1998 Lexus ES300 child restraint

COMFORT ADJUSTMENT93
High±positioned lap belts and loose±fitting belts both could cause
serious injuries due to sliding under the lap belt during a collision
or other unintended result. Keep the lap belt positioned as low on
hip as possible.
 For child's safety, do not place the shoulder belt under child's arm.
 After inserting the tab, make sure the tab and buckle are locked and
that the lap and shoulder portions of the belt are not twisted.
 Do not insert coins, clips, etc. in the buckle as this may prevent you
from properly latching the tab and buckle.
 If the seat belt does not function normally, immediately contact your
Lexus dealer. Do not use the seat until the seat belt is fixed. It cannot
protect your child from injury.
16E117±2
2. To remove the child restraint system, press the buckle±release button a\
nd
allow the belt to retract.

COMFORT ADJUSTMENT
94
Top strap anchors and locations
16E032
If your child restraint system requires the use of a top strap, latch the
hook onto the anchor bracket and tighten the top strap.
See the following instructions to install the anchor bracket.
16E033

1
Center 2341.6 mm (13.4 in.) 392 mm (3.6 in.)
460 mm (2.4 in.)
1. Run your fingers across the trim of the filler panel to locate the holes
underneath it in the positions shown above.
2. Make a hole in the covering directly above the hole in the filler panel.\

COMFORT ADJUSTMENT95
16E034±1

1Bolt 2Anchor bracket 3Spacer
3. Insert a 15 mm (0.6 in.) spacer, and tighten down the anchor bracket for
your child restraint system with a bolt. Torque the bolt to 16.5 ± 24.7 N´m
(1.68 ±2.52 kgf´m, 12.2 ± 18.2 ft´lbf.).
To comply with Canada Motor Vehicle Safety Standards, vehicles sold in
Canada are provided with a bracket set in the glovebox, designed for use with
the center location.
DRIVING POSITION MEMORY SYSTEM
The micro computer can memorize the position of the driver's seat. Two
different driving position profiles can be entered into the computer's memory.
Recording a driving position in the computer's memory can only be done
when the ignition key is in the ºONº position and the shift lever is i\
n the ºPº
position.
Setting a driving position
16E047
1. Adjust the driver's seat to the desired position.
2. While pushing the ºSETº button, push button º1º or º2º\
until the
signal beeps.
The beep sound means that the positions are recorded in the computer's
memory.