1998 CHEVROLET S10 lock

When you lift the hood, you’ll see these items an the “VORTEC” 4300 engine:
A. Battery E. Transmission Dipstick H. Air Cleaner
B. .Coolant Recovery Tank E. Power Steering Reservoir I. Fuse Block
C. Engine Uil Dipstick G. Brake Mas-ter Cylinder J. Windshield Washer Fluid
D. Engine Oil Fill
6-10
ProCarManuals.com

With the parking.brake applied, place. the shift lever
With your foot on the brake pedal, mow the shift
lever through each
gear range, p.ausing..fox about
three seconds in each range. Then, position the shift
lever in PARK (P).
* Let. the engine run at idle for three minutes or- more.
Then, without shutting off the engine, follow
these steps: .in
PARK (P).
1. Fiip the handle up
.the dipstick and wipe it
with a clean
rag
or paper towel.
and then pull OW.
2. Push it back inall the way, wait three seconds and
then pull it back out again,
3. Check b-0th sides of the dipstick, tind read the lower
level. The fluid level must be in the %OLD area for a.
cold check or in the HUT area or cross-hatched area
€or 'a hot check.
4. If fhe fluid level is in the acceptable l'aJlge, push the
I dipstick back in all the way; then flip the handle
down to lock the dipstick in place,
6-19
ProCarManuals.com

1. Remove the headlamp assembly as-shown under
“Two-Pie-ce Composite Headlamp System” ,earlier in
this section,
2. Lacate the locking tabs
-on the assembly.
Squeeze the
tabs
together and push.that
end
of the-assembly out
while
holding the tabs.
-The assembly will
.swing .out.
3. Unplug the electrical conne-czw. 6.
7.
6-38
4.
5.
Turn the harness bulb socket to the left to remove it.
Push the new b.ulb into the socket until it. snaps
into place.
Put the new bulb
into the headlamp. lens- assembly
and turn it to the right until it is. tight.
To replace the .assembly, snap the outboard end of
the lamp assembly back into the vehicle. Then swing
the assembly in ,and snap it into place.
ProCarManuals.com

'Fuses and Circuit Br i
Wyou ever have a pmblem on the road :and don'? have-a
spare fuse, you-earihorrow one that has the same
amperage.
Just pick some f&.ature-of your vehicle that
you. can get alofig withwt -- like the rxdio or 6ig&ette-
lighter --- ,and..use its fuse, if it is; the conect amperage.
~eplace it as s0.m as you can.
Instrument Panel -Fuse Block
-The fuse bloik i.S at
driver's end of the
instrument panel,
the
Remove thmovejr by turning, the .fastener to the. left.
Extra.
fuses. and the fuse extractor are provided~in the
cover. To reinstdl the fuse panel euver, push in and turn
:the fastener to the right.:
6-63
ProCarManuals.com

FuseKircuit Usage
Breaker
13
14
15
16
17
18
19
20
21
22
23
24
Auxiliary Po,wer
Power Locks
4WD Switch, Engine Control
(VCM, PCM, Transmission)
Supplemental Inflatable Restraint,
SDM Module
Front Wi.per
Not Used
Radio Battery
Not
Used.
HVAC .I, WAC Control Head.,
HVAC Devices
Anti-Lock Brakes
Rear
W~per
Ra.diO., Ignition
Engine Compartment Fuse Block
The fuse block is under the .hood at the drivei'8 side of
the engine compartment.
Remove the cover
by turning -the fastener to the left.. 'To
reinstall the fbse panel cover, push in and turn the
fastener to the right.
6-65
ProCarManuals.com

On all vehicles, th,e key should come -o.ut only in LOCK.
,Parking Brake- and Automatic Transmission
-K (P) Mechanism Check
r
eould begin to move, YOU or others could be
injured and
property cdd be damagqd. M.ake-
sure. there- is room in front.of your vehicle in case
it begins. to roll. Be ready to apply the regular
brake at once should the vehicle b,egin to-move.
!]
Pwk on a fairly SI p nilf, with tne. veniGie facing
downhill. Keeping
your foot :on the reguiar brake,. set
the parking brake.
0 TO check the parkin-g brake’ssholding ability:
With
the engine running. and transmission in.
NEUTRAL (N), :slowly remove- €001 ,pressure from
the regular brake pedal. Do this uatil the vel .s
held. by the parking brake only.
0 TQ check the PARK (P) rnechanixn’s holding ability:
With
the. engine funning, shift to PARK (P). Then
:release a11 brakes.
Underbody Flushhg ‘Service
At least every spring, use plain water to flush any-
corrosive materialsfrom the underbody.
Take care to
clean thoroughly any-areas where mud ardother debris
can collect.
7-45
ProCarManuals.com

USAGE,
Automatic
Tt.an&n~is,Sia.n
Key Lock
Cylinders
Fmnt .V
USAGE.
Windshield
Washer Solvent:
Transfer Case
Shift Lever
Re-= Driveline
Center Spline-
.and Universal..
.Taints
ProCarManuals.com

Highway Hypnosis ............................... 4-35
Hill and Mount& Rdrads ......................... 4-35
Hitches. Trailer ................................. 4-50
Hood .......................................... 6:-8
Ham ......................................... 2-32
Horsepgwer ................................... 6-68
Hydraixlic Clutch ............................... 6-21
Check ...................................... 7-43
Hydraplaning ................................... 4-31 .
Jack. Tife ..................................... 5-22
JumpSeat ............................,......... l-6
JumpStartin g. ................................... 5-3
Key in:the Ignition .............................. 2-20
Key Lock Cylinders Service ...................... 7-43
Hey Release Button .............................. 2-13
Keyless Entfy System ............................ 2-6
Keys ...... ....................................2.- 2
9-5
.
ProCarManuals.com