1998 Lexus LS400 lights

IN CASE OF AN EMERGENCY
195
40L002-7
5
Discharged battery 6
Booster battery
JUMP STARTING PROCEDURE
1. If the booster battery is installed in another vehicle, make sure the
vehicles are not touching. Turn off all unnecessary lights and
accessories.2. If required, remove all the vent plugs from the booster battery.
Lay a cloth over the open vents on the booster battery. (This helps
reduce the explosion hazard, personal injuries and burns.)
If the booster battery is an extended maintenance interval battery, it
is not necessary to remove the vent plugs.
3. If the engine in the vehicle with the booster battery is not running,
start it and let it run for about 5 minutes. During jump starting, run
the engine at about 2000 rpm with the accelerator pedal lightly
depressed.
4. Locate positive (+) and negative () terminals of each battery.
Connect the jumper cables in the exact order (
1
2
3
4
)
shown in the illustration.
1
Connect a positive (red) jumper cable clamp to the positive (+)
terminal of the discharged battery.
2
Connect the clamp at the other end of the positive (red) cable
to the positive (+) terminal of the booster battery.
3
Connect a negative (black) cable clamp to the negative ()
terminal of the booster battery.
4
Connect the clamp at the other end of the negative (black) cable
to a solid, stationary, unpainted metallic point (e.g. engine
hanger) away from the battery. Do not connect it to or near any
part that moves when the engine is cranked.

IN CASE OF AN EMERGENCY
196
CAUTION
When making the connections, to avoid serious injury, do not
lean over the battery or accidentally let the jumper cables or
clamps touch anything except the correct battery terminals or
the ground.
5. Start your engine in the normal way. After starting, run it at about
2000 rpm for several minutes with the accelerator pedal lightly
depressed.
6. Carefully disconnect the cables in the exact reverse order: the
negative cable and then the positive cable.
7. Carefully dispose of the battery cover cloths which may now
contain sulfuric acid.
8. If removed, replace all the battery vent plugs.
If the cause of your battery discharging is not apparent (for example,
lights left on), you should have it checked.
IF YOUR VEHICLE OVERHEATS
If your engine coolant temperature gauge indicates overheating,
if you experience a loss of power, or if you hear a loud knocking
or pinging noise, the engine has probably overheated.
When the engine overheats
Pull safely off the road, stop the vehicle and turn on your emergency
flashers. Put the transmission in ”P” and apply the parking brake.
A: If steam is coming from your engine:
Turn off the engine. Leave the hood closed until there is no sign of
steam or coolant. Your engine could have been seriously damaged
already. Call your Lexus dealer for assistance.
CAUTION
To help avoid personal injury, keep the hood closed until there
is no steam. Escaping steam or coolant is sign of very high
pressure.

MAINTENANCE
215 Tire rotation
Rotate the tires every 12000 km (7500 miles). See page 242 for
additional information.
Fluid leaks
Check underneath for leaking fuel, oil, water or other fluid after the
vehicle has been parked for a while. If you smell fuel fumes or notice
any leak, have the cause found and corrected immediately.
Doors and engine hood
Check that all doors, including trunk lid, operate smoothly and all
latches lock securely. Make sure the engine hood secondary latch
secures the hood when the primary latch is released.
Vehicle interior
Items listed below should be checked regularly, e.g. while
performing periodic services, cleaning the vehicle, etc.
Lights
Make sure the headlights, stop lights, tail lights, turn signal lights,
and other lights are working. Check headlight aim.
Service reminder indicators and warning buzzers
Check that all service reminder indicators and warning buzzers
function properly.Steering wheel
Check that it has the specified freeplay. Be alert for changes in
steering condition, such as hard steering, excessive freeplay or
strange noise.
Seats
Check that all front seat controls such as seat adjusters, seatback
recliner, etc. operate smoothly. Check that the head restraints move
up and down smoothly and that the locks hold securely in any latched
position.
Seat belts
Check that the seat belt system such as buckles, retractors and
anchors operate properly and smoothly. Make sure the belt webbing
is not cut, frayed, worn or damaged.
Accelerator pedal
Check the pedal for smooth operation and uneven pedal effort or
catching.
Brake pedal
Check the pedal for smooth operation and the proper clearance and
freeplay. Check the brake booster function.
Brakes
At a safe place, check that the brakes do not pull to one side when
applied.

ENGINE
226 COOLING SYSTEM
Capacity
Coolant type
10.8 L (11.4 qt., 10.4 lmp.qt.)
Ethylene glycol coolant (Do not use alcohol type.)
FUEL
Fuel type
Octane rating
Only UNLEADED
91 (Research octane number 96) or higher
IGNITION SYSTEM
Spark plug Make DENSO
NGK
Gap
SK20R11
IFR6A11
1.1 mm (0.043 in.)
ELECTRICAL SYSTEM
Battery Maintenance type battery
Specific gravity reading at 20C (68F):
Charging rates Quick charge
Slow charge
Nonmaintenance battery
Open voltage at 20C (68F):
Charging rates
1.260 Fully charged
1.160 Half charged
1.060 Discharged
15A max.
5A max.
12.7V Fully charged
12.3V Half charged
11.9V Discharged
[Voltage that is checked 20 minutes after the key is removed with
all the lights turned off]
5A max.

