1998 Lexus LS400 belt

COMFORT ADJUSTMENT
107
16L1661
2. Fully extend the shoulder belt to put it in the lock mode. When
the belt is then retracted slightly, it cannot be extended.
To hold the convertible seat securely, make sure the belt is in the lock
mode before letting the belt to retract.
16L1671
3. While pressing the convertible seat firmly against the seat
cushion and seatback, let the shoulder belt retract as far as it will go
to hold the convertible seat securely.

COMFORT ADJUSTMENT
108
16L1681
CAUTION
Push and pull the child restraint system in different directions
to be sure it is secure. Follow all the installation instructions
provided by its manufacturer.
16L1691
4. To remove the convertible seat, press the bucklerelease button
and allow the belt to retract completely. The belt will move freely
again and be ready to work for an adult or older child passenger.

COMFORT ADJUSTMENT
110
16L1702
1. Sit the child on a booster seat. Run the lap and shoulder belt
through or around the booster seat and child following the
instructions provided by its manufacturer and insert the tab into the
buckle.
Make sure the shoulder belt is correctly across the child’s shoulder
and that the lap belt is positioned as low as possible on child’s hips.
See ”Seat belts” on page 80 for details.
CAUTION
Always make sure the shoulder belt is positioned across the
center of child’s shoulder. The belt should be kept away
from child’s neck, but not falling off child’s shoulder.
Failure to do so could reduce the amount of protection in an
accident and cause serious injuries in a collision.
Highpositioned lap belts and loosefitting belts both could
cause serious injuries due to sliding under the lap belt
during a collision or other unintended result. Keep the lap
belt positioned as low on hip as possible.
For child’s safety, do not place the shoulder belt under
child’s arm.
After inserting the tab, make sure the tab and buckle are
locked and that the lap and shoulder portions of the belt are
not twisted.
Do not insert coins, clips, etc. in the buckle as this may
prevent you from properly latching the tab and buckle.
If the seat belt does not function normally, immediately
contact your Lexus dealer. Do not use the seat until the seat
belt is fixed. It cannot protect your child from injury.

COMFORT ADJUSTMENT
111
16L1711
2. To remove the child restraint system, press the bucklerelease
button and allow the belt to retract.Top strap anchors and locations
16L156
If your child restraint system requires the use of a top strap, latch
the hook onto the anchor bracket and tighten the top strap.
See the following instructions to install the anchor bracket.

COMFORT ADJUSTMENT
113
16L0401
1
Bolt 2
Anchor bracket 3
Spacer
4. Insert a 15 mm (0.6 in.) spacer, and tighten down the anchor
bracket for your child restraint system with a bolt. Torque the bolt
to 16.5 24.7 N·m (1.68 2.52 kgf·m, 12.2 18.2 ft·lbf.).
To comply with Canada Motor Vehicle Safety Standards, vehicles
sold in Canada are provided with a bracket set in the glovebox.
DRIVING POSITION MEMORY
SYSTEM
The micro computer can memorize the position of the driver’s seat,
the height of the shoulder belt anchor of the driver’s seat belt, and the
positions of the tilt and telescopic steering, and outside rear view
mirrors. Two different driving position profiles can be entered into
the computer’s memory.
Recording a driving position in the computer’s memory can only be
done when the ignition key is in the ”ON” position and the shift lever
is in the ”P” position.
Setting a driving position
16L055
1. Adjust the driver’s seat, driver’s shoulder belt anchor, tilt and
telescopic steering and outside rear view mirrors to the desired
position.
2. While pushing the ”SET” button, push button ”1” or ”2” until
the signal beeps.

