INTRODUCTION189
NOTICE
Remember that battery and ignition cables carry high currents or
voltages. Be careful of accidentally causing a short circuit.
Before closing the engine hood, check to see that you have not
forgotten any tools, rags, etc.
Do not drive with the air cleaner removed, or excessive engine wear
could result. Also backfiring could cause a fire in the engine
compartment.
Do not overfill automatic transmission fluid, or the transmission could
be damaged.
Be careful not to scratch the glass surface with the wiper frame.
PARTS AND TOOLS
Here is a list of parts and tools you will need to perform do±it±y\
ourself
maintenance. Remember all Lexus parts are designed in metric sizes, so your
tools must be metric.
Checking the engine oil level
Parts (if level is low):
Use API grade SH, ºEnergy±Conserving IIº or SJ, ºEnergy±Conservingº
multigrade engine oil or ILSAC multigrade engine oil. For recommended
oil viscosity, see page 200.
Tools:
Rag or paper towel
Funnel (only for adding oil)
Checking the engine coolant level
Parts (if level is low):
Ethylene±glycol coolant
Demineralized or distilled water
Tools:
Funnel (only for adding coolant)
ENGINE199
1
Add oil 2O.K. 3Too full
4. Pull the dipstick out and look at the oil level on the end. If it is between
the full line (
5 ) and the low line ( 4 ), it is O.K.
62E003±1
If the oil level is below or only slightly above the low line, add engin\
e oil
of the same type as already in the engine.
Remove the oil filler cap and add engine oil a little at a time, checking the
dipstick. The approximate quantity of oil needed to fill between the low line
and the full line on the dipstick is indicated below for reference.
When the level reaches within the correct range, return the filler cap and t\
urn
the cap clockwise until you hear a click.
Oil quantity. L (qt., lmp. qt.) 1.5 (1.6, 1.3)
NOTICE
Avoid overfilling, or the engine could be damaged. Check the oil level on
the dipstick once again after adding the oil.
