SWITCHES
26The time interval between sweeps is shortened when the vehicle
speed increases. When the vehicle speed reaches more than about
20 km/h (12 mph) with the interval adjuster in ”F” position, the time
interval becomes the shortest 1.5 seconds.
If you stop the vehicle with the wiper switch in the ”LO” position,
the wiper speed automatically changes from low speed to
intermittent operation speed.* This function does not work when the
interval adjuster is in the ”F” position.
NOTE: *This feature can be set inoperative. Ask your Lexus
dealer for details.
For mist wiper operation (a single wipe), pull the lever toward
you and release it.
To make the washer squirt, push the button on the end of the
lever.
If the wiper lever is in the ”OFF” position, the wipers will
automatically operate a couple of times and a few seconds later,
make a single wipe again to sweep the windshield completely.* The
last sweep does not happen if the vehicle speed exceeds about 170
km/h (106 mph).
NOTE: *The last single wipe can be set inoperative. Ask your
Lexus dealer for details.
The warning message ”LOW WASHER FLUID” is displayed in the
multi information display when the fluid level in the tank becomes
nearly empty. For information on adding washer fluid, see ”Adding
washer fluid” on page 261.
In cold weather, warm the windshield with the defroster before using
the washer. This will help prevent icing, which could block your
vision.
NOTICE
Do not operate the wipers if the windshield is dry. It may scratch
the glass.
INTRODUCTION
222Remember that battery and ignition cables carry high
currents or voltages. Be careful of accidentally causing a
short circuit.
Before closing the engine hood, check to see that you have not
forgotten any tools, rags, etc.
Do not drive with the air cleaner removed, or excessive engine
wear could result. Also backfiring could cause a fire in the
engine compartment.
Do not overfill automatic transmission fluid, or the
transmission could be damaged.
Be careful not to scratch the glass surface with the wiper
frame.
PARTS AND TOOLS
Here is a list of parts and tools you will need to perform
do it yourself maintenance. Remember all Lexus parts are
designed in metric sizes, so your tools must be metric.
Checking the engine oil level
Parts (if level is low):
Use API grade SH, ”Energy Conserving II” or SJ,
”Energy Conserving” multigrade engine oil or ILSAC
multigrade engine oil. For recommended oil viscosity, see page
232.
Tools:
Rag or paper towel
Funnel (only for adding oil)
Checking the engine coolant level
Parts (if level is low):
Ethylene glycol coolant
Demineralized or distilled water
Tools:
Funnel (only for adding coolant)