1998 Oldsmobile Cutlass instrument panel

Exterior Lamps
Rotate the turn signal lever end cap up one position to
turn on:
Parking Lamps
Side Marker Lamps
Taillamps
0 License Plate Lamps
Instrument Panel Lights Rotate the
turn signal lever end cap up two positions to
turn on:
Headlamps
0 Parking Lamps
Sidemarker Lamps
License Plate Lamps
Instrument Panel Lights
Rotate the switch to
OFF to turn all of the lamps off.
Lamps On Reminder
If you open the driver’s door and turn off the
ignition while leaving the lamps on, you
will hear a
warning chime.
2-36

Daytime Running Lamps
Daytune Running Lamps (DRL) can make it easier for
others to see the front of your vehicle during the day.
DRL
can be helpful in many different driving
conditions, but they can be especially helpful in the
short periods after dawn and before sunset.
The
DRL system will make your low-beam headlamps
come on at a reduced brightness when:
The ignition is on,
The headlamp switch is in the OFF position or you
have turned
on your parking lamps
The light sensor detects daytime light,
0 The parking brake is released and
The shift lever is not in PARK (P).
When the DRL system is on, the taillamps, sidemarker,
parking lamps and instrument panel lights will not
be illuminated.
The
DRL system will remain off any time your vehicle
is in
PARK (P) or the parking brake is engaged.
As with any vehicle, you should turn on the regular
headlamp system when you need it.

Fog Lamps
The button for your fog.
lamps is on the instrument
panel, to the left of the
I
steering wheel, beside
the instrument panel
intensity control.
When using fog lamps, the ignition must be on, as well
as the parking lamps or the low-beam headlamps.
Ish the top of the button to turn the fog lamps on. An
indicator light on the button will glow when the fog
.lamps
are on. Push the top of the button again to turn the
The fog lamps will
turn off whenever the high-beam
-headlamps
are turned on. When the high-beams are
turned
off, the fog lamps will come on again.
fog
lamps
off.
Interior Lamps . ..
Instrument Panel Intensity Control
You can brighten or dim the
instrument panel cluster
lights by rotating the switch,
located to the left
of the
steering wheel.
Illuminated EntryExit System
When you open any door, the lamps inside your
vehicle will
go on. These lamps will fade out after about
40 seconds, or when the ignition is turned on after all
doors have been closed. If the ignition was recently
turned
off, the lamps will fade out after four seconds.
These lamps will
also go on when you press the vehicle
symbol or
UNLOCK button on the optional remote lock
control transmitter.
2-38

Your instrument panel is designed to let you know at a glance how your vehicle is running. You’ll k\
now how fast
you’re going, how much fuel you’re using, and many other things you’ll need to drive \
safely and economically.
The main components of your instrument panel
are:
A. Fog Lamp Switch
B. Instrument Panel Intensity Control
C. Turn SignaVMultifunction Lever
D. Cruise Control Switches (If Equipped)
E. Horn
F. Instrument Panel Cluster
G. Windshield Wiper/Washer Lever
H. Ignition Switch
I. Hazard Warning Flashers Switch
J. Fuse Panels
K. Climate Control System
L. Accessory Power Outlets
M. Gear Shift Lever
N. Audio System
0. Park Brake Pedal
P. Tilt Wheel Lever
Q. Hood Release Lever
R. Trunk Release Button
S. Instrument Panel Cupholder
2-47

Instrument Panel Cluster
Your vehicle is equipped with this cluster, which includes indicator wdg lights and gages that me explained on the
following pages. Be sure to read them.
SYSTEM THEFT
CHECK OIL SERVICE
VEHICLE
SOON
CRUISE
2-48

