is consumed when the engine is new
as the internal parts  generate  higher friction  while wearing-in to each other. From the time the engine is new until
the first service  is performed, the oil consumption  could be higher than  normal. For this reason, it is especially
important to check  the oil every time you refuel your car during this period. See  page 114
. 
In general,  the rate of oil consumption depends on such factors as: engine temperature, length of trip, driving
conditions, oil viscosity and  quality, engine speed and  acceleration/deceleration. 
Checking your engine oil level  each time the car is refueled is one  of the most  important items you can perform to
help keep your car in good running order. 
ProCarManuals.com 

well on the government course as a  tire graded 100. The relative performance of tires depends upon the actual
conditions of their use, however,  and  many depart significantly from  the norm due  to variation in driving habits,
service practices and  differences  in road characteristics and  climate.  
TRACTION 
The traction grades, from  highest to lowest, are AA,  A, B, and  C, as measured under controlled conditions on specified
government test surfaces of asphalt and  concrete.  A tire marked C may have poor traction performance. 
WARNING!  The traction grade assigned  to this  tire is based on braking (straight-ahead) traction tests and  does not
include  cornering (turning) traction.
TEMPERATURE  
The temperature grades are AA  (the highest), A, B, and  C, representing  the tire's resistance  to the generation of heat
and  its  ability to dissipate heat when tested under controlled conditions on a  specified indoor laboratory test wheel.
Sustained high temperature can cause the material of the tire to degenerate and  reduce tire life, and  excessive
temperature can lead to sudden tire failure. The grade C corresponds to a  level  of performance which  all passenger  car
tires must  meet  under the Federal Motor Safety Standard No. 109. Grades B and  A represent higher levels of
performance on the laboratory test wheel than the minimum required by law.  
WARNING!  The temperature grade for this  tire is established  for a  tire that is properly inflated and  not overloaded.
Excessive speed, underinflation, or excessive loading, either separately or in combination, can cause heat buildup
and  possible tire failure.
  
Contents | Top of Page
ProCarManuals.com 

CAUTION: Correct tightening torque on wheel bolts  must  be  observed. The wheel bolts  should never be  greased or
lubricated. The extended, chromed wheel bolts  must  not be  used with steel rims, as they make it impossible to fit the
hub caps.
pg. 84 Spare tire
Temporary Spare (certain models) 
The spare tire of your car is what  is called a  "Temporary Spare". It has the following designation: T115/70 R15 or
T125/90R15. 
Recommended tire pressure (see decal on fuel filler  flap) should be  maintained  irrespective of which  position on the
car the Temporary  Spare tire is used on. 
In the event of damage to this  tire a  new one  can be  purchased from  your Volvo retailer. 
CAUTION:  The car must  not be  driven with wheels of different  dimensions or with a  spare tire other than the one
that came with the car. The use of different  size wheels can seriously damage your car's transmission.
WARNING!  
Current legislation prohibits the use of the "Temporary Spare" tire other than as a  temporary replacement  for a
punctured tire. In other words,  it must  be  replaced  as soon as possible by a  standard tire. Roadholding, etc., may be
affected with the "Temporary Spare" in use. Do not, therefore, exceed 50 mph (80 km/h).
  
Contents | Top of Page
ProCarManuals.com 

1 Vehicle Emission Control Information 
Your Volvo is designed to meet  all applicable emission standards, as evidenced by the certification label  on the
underside of the hood. For further information regarding these regulations,  please consult your Volvo retailer. 
2 Vacuum hose routing  
(underside of hood) 
3 Loads and Tire Pressures  
(on rear edge of passenger's  door) 
4 Model plate  
Vehicle Identification Number (VIN).  Codes for color and  upholstery, etc. The plate  is located in the engine
compartment, on the inside of left front  fender. 
5 Vehicle Identification Number (VIN) * 
The VIN plate  is located on the top left surface  of the dashboard. The VIN is also stamped on the right hand  door
pillar. 
6 Federal Motor Vehicle Safety Standards (FMVSS) specifications (USA) and Ministry of Transport (CMVSS)
Standards (Canada)  
Your Volvo is designed to meet  all applicable safety standards, as evidenced by the certification label  on the facing
side of the driver's door. For further information regarding these regulations,  please consult your Volvo retailer. 
* The Vehicle Identification Number (VIN)  should always be  quoted in all correspondence concerning  your vehicle
with the retailer and  when ordering parts.  
** These decals are located on the underside of the hood. 
All specifications are subject to change without notice.  
pg. 107 Maintenance service, Warranty
Maintenance service
 
Volvo advises  you to follow the service program which  is outlined in the "Maintenance  Records Manual". This
maintenance program contains inspections and  services necessary  for the proper function of your car. The maintenance
services contain  several checks which  require special instruments and  tools  and  therefore must  be  performed by a
qualified technician. To keep your Volvo in top condition, specify time tested and  proven Genuine Volvo Parts and
Accessories. 
ProCarManuals.com