1998 Mercury Villager steering

During ABS activation, a mechanical noise may be heard as the
ABS cycles. This is normal ABS operation.
Anti-lock brake system (ABS)
On vehicles equipped with an anti-lock braking system (ABS), a
noise from the hydraulic pump motor and pulsation in the
pedal may be observed during ABS braking events. Pedal pulsation
coupled with noise while braking under panic conditions or on
loose gravel, bumps, wet or snowy roads is normal and indicates
proper functioning of the vehicle's anti-lock brake system. If
the vehicle has continuous vibration or shudder while braking,
felt mainly in the steering wheel, the vehicle most likely needs
service.
The ABS system has self-check capabilities. The system turns on
the ABS warning light each time you start the engine. After
the engine is started and the ABS warning light turns off, the system
performs another test the first time the vehicle reaches 4 mph
(6 km/h). A mechanical noise may be heard as the ABS system
performs a self test. This is a normal part of the self test
feature. If a malfunction is found during this check, the ABS
warning light will come on.
You should always be careful when braking, even if your vehicle
has the ABS system. Heavy braking on roads with loose
surfaces such as snow or gravel, or roads with severe pavement
irregularities could also cause you to lose control of your
vehicle.
WARNING
If the anti-lock brake system warning light remains on or
comes on while driving, have the braking system
checked by a qualified service technician as soon as
possible.
216

The parking brake is not designed to stop a moving vehicle, but
you can use the parking brake to stop your vehicle in an
emergency if the service brakes fail. However, since the parking
brake does not stop your vehicle as quickly as the normal
brakes, the stopping distance will increase greatly.
Steering Your Vehicle
Your vehicle has power steering. Power steering uses energy
from the engine to help steer your vehicle.
If the amount of effort needed to steer your vehicle changes at a
constant vehicle speed, have the power steering system
checked. If the power steering system breaks down (or if the
engine is turned off), you can steer the vehicle manually but it takes
more effort.
Never hold the steering wheel in the extreme right or left
position for more than five seconds if the engine is running. This
can damage the power steering pump.
NOTE: After any severe impact such as striking large potholes,
sliding into curbs on icy roads, or a collision involving
the front end, have the front suspension and
steering checked for possible damage.
220

Automatic Transaxle Operation
Putting Your Vehicle in Gear
Your vehicle's gearshift lever is on the steering column. The
OVERDRIVE OFF/ON button is located at the end of the gearshift
lever. You can put the gearshift lever in any one of several
positions.
WARNING
Hold the brake pedal down while you move the gearshift
lever from position to position. If you do not hold the
brake pedal down, your vehicle may move unexpectedly
and injure someone.
Once you place the gearshift lever securely into position,
gradually release the brake pedal and use the accelerator as
necessary.
The steering column gearshift lever positions
Driving
221

Trailer Towing Tips
Before starting on a trip, practice turning, stopping and backing
in an area away from heavy traffic. Get to know the ªfeelº of
the vehicle/trailer combination.
Practice backing up. Back up very slowly, with someone outside
at the rear of your trailer to guide you. Place your hand at
the bottom of the steering wheel and move it in the direction you
want the rear of the trailer to swing. Slight movement of the
steering wheel results in a much larger movement of the rear of
the trailer.
When turning, drive slightly beyond the normal turning point so
the trailer wheels will clear curbs or other obstructions.
Allow more room for stopping with a trailer attached. Trailer
brakes should be applied first, whether manually or automatically
controlled, when approaching a stop.
For an easy-to-operate vehicle/trailer combination, the trailer
tongue load should be approximately 10-15% of the loaded trailer
weight.
Make a thorough check of your equipment before starting out on
the road. After you have traveled about 50 miles (80 km), stop
in a protected area and double-check your hitch and electrical
connections. Also check trailer wheel lug nuts for tightness.
When stopped in traffic for long periods of time in hot weather,
place the gearshift selector lever in Park (P) to increase the
engine idle speed. This aids in engine cooling and air conditioner
efficiency. If the engine overheats, press the air intake selector
button to select the fresh air position to stop the air conditioner
compressor. Increase the engine speed for a short time.
Vehicles with trailers should not be parked on a grade. However,
if you must park on a grade, place wheel chocks under the
trailer's wheels as follows:
Driving
237

Changing a Flat Tire
If you get a flat tire while you are driving, do not apply the
brake heavily. Instead, gradually decrease the speed. Hold the
steering wheel firmly and slowly move to a safe place on the side
of the road. Park on a level spot, turn off the ignition, set the
parking brake, and turn on the hazard flashers.
The Temporary Spare Tire
Your vehicle has a temporary spare tire (unless you ordered the
optional full-size spare tire). This spare tire is smaller than a
regular tire and is designed for emergency use only. Use it only
when you get a flat tire and replace it as soon as you can. This spare
tire is marked with the words TEMPORARY USE ONLY so
that you can easily identify it.
WARNING
If you use the temporary spare tire continuously or do not
follow these precautions, the tire could fail, causing
you to lose control of the vehicle, possibly injuring yourself
or others.
When you drive with the temporary spare tire, DO NOT:
mexceed 50 mph (80 km/h) under any circumstances
mload your vehicle so that it is heavier than the maximum
vehicle load rating listed on the tire decal
mtow a trailer
muse tire chains
mtry to repair the temporary spare tire or remove it from its
wheel
muse the wheel for any other type of vehicle
254

Engine Coolant Drain and Flush
To have your engine coolant drained, see your Ford or
Lincoln-Mercury dealer or refer to the procedure in the Service
Manual.
Power Steering Fluid
Check the level of the power steering fluid at least twice a year
(i.e., every Spring and Fall).
Checking and Adding Power Steering Fluid
1. Start the engine and let it run until the power steering fluid
reaches normal operating temperature. The power steering
fluid will be at the right temperature when the engine coolant
temperature gauge in the instrument cluster is near the
center of the NORMAL operating temperature range.
2. While the engine idles, turn the steering wheel back and forth
several times. Make sure that the cap assembly is installed at
this time.
3. Then turn the engine off.
4. Check the fluid level in the power steering fluid reservoir.
Maintenance and Care
289

5. If the power steering fluid is low, add fluid in small
amounts, continuously checking the level, until the fluid is
between the minimum (MIN) and maximum (MAX) lines on the
reservoir. Do not overfill. To find out how much fluid your
vehicle's reservoir for the power steering fluid will hold, see
Refill Capacities, Motorcraft Parts, and Lubricant Specifications
in theCapacities and Specificationschapter.
Use only power steering fluid that meets Ford Specification such
as MERCONtATF XT-2-QDX (or equivalent).
NOTE: If the power steering fluid is low, do not drive your
vehicle for a long period of time before adding fluid.
This can damage the power steering pump.
If you must check the power steering fluid when it is cold, make
sure that the fluid reaches at least the minimum (MIN) mark.
The reading will only be accurate if the fluid temperature is
approximately 70É to 100É F (21É to 38É C).
Power steering fluid reservoir
290

Engine Compartment
Your vehicle has a 3.0 liter EFI, V-6 engine. The following
illustration will show a diagram of your engine and where you
can find items that you should service regularly.
1. Automatic Transmission Fluid Dipstick
2. Engine Coolant Reservoir
3. Brake Fluid Reservoir
4. Air Filter
5. Battery
6. Engine Compartment Fuse and Relay Box
7. Radiator Cap
8. Engine Oil Filler Cap
9. Engine Oil Dipstick
10. Windshield Washer Fluid Reservoir
11. Engine Compartment Relay Box
12. Power Steering Fluid Reservoir
Capacities and Specifications
341