Waiting to do repairs can be costly -- and even
dangerous.
So please get to know your warning lights
and gages. They’re a big help.
Safety Belt Reminder Light
When the key is turned to ON or START, a chime will
come on for about eight seconds to remind people to
fasten their safety belts, unless the driver’s safety belt is
already buckled.
Air Bag Readiness Light
There is an air bag readiness light on the instrument
panel, which shows the air bag symbol. The system
checks the air bag’s electrical system for malfunctions.
The light tells you if there is an electrical problem. The
system check includes the air bag sensor, the
air bag
modules, the wiring and the crash sensing and
diagnostic module. For more information on the
air bag
system, see
“Air Bag” in the Index.
I
The safety belt light will
also come on and stay on
for about
20 seconds,
then it will flash for about
55 seconds. This light will come on
when you start your engine,
and it will flash for a few
seconds. Then the light
should go out. This mans
the svstem is rea
, ..
If the driver’s belt is already buckled, neither the chime
nor the light will come on. If the air bag readiness light stays on after you start the
engine or comes
on when you are driving, your air bag
system may not work properly. Have your vehicle
serviced right away.
The
air bag readiness light should flash for a few
seconds when
you turn the ignition key to ON. If the
light doesn’t come on then, have it fixed
so it will be
ready to warn you
if there is a problem.
2-51

Comfort Controls
This section tells you how to make your air system
work for you. The climate control system with
air
conditioning uses ozone-friendly R- 134a refrigerant.
With this system, you can control the ventilation and heating in your vehicle. Your vehicle
also has
the flow-through ventilation system described later
in this section.
Climate Control System with
Air Conditioning
% Fan Knob
The left knob selects the force of air you want. Turn the
knob to the right to increase fan speed and to the left to
decrease fan speed. To turn the fan
off (which will also
turn the climate control system off), turn the knob all the
way to the left.
In any other setting, the fan will run
continuously. The fan must be on to run the air
conditioning compressor.
Temperature Knob
The center knob regulates the temperature of the air
coming through the system.
Mode Knob
The right control knob changes the functions of the
system.
/Ir VENT In this position most of the airflow comes
through the instrument panel outlets.
A small amount of
air comes through the floor vents. Set the center control
knob to the temperature desired.
.)rr BI-LEVEL: In this position the airflow comes
through the instrument panel outlets and through the
floor outlets. Set the center control knob to the
temperature desired.
+e
+e

’ . For quick cool-down on very hot days, use VENT with
’ . the temperature knob all the way in the blue area and the
; A/C and RECIRCULATION buttons pressed. If this
; setting is used for long periods of time, the air in your
vehicle may become too dry.
-1 For normal cooling on hot days, use VENT with the
’: temperature knob in the blue area and the A/C button
f pushed in. The system will bring in outside air and cool it.
Heating
On cold days, use FLOOR and the outside air button
I with the temperature knob all the way in the red area.
The system will bring in outside air, heat it and send it
to the floor outlets.
I Your vehicle has heat outlets that are directed toward
I
. : the rear seat. Keep the area under the front seats
’ I clear of obstructions so the heated air can reach the
rear seat passengers.
:If your vehicle has an engine coolant heater, you can
use it to help your system provide warm air faster
when it’s cold outside
(0 OF (- 18 O C) or lower). An
engine coolant heater warms the coolant your engine
and heating system use to provide heat. See “Engine
’ . Coolant Heater” in the Index.
-~ -. ... . ~ ~ ~ ~~ ~ ~
~ .. ~~ __ ~
Defogging and Defrosting Windows
Your system has two settings for clearing the front and
side windows.
For each setting, adjust the temperature
control as desired.
To defrost the front window quickly, rotate the
temperature control knob all the way in the red area.
Use DEFROST and adjust the fan to the highest speed.
To warrn passengers while keeping the front window
clean, use DEFOG.
Your vehicle is equipped with side window defogger
vents. The side window defogger vents are located
on the outside of the side instrument panel vents. To
defrost the side windows rotate the temperature control
knob all the way in the red area. Use
FLOOR and adjust
the fan to the highest speed. To control fogging of the
windows rotate the temperature control knob all the
way in the red area. Use DEFOG and adjust the fan
to the highest speed.
To defog the side windows while using air conditioning
use BI-LEVEL and adjust the fan to the highest speed and press the
A/C button. For added airflow to the side
windows aim the side vents toward the windows and
close the center vents.
RECIRCULATION will not work in DEFROST and
DEFOG. This is done to prevent recirculation of humid
inside air and allow the system to work properly.