1998 Lexus LS400 ignition

SWITCHES
32
SEAT HEATER SWITCHES
12L0132
The seat heater has two switches one marked ”L” (for the left
seat) and the other marked ”R” (for the right seat). Push these
switches to turn the respective seat heater on, and push the
switches again to turn them off.
The ignition key must be in the ”ON” position.
CAUTION
Occupants must use caution when operating the seat heater
because it may make them feel too hot or cause burns at low
temperatures (erythema, varicella). Use extra caution for;
Baby, small child, elderly person, sick person or
handicapped person
Persons who have delicate skin
Persons who are exhausted
Persons who have taken alcohol or drugs which induce
sleep (sleeping drug, cold remedy, etc.)
To prevent the seat overheating, do not use the seat heater with
a blanket, cushion, or other insulating objects which cover the
seat.
NOTICE
Do not put unevenly weighted objects on the seat and do not
stick sharp objects (needles, nails, etc.) into the seat.
When cleaning the seats, do not use organic substances
(paint thinner, benzine, alcohol, gasoline, etc.). They may
damage the heater and seat surface.
To prevent the battery from being discharging, turn the
switches on when the engine is running.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
34
FUEL GAUGE
13L0011
Low fuel level warning light
The gauge is displayed when the ignition switch is on and
indicates the approximate quantity of fuel remaining in the tank.
It is a good idea to keep the tank over 1/4 full.
If the fuel level approaches ”E” or the low fuel level warning light
comes on, fill the fuel tank as soon as possible.
On inclines or curves, due to the movement of fuel in the tank, the
fuel gauge needle may fluctuate or the low fuel level warning light
may come on earlier than usual.
If the fuel tank is completely empty, the malfunction indicator lamp
comes on. Fill the fuel tank immediately.
The indicator lamp goes off after driving several times. If the
indicator lamp does not go off, contact your Lexus dealer as soon as
possible.
See the inner back cover for fuel capacity and recommended fuelselection.
ENGINE COOLANT
TEMPERATURE GAUGE
13L0022
Normal range
The gauge indicates the engine coolant temperature when the
ignition switch is on. The engine operating temperature will
vary with changes in weather and engine load.
If the needle points to the red zone or higher, stop your vehicle and
allow the engine to cool.
Your vehicle may overheat during severe operating conditions, such
as:
Driving up a long hill on a hot day.
Reducing speed or stopping after high speed driving.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
38If the brake fluid level is correct ...
Have the warning system checked by your Lexus dealer.
(b) Driver’s Seat Belt Reminder Light and Buzzer
Once the ignition key is turned to ”ON” or ”START”, the reminder
light flashes and buzzer sounds if the driver’s seat belt is not
fastened. Unless the driver fastens the belt, the light stays flashing
and the buzzer stops after about 4 to 8 seconds.
(c) Front Passenger’s Seat Belt Reminder Light
Once the ignition key is turned to ”ON” or ”START”, the reminder
light flashes if a passenger sits in the front passenger seat and does
not fasten the seat belt. Unless the front passenger fastens the belt,
the light stays flashing.
If luggage load is placed on the front passenger seat, depending on
its weight and how it is placed on the seat, builtin sensors in the seat
cushion may detect the pressure, causing the reminder light to come
on.
(d) SRS Warning Light
The indicators come on when the ignition key is turned to the
”ACC” or ”ON” position. It goes off after about 6 seconds. This
means the SRS is operating properly.
The SRS warning light system monitors the airbag sensor
assemblies, inflators, seat belt pretensioners, warning light,
interconnecting wiring and power sources.
If either of the following conditions occurs, this indicates a
malfunction somewhere in the parts monitored by the warning light
system. Contact your Lexus dealer as soon as possible to service the
vehicle.
The light does not come on as described above.
The light stays on or flashes.
The light comes on or starts flashing while driving.
If the light stays on, it indicates that the driver and front passenger
airbags fail. If the light flashes, the side airbags and/or seat belt
pretensioners fail.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
39
(e) Discharge Warning Light
This light warns that the battery is being discharged.
If it comes on while you are driving, stop the vehicle, turn off the
engine, and check for the cause. Look first at the engine drive belt.
If it is loose or broken, the generator will not charge the battery
properly.
If the belt is O.K., there is a problem somewhere in the charging
system.
The engine ignition will continue to operate, however, until the
battery is discharged. Turn off the air conditioning, blower, radio,
etc., and drive directly to the nearest Lexus dealer or repair shop.
NOTICE
Do not continue driving if the engine drive belt is broken or
loose.
(f) Malfunction Indicator Lamp
This lamp comes on in the following cases.
a. The fuel tank is completely empty. (See ”Fuel gauge” on page 34
for instructions.)
b. The fuel tank cap is not tightened securely. (See ”Fuel tank cap”
on page 65 for instructions.)
c. There is a problem somewhere in your engine electrical system
or electronic throttle control system.
If it comes on while you are driving in case c., have your vehicle
checked/repaired by your Lexus dealer as soon as possible.
(g) ”ABS” Warning Light
This light warns that there is a problem somewhere in your antilock
brake system.
If the light comes on while you are driving, have your vehicle
checked by your Lexus dealer as soon as possible.
The light will come on when the ignition key is turned to ”ON”, and
will go off after about a few seconds.
When the ”ABS” warning light is on (and the brake system warning
light is off), the brake system operates conventionally but antilock
brake system is not assisting brake performance so that the wheels
could lock up during a sudden brake or braking on slippery road
surfaces.
(h) Open Door Warning Light
This light remains on until all the doors are completely closed.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
40
(i) Low Fuel Level Warning Light
This light comes on when the fuel level in the tank becomes nearly
empty. Fill the tank as soon as possible.
On inclines or curves, due to the movement of fuel in the tank, the
low fuel level warning light may come on earlier than usual.
(j) Key Reminder Buzzer
This buzzer reminds you to remove the key when you open the
driver’s door with the ignition key in the ”ACC” or ”LOCK”
position.
How to check all the service reminder indicators
(except the low fuel level warning light):
1. Apply the parking brake.
2. Open the door.
The following service reminder indicator should come on. It goes
off when you close the door completely.
3. Turn the ignition key to ”ACC”.
The following service reminder indicator should come on. It goes
off after 6 seconds.
4. Turn the ignition key to ”ON”.
The following service reminder indicators should come on.

