Downloaded from www.Manualslib.com manuals search engine If you have trouble programming the universal
transmitter, make sure that you have followed the
directions exactly as described and that the battery in the
hand-held transmitter is not dead. If you still cannot
program it, rotate the hand-held transmitter end over end
and
try again. The universal transmitter may not work
with older garage door openers that do not meet current
Federal Consumer Safety Standards. If you cannot
program the transmitter after repeated attempts, consult
your
GM dealer.
Be sure to keep the original hand-held transmitter
in case you need to erase and reprogram the
universal transmitter.
Operating the Transmitter
Press and hold the appropriate button on the universal
transmitter. The red light comes on while the signal is
being transmitted.
Note that the effective transmission range of the
universal transmitter may differ from the hand-held
transmitter and from one channel to another.
Training a Garage Opener with a “Rolling
If you programmed the universal transmitter, but the
garage door will not open, and if your garage door opener
was manufactured after 1995, your garage door may have
a
security feature that changes the “code” of your garage
door opener every time it is opened or closed.
To determine if your garage door opener has this
“rolling code” feature, press the appropriate button
on
the universal transmitter that was programmed. If the
red light flashes rapidly for one to two seconds, then
turns solid, your garage door opener has this feature.
To program
a garage door opener with the rolling code
feature, do the following:
1.
2.
3.
Program your hand-held transmitter to the universal
transmitter by following the steps provided under “Programming the Transmitte?’ earlier
in this section.
Remove the cover panel from the garage door opener
receiver.
It is located near the garage door opener motor.
Locate the training button on the garage door opener
receiver. The exact location and color will vary
among brands.
2-62
Downloaded from www.Manualslib.com manuals search engine P
-1AUTION:
Snow can trap exhaust gases under your vehicle.
This can cause deadly
CO (carbon monoxide) gas
to get inside. CO could overcome you and kill
you. You can’t see it or smell it,
so you might not
know it is in your vehicle. Clear away
snow from
around the base
of your vehicle, especially any
that is blocking your exhaust pipe. And check
around again from time to time to be sure snow
doesn’t collect there.
Open
a window just a little on the side of the
vehicle that’s away from the wind. This will help
keep CO out.
Run your engine only as long as you must. This saves
fuel. When you run the engine, make
it go a little faster
than just idle. That
is, push the accelerator slightly. This
uses less fuel for the heat that you get and it keeps the
battery charged. You will need a well-charged battery to
restart the vehicle, and possibly for signaling later on
with your headlamps. Let the heater run for
a while.
Then, shut the engine off and close the window almost
all the way to preserve the heat. Start the engine again
and repeat this only when you feel really uncomfortable
from the cold. But
do it as little as possible. Preserve the
fuel as long as you can. To help keep warm, you can get
out of the vehicle and do some fairly vigorous exercises
every half hour or
so until help comes.
Recreational Vehicle Towing
Vehicles with two-wheel drive or the electronic shift
transfer case require special modifications before they
can be towed
in this manner. Please contact your dealer
for the towing information that is appropriate for your
particular vehicle.
4-39
Downloaded from www.Manualslib.com manuals search engine 5. Check that the jumper cables don’t have loose or
missing insulation. If they do, you could get a shock.
The vehicles could be damaged too.
Before
you connect the cables, here are some basic
things you should know. Positive
(+) will go to
positive
(+) and negative (-) will go to a metal
engine
part. Don’t connect positive (+) to
negative
(-) or you’ll get a short that would damage
the battery and maybe other parts too.
6. Connect the red
positive
(+) cable to the
positive
(+) terminal of
the vehicle with the dead battery.
7. Don’t let the other end
touch metal. Connect it
to the positive
(+)
terminal of the
good battery.
8. Now connect the black negative
(-) cable to
the good battery’s negative
(-) terminal.
Don’t let the other end
touch anything until the next step. The other end
of the negative cable
doesn’t
go to the dead
battery. It goes to a
heavy unpainted metal
part on the engine
of the
vehicle with the
dead battery.
5-5
Downloaded from www.Manualslib.com manuals search engine 9. Attach the cable at least
18 inches (45 cm) away
from the dead battery,
but not near engine parts
that move.
The electrical
connection is just as
good there, but the
chance
of sparks getting
back to the battery is
much less.
10. Now start the vehicle with the good battery and run
the engine for awhile.
11. Try to start the vehicle with the dead battery. If it
won’t start after a few tries, make sure all
connections are good. If it still won’t start, it
probably needs service.
Fans or other moving engine parts can injure you
badly. Keep your hands away from moving parts once the engiv is running.
12. Remove the cables in reverse order to prevent
electrical shorting. Take care that they don’t touch
each other or
any other metal.
A. Heavy Metal Engine Part
B. Good Battery
C. Dead Battery
5-6
Downloaded from www.Manualslib.com manuals search engine Customer Assistance Information ................... 8-1
Customer Satisfaction Procedure
.................... 8-2
Damage. Finish
............................... 6-56
Damage. Sheet Metal
............................ 6-55
Daytime Running Lamps
......................... 2-42
Dead Battery
................................... 5-3
Defects. Reporting Safety
........................ 8-10
Defensive Driving
............................... 4-2
Defogging
..................................... 3-8
Defrosting
..................................... 3-8
Dimensions. Vehicle
............................ 6-66
DomeLamps
.................................. 2-43
Door Locks
....................................... 2-4
Storage
..................................... 2-52
Drive
........................................ 2-20
Drive. Automatic Transmission
.................... 2-20
Drive Axle Service
.............................. 7-44
Driver Information System
....................... 2-50
DriverPosition
................................. 1-15
Driving City
........................................ 4-31
Defensive
.................................... 4-2
Drunken
..................................... 4-3
Foreign Countries
.............................. 6-5
Freeway
.................................... 4-32
Guidelines
.................................. 4- 14
Hill and Mountain Roads ....................... 4-34
InaBlizzard
................................. 4-38
Night
...................................... 4-27
Off-Road
................................... 4-14
On Curves
................................... 4-9 Rainy Conditions
............................. 4-28
Snowy and Icy Conditions
...................... 4-36
Through Deep Standing Water
................... 4-30
WetRoads
.................................. 4-28
Winter
...................................... 4-36
With a Trailer
................................ 4-47
Driving On Grades While Towing a Trailer
........... 4-48
DrunkenDriving
................................ 4-3
Easy Entry Seat ................................ 1-7
Electrical Equipment. Adding
................ 3-28. 6-58
Electrical System
............................... 6-58
Endgate
....................................... 2-9
Emergency Release
........................... 2-11
ManualRelease
.............................. 2-10
Remote Release
.............................. 2-11
Engine
........................................ 6-9
Coolant Heater ............................... 2-17
Coolant Level Check
.......................... 7-39
Coolant Temperature Gage
..................... 2-72
Exhaust
..................................... 2-27
FanNoise
................................... 5-20
Identification
................................ 6-58
OilLevelCheck
.............................. 7-39
Overheating ................................. 5-12
Running While Parked
......................... 2-28
Specifications
................................ 6-64
Starting
..................................... 2-16
Engine Compartment Fuse Block
.................. 6-62
Engine Coolant
................................. 6-23
Engineoil
.................................... 6-10
Adding
..................................... 6-11
Additives
................................... 6-13
9-3