’98 AVALON (USA/CANADA)−U
214
Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
Light bulbsBulb
No.WTy p e
Headlights
(low beam)900651A
Headlights
(high beam)900560B
Front fog lights—55C
Parking and front turn
signaol lights3157 NA27/8E
Rear turn signal lights744021E
Stop and tail lights744321/5E
Rear side marker lights1683.8E
Back −up lights92118E
License plate lights1685E
High mounted
stop light92118E
Interior light—8F
Front personal lights—8D
Rear personal lights—8D
Glovebox light—1.2E
Door courtesy lights1945E
Trunk light—3F
A: HB4 halogen bulbs
B: HB3 halogen bulbs
C: H3 halogen bulbs
D: Single end bulbs
E: Wedge base bulbs
F: Double end bulbs
—Headlights
1. Unplug the connector while depress-
ing the lock release.
If the connector is tight, wiggle it.
ProCarManuals.com
’98 AVALON (USA/CANADA)−U
215
2. Turn the bulb and remove it.3. Install a new bulb and the connector
into the mounting hole.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
—Front fog lights
1. Remove the bolts and clips, take out the engine under cover.
Remove and install the cover clips as shown
in the following illustration.
ProCarManuals.com
