Page 13 of 179
Contents
Owner service procedure
Advanced technology
Technical data
Replacement procedures:
Onboard tool kit140
Windshield wiper blades140
Lamps and bulbs141
Master key with
battery lamp145
Changing tires146
Battery149
Fuses151
In case of electrical
malfunction:
Fuel filler door 152
Sliding/tilt sunroof 152
Assistance, giving and receiving:
Jump-starting153
Towing the vehicle154
Towing154Airbags156
Automatic Stability Control
plus Traction (ASC+T)156
Radio reception157
Safety belt tensioner157Engine specifications 160
Dimensions 161
Weights 163
Capacities 166
Electrical system 167
Drive belts 167
Page 72 of 179

71
At a glanceControls Car careRepairsTechnicalDataIndex
Texts with messages and warnings are
used to alert the driver to defective sys-
tems. In addition, there is a warning
lamp in the instrument panel.
The time and date can be displayed
with the digital clock.
1 Status report symbol
2 Display
3 Plus symbol for additional messages
4 CHECK key
The defective-system messages are
divided into 3 different priorities:
Priority 1These defects are indicated immedi-
ately with the flashing warning lamp and
the flashing warning symbol (1). Several
simultaneous defects are displayed
consecutively. After 20 seconds or
when the CHECK key is pressed, the
warning lamp in the instrument cluster
stops flashing.
The messages continue to be displayed
until the defects are eliminated and can
not be deleted by pressing the CHECK
key (4).
Brake lamp electrical system
The brake lamps have failed. Fuse or
electrical circuit is defective. Refer to
page 151 or consult your BMW Retailer.
360us110Check Control*
Brake lamps defective
Brake lamps have failed - bulbs
defective.
Replace bulbs. Refer to page 143.Priority 2These defects appear when the ignition
key is in position 2. The warning sym-
bols remain after the message disap-
pears. If the plus symbol (3) appears:
Additional messages are present and
can be displayed by pressing the
CHECK key.
1 Brake lamp defective
A bulb has failed. Refer to page 143.
Low beams defective,
Backup lamps defective,
License plate lamp
Bulb has failed or fuse or electrical
circuit defective. Refer to pages 141,
143, 145 or visit a BMW Retailer.
Washer fluid low
Too low, top up at next opportunity.
Refer to page 124.
Check Control inactive
Messages and warnings can not be
displayed. See BMW Retailer.
Page 140 of 179
At a glance
Controls and featuresCare and maintenanceAdvanced technology
Technical data
Owner service procedure
At a glanceControlsCar careRepairsTechnicalDataIndex
Index
13 9
Replacement procedures:
Onboard tool kit140
Windshield wiper blades140
Lamp and bulbs141
Master key with battery lamp145
Changing tires146
Battery149
Fuses151
In case of electrical
malfunction:
Fuel filler door 152
Sliding/tilt sunroof 152
Assistance, giving and receiving:
Jump-starting153
Towing the vehicle154
Towing154
Page 142 of 179