or
The following service reminder indicators go off after 3 seconds.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
41

or
5. Turn the ignition key to ”START”.
The following service reminder indicator should come on.
or
If any service reminder indicator or warning buzzer does not
function, either the bulb is burned out or circuit is in need of repair.
Have it checked by your Lexus dealer as soon as possible.
MULTI INFORMATION DISPLAY
13L0421
The multi information display provides cruise information on
your vehicle’s driving condition and warning messages if your
vehicle has trouble. During ordinary driving, cruise
information is shown in the display. However, if any problem
occurs in your vehicle, a warning message appears in place of
cruise information. To change to the cruise information display,
push the ”FUNCTION” button.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
42
(a) Cruise information
13L0491
The following information is shown with the ignition switch
turned on. Each time you push the ”MODE” button, the
displayed information is changed.
Available driving distance
Average fuel consumption
Current fuel consumption
Average fuel consumption after being refueled
Driving distance after being refueled
Elapsed time
Average vehicle speed
The displayed values of cruise information indicate the general
driving condition, so those may not show precise and actual
condition.
Available driving distance
W24
When the fuel gauge indicates around ”F”
W25W25
When the fuel gauge indicates around middle
W26
When the fuel gauge indicates around ”E”
Available driving distance with the remaining fuel is calculated
and displayed depending on the amount of remaining fuel.
Average fuel consumption
W27
W27
The average fuel consumption is calculated and displayed based
on the total driving distance and the total fuel consumption with
the engine running.
The value is updated every 10 seconds.
To calculate from the beginning, push the ”RESET” button.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
43
Current fuel consumption
W28
W28
The current fuel consumption is calculated and displayed based
on the driving distance and the fuel consumption for 2 seconds
with the engine running.
The value is updated every 2 seconds.
If you are driving at low speeds just before stopping, the accurate
figure may not be shown.
Average fuel consumption after being refueled
W29
W29
The average fuel consumption after being refueled is calculated
and displayed based on the total driving distance and the total
fuel consumption after being refueled.
The value is updated every 10 seconds.
To calculate from the beginning, push the ”RESET” button.
Driving distance after being refueled
W30
W30
The driving distance after being refueled is displayed.
Elapsed time
W31
W31
The total time during the engine running is displayed.
When the engine is started again after the ignition is off, the driving
time is added to the previous value. Up to 99 hours 59 minutes can
be displayed. When the driving time exceeds 99 hours 59 minutes,
the display returns to 0 and recounting starts.
To count from the beginning, push the ”RESET” button.
Average vehicle speed
W32
W32
The average vehicle speed is calculated and displayed based on
the total driving distance and the total driving time with the
engine running.
The displayed value is updated every 10 seconds.
To calculate from the beginning, push the ”RESET” button.