Page 11 of 166
output stage, and fuse for fuel pump. 
     Disconnect harness connectors from all fuel 
injectors. 
     Afterward, erase Diagnostic Trouble Code 
(DTC) memory. 
Pa
ge 11 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
         
        
        
     
        
        Page 22 of 166
24-17
      
Test conditions  
     
Fuses for engine electronics OK 
     No malfunctions stored in DTC memory   
page 01
-16
 
     
Engine Coolant Temperature (ECT) at least 
80 C (176 F) 
     
All electrical consumers switched off 
(radiator coolant fan must not run during 
test) 
     A/C switched off 
     Exhaust system free of leaks 
     Automatic transmission selector lever in "P" 
or "N" position 
     Throttle valve in Closed Throttle Position 
(CTP); for Accelerator Pedal (AP) cable 
adjustment   Repair Manual, Fuel Supply 
System, Repair Group 20 
Pa
ge 22 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
         
        
        
     
        
        Page 45 of 166
     
Fuse for Oxygen Sensor (O2S) heater(s) OK 
     Engine Coolant Temperature (ECT) at least 
80 C (176 F) 
Pa
ge 45 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
         
        
        
     
        
        Page 66 of 166
     
Test requirements  
     
Fuse for Oxygen Sensor (O2S) heater OK 
     Engine Coolant Temperature (ECT) at least 
80 C (176 F) 
Pa
ge 66 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
         
        
        
     
        
        Page 89 of 166
24-68
      
Mass Air Flow (MAF) sensor, checking
 
     
Required special tools and test equipment  
     
VAG1551 or VAG1552 Scan Tool (ST) with 
VAG1551/3 adapter cable 
     VAG1598/22 test box 
     Multimeter US1119 (Fluke 83 or equivalent) 
     VW1594 connector test kit 
     Wiring diagram 
     
Test requirements  
     All electrical consumers switched off (coolant 
fan must not run during test). 
     A/C must be switched off 
     Fuse for MAF sensor OK 
Pa
ge 89 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
         
        
        
     
        
        Page 118 of 166
24-92
 Evaluation of display group 4  Display group: 4  
  
  
Display field: 2  
Possible malfunction 
cause  
Corrective action  
If "Control module does not answer" is 
displayed  
Fuse for ECM faulty- Replace fuse
  Open circuit in wiring- Check voltage supply at terminal 15   page 
24
-94
 
Displayed value changes between 10.0 - 
14.5 V  
Intermittent connection- Check voltage supply at terminal 15   page 
24
-94
 
- Check voltage supply at terminal 30   page 24
-93
 
0.0 - 10.0 V  
Battery discharged/faulty Voltage regulator faulty- Check battery
- Check generator
- Check voltage regulator
14.5 - 16.5 V  Generator faultyVoltage regulator faulty- Check generator
- Check voltage regulator
Pa
ge 118 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
         
        
        
     
        
        Page 121 of 166
24-95
      
Fuel pump relay and connections, 
checking
 
    
The fuel pump relay is located at relay position 6 on the relay panel on the 
left side under the instrument panel.  
Checking function of fuel pump relay -J17-  
-  Remove storage shelf in left-front footwell.
    
-  Remove fuses 28, 29 and 34 from fuse panel.
-  Connect VAG1527B LED voltage tester between Ground and one of 
the two terminals for fuse 28. 
-  Briefly crank starter.
 
LED test light must light up.
 Fuel pump relay must be actuated (can be felt and heard)
Pa
ge 121 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1 
         
        
        
     
        
        Page 122 of 166
24-96
       If the fuel pump does not respond:  
     
-  Check fuel pump relay actuation   page 24
-
99
 . 
      If the LED test light does not light up:  
     
-  Repeat test at other terminal of fuse 28.
    
If the LED light still does not light up:  
-  Check wiring for open or short circuits between fuse 28 and terminal 30 
at relay position 6, using the applicable wiring diagram. Repair wiring 
as necessary. 
  
Specified value: max. 1.5 
    
Note:  
This step lets the fuel pump run without the engine running. The closed 
throttle position switch must be closed during the test, or the selected fuel 
injector will discharge fuel when it is actuated 5 times.  -  Connect VAG1527B LED voltage tester between Ground and one of 
the two terminals for fuse 29. 
Pa
ge 122 of 166 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.1