ELECTRICAL COMPONENTS
251
No.FUSEAMPERECIRCUIT
1 TURN7.5Turn signal lights
2 WIPER20Windshield wipers
3 HEATER10
Air conditioning system,
Rear window defogger, Multiport
fuel injection system/sequential
multiport fuel injection system
4 FR FOG15Fog lights
5 ECUIG10Power steering control system,
Charging system,
Vehicle skid control system
6 PWRIG15
Automatic headlight leveling
system, Moon roof,
Headlight cleaner,
Power seat switch,
Tilt and telescopic steering, Shift
lock system
7 GAUGE10
Gauges and meters, service
reminder indicators and warning
buzzers,
Backup lights,
Vehicle skid control system,
Multiport fuel injection
system/sequential multiport fuel
injection system, Automatic
transmission system
8 IGN10SRS, Multiport fuel injection
system/sequential multiport fuel
injection system
9 RR FOG7.5No circuit
10 FUEL OPN10Fuel opener system
No.FUSEAMPERECIRCUIT
11 RR CIG15Rear cigarette lighter,
Power outlet
12 FR CIG15Front cigarette lighter, SRS
13 A/C7.5Air conditioning system
14 P RR
DOOR20Rear door lock,
Rear power window
15 STOP LP25Stop lights,
High mounted stop light
16 RADIO
NO.215
Audio system,
Outside rear view mirror,
Shift lock system,
Air conditioning system
17 PANEL7.5Instrument panel lights,
Air conditioning system, Glovebox
light, Audio system
18 STARTER7.5
Starting system,
Automatic transmission system,
Multiport fuel injection
system/sequential multiport fuel
injection system
19 TAIL7.5Tail lights, Side marker lights,
License plate lights
20 STOPS7.5
Shift lock system,
Height control system, Antilock
brake system,
Vehicle skid control system
21 RR S/HTR15No circuit
22 WASHER20Windshield washer

ELECTRICAL COMPONENTS
252
No.FUSEAMPERECIRCUIT
23 AIR SUS20Height control system
24 D RR
DOOR20Rear door lock,
Rear power window
25 HORN10Horns
26 ETCS15Electronic throttle control system
27 HLP L
UPR10Lefthand headlight (high beam)
28 HLP R
UPR10Righthand headlight (high beam)
29 EFI NO.210Emission control system
30 MIRHTR15Outside rear view mirror defogger
31 FR S/HTR15Seat heater
32 ALTS7.5Charging system
33 TEL15Telephone
34 CRT15Multi information display
35 RADIO
NO.120Audio system
36 MPXB10Power window, Door lock,
Tilt and telescopic steering
37 ECUB7.5Vehicle skid control system,
Daytime running light system
38 HAZ10Emergency flashers
No.FUSEAMPERECIRCUIT
39 EFI NO.120Multiport fuel injection
system/sequential multiport fuel
injection system
40 DOME10Interior light, Vanity lights,
Foot lights, Rear personal light,
Garage door opener
41 OBD7.5Onboard diagnosis system
42 DRL10Vehicles sold in Canada
Daytime running light system
43 HLP R
LW R15Righthand headlight (low beam)
44 HLP L
LW R15Lefthand headlight (low beam)

ELECTRICAL COMPONENTS
260
CHECKING THE CARTRIDGE TYPE
FUSES
64L016-3
1
Good 2
Melted
If the headlights or other electrical components do not work and
the blade type fuses are O.K., check the cartridge type fuses. If
any of the cartridge type fuses are blown, they must be replaced.
If there is an overload in the circuits from the battery, the fuses are
designed to blow before the entire wiring harness is damaged.
NOTICE
Before replacing the fuses, have the cause of electrical overload
determined and repaired by your Lexus dealer.
CAUTION
Always use a genuine Lexus fuse or equivalent for
replacement. Never install an ordinary wireeven for a
temporary fix. This may cause extensive damage and possibly
a fire.

ELECTRICAL COMPONENTS
264
REPLACING LIGHT BULBS
The illustration on the following pages show the locations of light
bulbs. If it is necessary to replace a bulb, take your vehicle to your
Lexus dealer as soon as possible. Use bulbs with the bulb numbers
and wattage ratings given in the table.
CAUTION
Do not disassemble, repair or take apart the low beam
headlight bulbs, connector, power supply circuits and
rotated components. Or you may be injured by electric
shocks. Call your dealer when the headlights fail to work
or have to be replaced or disposed of.
Halogen bulbs have pressurized gas inside and require
special handling. They can burst or shatter if scratched or
dropped. Hold a bulb only by its plastic or metal case. Do
not touch the glass part of a bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
LIGHT LOCATION
64L022-4
Light Bulbs Bulb No. W Type
1 Headlights (High beam) HB3 60 A
2 Parking lights 5 D
3 Headlights (Low beam)
Discharge bulbs D2R 35 B
Halogen bulbs HB4 51 C
4 Front turn signal lights 21 D
5 Front side marker lights 5 D
6 Fog lights HB4 51 C