STARTING AND DRIVING
157
BEFORE STARTING THE ENGINE
1. Check the area around the vehicle before entering it.
2. Adjust seat position, seatback angle, head restraint height and
steering wheel angle.
3. Adjust inside and outside rear view mirrors.
4. Lock all doors.
5. Fasten seat belts.
Remember to check that the service reminder indicators function
when turning the key to ”ON”, and check the fuel gauge to see that
you have sufficient fuel.
IGNITION SWITCH WITH
STEERING LOCK
31L0011
”START” Starter motor on. The key will return to the ”ON”
position when released.
For starting tips, see page 159.
”ON” Engine on and all accessories on.
This is the normal driving position.
NOTICE
Do not leave the key in the ”ON” position if the engine is not
running. The battery will discharge and the electronic ignition
system/distributor ignition system could be damaged.
”ACC” Accessories such as the radio operate, but the engine
is off.
If you leave the key in the ”ACC” or ”LOCK” position and open the

IN CASE OF AN EMERGENCY
197 B: If no steam is coming from your engine:
Leave the engine running and turn off the air conditioning. Check
the following.
Is the cooling fan operating?
Is the coolant in the acceptable range?
Is the engine drive belt O.K.?
CAUTION
When the engine is running, keep hands and clothing away
from the moving fan and engine drive belt.
Do not attempt to remove the radiator cap when the engine
and radiator are hot. Serious injury could result from
scalding hot fluid and steam blown out under pressure.
If the cooling fan is not operating or the coolant is not in the
acceptable range, turn off the engine and call your Lexus dealer.
If both conditions are O.K., after the engine coolant temperature has
cooled to normal, continue driving your vehicle.
If the engine coolant temperature does not cool down, or your
vehicle overheats again, have it checked as soon as possible by your
Lexus dealer.
IF YOU HAVE A FLAT TIRE
1. Reduce your speed gradually, keeping a straight line. Move
cautiously off the road to a safe place well away from the traffic.
Avoid stopping on the center divider of a highway. Park on a level
spot with firm ground.
2. Stop the engine and turn on your emergency flashers.
3. Firmly set the parking brake and put the transmission in ”P”.
4. Have everyone get out of the vehicle on the side away from
traffic.
5. Read the following instructions thoroughly.
NOTICE
For vehicles equipped with the height control switch, be sure to
turn the ignition switch off before jacking. If this is not done, the
vehicle height adjustment function will operate, which may
cause body damage.
CAUTION
When jacking, be sure to observe the following to reduce the
possibility of personal injury:
Follow jacking instructions.
Do not start or run the engine while your vehicle is
supported by the jack.

MAINTENANCE
215 Tire rotation
Rotate the tires every 12000 km (7500 miles). See page 242 for
additional information.
Fluid leaks
Check underneath for leaking fuel, oil, water or other fluid after the
vehicle has been parked for a while. If you smell fuel fumes or notice
any leak, have the cause found and corrected immediately.
Doors and engine hood
Check that all doors, including trunk lid, operate smoothly and all
latches lock securely. Make sure the engine hood secondary latch
secures the hood when the primary latch is released.
Vehicle interior
Items listed below should be checked regularly, e.g. while
performing periodic services, cleaning the vehicle, etc.
Lights
Make sure the headlights, stop lights, tail lights, turn signal lights,
and other lights are working. Check headlight aim.
Service reminder indicators and warning buzzers
Check that all service reminder indicators and warning buzzers
function properly.Steering wheel
Check that it has the specified freeplay. Be alert for changes in
steering condition, such as hard steering, excessive freeplay or
strange noise.
Seats
Check that all front seat controls such as seat adjusters, seatback
recliner, etc. operate smoothly. Check that the head restraints move
up and down smoothly and that the locks hold securely in any latched
position.
Seat belts
Check that the seat belt system such as buckles, retractors and
anchors operate properly and smoothly. Make sure the belt webbing
is not cut, frayed, worn or damaged.
Accelerator pedal
Check the pedal for smooth operation and uneven pedal effort or
catching.
Brake pedal
Check the pedal for smooth operation and the proper clearance and
freeplay. Check the brake booster function.
Brakes
At a safe place, check that the brakes do not pull to one side when
applied.