1998 FORD TAURUS recommended oil

²If the oil level is
below the ADD or
MIN mark, add
enough oil to raise
the level within the
ADD-FULL or within
the MIN-MAX range.
²Oil levels above the F in FULL or above the MAX
mark, may cause engine damage. Some oil must
be removed from the engine by a service
technician.
7. Put the indicator back in and ensure it is fully
seated.
Adding engine oil
1. Check the engine oil. For instructions, refer to
Checking the engine oilin this chapter.
2. If the engine oil level is not within the normal
range, add only certified engine oil of the
recommended viscosity. Remove the engine oil filler
cap and use a funnel to pour the engine oil into the
opening.
3. Recheck the engine oil level. Make sure the oil
level is not above the F in FULL mark on the
dipstick.
Maintenance and care
134

Engine oil and filter recommendations
Look for this
certification mark.
Ford oil specification is WSS-M2C153-G.
Use SAE 5W-30 motor oil certified for gasoline
engines by the American Petroleum Institute.
Do not use supplemental engine oil additives, oil
treatments or engine treatments. They are
unnecessary and could, under certain conditions,
lead to engine damage which is not covered by your
warranty.
Change your engine oil and filter according to the
appropriate schedule listed in the ªService Guideº.
Ford production and aftermarket (Motorcraft) oil
filters are designed for added engine protection and
long life. If a replacement oil filter is used that does
not meet Ford material and design specifications,
startup engine noises or knock may be experienced.
It is recommended you use the appropriate
Motorcraft oil filter (or another brand meeting Ford
specifications) for your engine application.
Maintenance and care
135

After washing, apply the brakes several times to dry
them.
Waxing your vehicle
Wax when water stops beading on the surface. This
could be every three or four months, depending on
operating conditions.
Use only carnauba or synthetic-based waxes. Use
cleaning fluid or alcohol with a clean cloth to remove
any bugs and tar before waxing vehicle. Use tar
remover to remove any tar spots.
Avoid getting wax on the windshield. If you have
wax applied at a commercial car wash, it is
recommended that you clean the wiper blades and
windshield as described inCleaning the wiper
blades and windshield.
Repairing paint chips
Minor scratches or paint damage from road debris
may be repaired with touch-up paint, repair foil or
aerosol paint spray from the Ford accessory line.
Observe the application instructions on the
products.
Remove particles such as bird droppings, tree sap,
insect remains, tar spots, road salt and industrial
fallout immediately.
Cleaning the wheels
Wash with the same detergent as the body of your
vehicle. Do not use acid-based or alcohol-based
wheel cleaners, steel wool, fuel or strong detergents.
Never use abrasives that will damage the finish of
special wheel surfaces. Use a tar remover to remove
grease and tar.
Cleaning the engine
Engines are more efficient when they are clean
because grease and dirt buildup keep the engine
warmer than normal. When washing:
Maintenance and care
170

Recommended
fuel-3.0L V6 enginesUnleaded fuel only - 87
octane
Recommended
fuel-3.4L SHO V8
engineUnleaded fuel only - 91
octane
Fuel tank capacity 60.6L (16 gallons)
Engine oil capacity
(including filter
change)-3.0L V6
Vulcan engine4.25L (4.5 quarts). Use
Motorcraft 5W30 Super
Premium Motor Oil, Ford
specification
WSS-M2C153-G.
Engine oil capacity
(including filter
change)-3.0L V6
Duratec engine5.2L (5.5 quarts). Use
Motorcraft 5W30 Super
Premium Motor Oil, Ford
specification
WSS-M2C153-G.
Engine oil capacity
(including filter
change)-3.4L V8 SHO
engine6.1L (6.5 quarts). Use
Motorcraft 5W30 Super
Premium Motor Oil, Ford
specification
WSS-M2C153-G.
Tire size and pressure Refer to Safety
Certification Label on
driver's door panel. Inflate
temporary spare to 60 psi.
Hood release Pull handle under the left
side of the instrument
panel.
Coolant capacity (3.0L
V6 Vulcan engine)
111.0L (11.6 quarts)
Coolant capacity (3.0L
V6 Duratec and 3.4L
V8 SHO engine)
1
10.0L (10.6 quarts)
Recommended
fuel-3.0L V6 enginesUnleaded fuel only - 87
octane
Recommended
fuel-3.0L V6 enginesUnleaded fuel only - 87
octane
Power steering fluid
capacity-3.0L V6
Vulcan engineKeep in FULL range
ondipstick.
Filling station information
191