14 1
At a glanceControlsCar careRepairsTechnicalDataIndex
The lamps and bulbs on your car play a
vital role in ensuring road safety, a fact
which you should always bear in mind
in caring for them. Carefully observe the
following instructions during bulb
replacement, referring any procedures
with which you are not familiar to your
BMW Retailer.b
Never touch the bulb glass of a
new lamp with your bare hands. Use a
clean cloth, paper napkin, etc. or hold
the bulb by its metallic base.c
A replacement bulb set is available from
your BMW Retailer.
a
To prevent short circuits, always
switch off all electrical systems and
components, or disconnect the negative
terminal of the battery, before working
on them.
To prevent injuries and damage, always
observe any instructions provided by
the bulb manufacturer.c
Low and high beamsLow beam: HB4, 55 watts
High beam: HB3, 65 wattsa
Each bulb is pressurized; always
wear gloves and eye protection! Failure
to observe this precaution could lead to
injury if the bulb is accidentally dam-
aged during replacement.c
dTurn the bulb holder to the left and
remove.
dReplace the bulb.
Parking lamp 5 watt bulb
dPress in the upper tab of the bulb
holder to release and remove.
dPull out the bulb holder.
dPull off the bulb and replace.b
Please observe the following
when cleaning the headlamp covers:
dDo not rub them dry and do not apply
scouring or caustic cleaning agents.
dRemove dirt and contamination (such
as insects) by soaking with BMW Car
Shampoo and then rinsing with
plenty of water.
dAlways use a de-icer spray to remove
accumulated ice and snow Ð Never
use a scraper!c
360us089
Bulb replacement
Page 143 of 179
14 2
Front turn signals 21 watt bulb
dRelease the hooks with a screw-
driver.
dRemove the lamp from the front.
dRelease the bulb holder and remove.
dApply gentle pressure to the bulb
while turning it to the left to remove.
dAfter replacing the bulb, re-insert the
lamp and push it back until it
engages audibly twice.
Side turn signals
*
5 watt bulb
dUse finger pressure against the rear
edge of the lens (arrow) to press it
forward for removal.
dPress gently on the bulb and turn it to
the left to remove.
Foglamps
*
H1 55 watt bulb
dRelease the lamp bracket with a
screwdriver.
dPull the foglamp out toward the front
dTurn the plastic cap on the back of
the lamp to the left and remove.
dPull off the plug.
dRelease the wire spring.
dReplace bulb.
dAfter replacing the bulb, guide in the
lamp again and press on Þrmly until it
audibly engages.b
The retainer must be in the "Open"
position, otherwise the foglamp can not
be guided in.c
360de116
360de148
360de117
Bulb replacement
Page 144 of 179
14 3
At a glanceControlsCar careRepairsTechnicalDataIndex
Taillamps 1 Turn signal yellow
21 watt bulb
2 Backup lamp white
21 watt bulb
3 Brake lamp red
21 watt bulb
4 Taillamp red
5 watt bulbdRemove the lamp cover after releas-
ing the locking device.
dOnce you have found the lamp
holder for the defective bulb, push it
gently to the rear while turning to the
left to remove.
dUse the same procedure to remove
the bulb.
Center brake lamp
*
21 watt bulb
dOpen the luggage compartment lid.
dPush the bulb holder's release knob
gently to the rear while turning to the
left to remove.
dUse the same procedure to remove
the bulb.
BMW Convertible:
LED strip in luggage compartment lid.
Please contact a BMW Retailer in the
case of a malfunction.
12
3
4
360us093
360de119
360de120
Bulb replacement
Page 145 of 179
14 4
License plate lamps 5 watt bulb
dScrew out the screws and remove
the handle.
dPress the bulb holder to the left and
remove.
dExtract the bulb from the contacts.
Front interior lamp Interior lamp with reading lamps:
(Bulbs 10 watt)
dInterior lamp: use a screwdriver to
press out the lens at the left recess.
Extract the bulb from the contacts.
dReading lamp: remove the entire
lamp from the trim, remove the con-
tact strip and gently press against
the lamp while turning it to the left to
remove.b
When reinstalling first, engage the
housing then the lens.c
Rear interior lampsBMW Sedan, Coupe
Without reading lamp
5 watt bulb
dPull the lamp out of the trim.
dFold up the reflector and remove the
bulb.
With reading lamp
*
6 watt bulbdPull the lamp out of the trim.
dFold up the PCB and remove the
bulb.
Illuminated make-up mirror
*
10 watt bulb
dRemove lamp housing (use a screw-
driver if necessary).
dReplace bulb.
360de121Bulb replacement
Page 146 of 179

14 5
At a glanceControlsCar careRepairsTechnicalDataIndex
Luggage compartment lamps BMW Sedan, Coupe
10 watt bulb
Lamp on underside of rear shelf:
dUse a screwdriver to pry out the lamp
at the recess.
dReplace bulb.
BMW Convertible:
5 watt bulbs
There is one lamp each in the bulb cov-
ers of the rear lamps.
dUse a screwdriver to pry out the lamp
at the recess.
dReplace bulb.Glove compartment lamp 5 watt bulb
dUse a screwdriver to pry out the lamp
forward.
dReplace bulb.Footwell lamps
*
5 watt bulb
dUse a screwdriver to pry the lamp out
of the lower instrument panel trim.
dReplace bulb.
Replace batteryIf lamp intensity drops, renew the bat-
tery to safeguard against acid escaping.
To change the battery, use a screw-
driver to remove the cover on the back
of the key.
Insert a new battery of the same type
(CR 2025) - as shown in the picture - so
that it touches the contacts.
Snap the cover back on and press it in
evenly.A
Bring old batteries to a collection
point or your BMW Retailer.c365de132
Bulb replacement Master keys