Page 308 of 444

NOTE: INSTALL BOlTOM OF BAG FIRST 
TOOL STORAGE 
’ BAG & TOOLS 
Replace all jacking tools as they were stored in  the  jack 
storage compartment and  replace  the compartment 
cover. 
To replace the cover,  line up the tabs on the right 
of  the  cover  with the slots  in the  cover  opening. Push the 
cover 
in place  and push down  the tab so that  it  rests  in 
the groove.  This secures the  cover in place.  Unless 
you have  the plastic “bolt-on”  wheel  covers,  be 
sure  to  also store the center  cap. When  you replace  the 
compact  spare with a full-size  tire,  replace the bolt-on 
wheel  covers  and the  center  cap.  Tighten them “hand 
tight’’  over the wheel nuts, using the folding wrench. 
Compact  Spare  Tire 
Although the compact  spare tire was fully inflated when 
your vehicle  was  new, it can lose  air  after a time. Check 
the inflation pressure regularly. It should be 
60 psi 
(420 kPa). 
After installing the compact  spare on your vehicle, you 
should  stop as soon  as possible and make sure your 
spare  tire  is correctly inflated.  The compact  spare 
is 
made to perform  well at speeds  up to 65 mph 
(105 km/h)  for distances up to 3,000 miles (5 000 km), 
so you  can finish  your trip and have your  full-size  tire 
repaired  or replaced where  you want.  Of course,  it’s best 
to  replace your  spare with a  full-size  tire  as soon as 
you 
can. Your  spare  will last longer and  be in good  shape in 
case 
you need  it again. 
5-34 
ProCarManuals.com 
     
        
        Page 353 of 444

CAUTION: 
Mixing tires could  cause  you  to lose  control  while 
driving. 
If you mix tires  of different  sizes or types 
(radial  and  bias-belted  tires),  the vehicle  may  not 
handle  properly,  and you  could  have  a  crash. 
Using  tires of different  sizes  may  also  cause 
damage to your  vehicle.  Be sure to use  the same 
size  and  type  tires  on all wheels. 
It’s  all  right to drive  with your  compact  spare, 
though.  It was  developed  for use  on  your vehicle. 
i A CAUTION: I 
I If you  use  bias-ply  tires on your  vehicle,  the 
wheel  rim flanges  could  develop  cracks  after 
many  miles  of driving. 
A tire  and/or  wheel  could 
fail  suddenly,  causing  a  crash. Use  only  radial-ply 
tires  with  the wheels 
on your  vehicle. 
Uniform  Tire  Quality  Grading 
The  following  information  relates  to the system 
developed  by the  United  States  National  Highway 
Traffic Safety  Administration,  which grades tires by 
treadwear, traction and temperature performance.  (This 
applies  only to vehicles sold  in  the United States.)  The 
grades  are molded  on the  sidewalls 
of most  passenger 
car  tires.  The  Uniform Tire Quality Grading  system 
does not apply  to deep  tread,  winter-type  snow  tires, 
space-saver  or temporary  use spare  tires, tires with 
nominal  rim  diameters  of 
10 to 12 inches (25 to 30 cm), 
or  to  some  limited-production  tires. 
While  the  tires  available  on General Motors passenger 
cars  and light  trucks may  vary  with respect to these 
grades,  they must also conform  to Federal  safety 
requirements  and additional  General Motors  Tire 
Performance  Criteria 
(TPC) standards. 
6-43 
ProCarManuals.com 
     
        
        Page 356 of 444
Used Replacement  Wheels 
I * I 
1 
Putting a used wheel  on  your  vehicle  is 
dangerous.  You can’t  know  how it’s been  used  or 
how  far it’s been  driven.  It could  fail  suddenly 
and  cause  an  accident.  If you have  to  replace  a 
wheel,  use 
a new GM original  equipment  wheel. 
Tire Chains 
NOTICE: 
Use tire  chains  only where  legal and only  when 
you  must.  Use only 
SAE Class “S” type  chains 
that  are  the  proper  size for  your  tires.  Install 
them  on  the  front  tires  and  tighten  them  as 
tightly  as  possible  with  the  ends  securely 
fastened.  Drive  slowly and follow  the  chain 
manufacturer’s  instructions.  If you  can  hear  the 
chains  contacting  your  vehicle, stop  and  retighten 
them. 
If the  contact  continues,  slow down  until  it 
stops.  Driving  too  fast  or  spinning  the  wheels 
with  chains  on  will damage  your  vehicle. 
6-46 
ProCarManuals.com 
     
        
        Page 374 of 444

Replacement  Bulbs 
Exterior  Lamps  Bulb  Number 
Headlamps ......................... 9004-HBI 
Signal Lamps 
.......... .3 157 NA or 3 157 NAK 
Front  Sidemarker Lamps ................... 194 
Stop/Tail  (Top) 
.......................... 3057 
Signal  (2nd from top) 
..................... 3 156 
Tail (Bottom) ........................... 3057 
Front Parking/Turn 
Back-up  Lamps (3rd from top) 
............. 3156 
Capacities  and  Specifications 
The following approximate 
capacities  are given in 
English and metric  conversions. 
Please  refer to “Recommended Fluids  and Lubricants’’ 
in  the Index for more information. 
Automatic  Transaxle 
Pan Removal and Replacement ..... 8 quarts  (7.5 L) 
With  A/C 
................... 9.6  quarts  (9.1 L) 
Cooling  System 
With Rear Climate  Control 
or  Rear Heater 
............ 1 1.9 quarts (1 1.3  L) 
Engine  Crankcase - Oil  and 
Fuel  Capacity  Filter  Change 
............... 4.5 quarts (4.3 L) 
Standard/Regular .............. 20 gallons (76 L) 
OptionalExtended 
............ 25  gallons (95 L) 
Refrigerant, 
Air  Conditioning* 
.......... See  the Refrigerant 
Label under the hood. 
Tire  Pressures,  Sizes ........... See  Tire-Loading 
Information label 
on  driver’s door. 
Wheel  Nut  Torque .......... 100  lb-ft  (140 N-m) 
Windshield  Washer  Fluid ....... 1 gallon  (0.37 L) 
*See Air Conditioning  Refrigerants  later in this  section. 
NOTE: All capacities  are approximate.  When adding, 
be  sure  to fill to the appropriate level, as  recommended 
in this  manual. 
Engine  Specifications 
Engine VIN Code ........................... E 
Firing Order 
...................... 1-2-3-4-5-6 
EngineType 
.............................. V6 
Horsepower 
............................. 180 
Thermostat Temperature  Specification 
................... 195°F  (91°C) 
6-64 
ProCarManuals.com